ALBERT

Notes: Analysis of the precision of the illite ‘crystallinity’technique shows that machine errors are 〈5%, while intra- and inter-sample errors are variable but are up to 12% and 14%, respectively (1σ). Consideration of this error analysis shows that the isocryst approach, which involves close contouring (e.g. 0.03 Δ2°) of illite ‘crystallinity’data, has a very low degree of confidence (〈0.5) and thus is not regarded as statistically valid. If contouring is to be undertaken with a high degree of confidence (〉0.8) it is necessary that contours should be at intervals of 0.1 ΔΘ2°, which is equivalent to subdivision of the anchizone into upper and lower units. Where previous interpretations have relied upon an isocryst method of contouring at less than 0.1 ΔΘ2° the conclusions must be regarded as unsubstantiated.Centrifuge separation of clay fractions (based on a Stokes’law application) gives separations in which a significant, but variable, percentage of grains have long axes greater than the size calculated. For the typical 〈2-μm fraction utilized, some 20% of grains lie in the 2–4-μm range, although the proportion is not believed to have a significant effect upon ‘crystallinity’values. The formula is applicable for grain-sizes down to 0.5 μm. Illite ‘crystallinity’values on samples prepared by an ultrasonic disaggregation method show a small increase on those prepared by ball mill crushing. The differences are minimal at the epi/anchizone level but increase to some 10% at the anchizone/diagenetic level. The effect on grade determinations is again thought to be minimal and indicates that concern over unsuitability of the ultrasonic disaggregation method is unfounded.

Notes: The amphibolite facies Puolankajärvi Formation (PjF) occupies the western margin of the Early Proterozoic Kainuu Schist Belt (KSB) of northern Finland. The lower and middle parts of the PjF consist of turbiditic psammites and pelites and tempestitic semipelites. This report concentrates on the pelitic lithologies which include quartz–two-mica–plagioclase schists with variable amounts of garnet, staurolite, andalusite and biotite porphyroblasts as well as sillimanite and cordierite segregations.The KSB forms a major north–south-trending synclinorium between two Archaean blocks. It contains both autochthonous and allochthonous units and is cut by faults and shear zones. The PjF lies on the western side of the KSB and is probably allochthonous. The formation has undergone six major deformation phases (D1, D2, D3a, D3b, D4 and D5). During D3a-D5 the maximum principal stress (σ1) changed in a clockwise direction from south-west to north-east. Between D2 and D3 the intermediate principal stress (σ2) changed from horizontal to vertical and the interval between D2 and D3 marks a transition from thrust to strike-slip tectonics.Relict structures in the porphyroblasts indicate the following mineral growth–deformation evolution in the PjF. (1) Throughout the PjF there was a successive crystallization of garnet (syn-D1), poryphyroblastic biotite (inter-D3/4) and staurolite (inter-D3/4) during the pre-D4 stage. (2) A syn-D4-inter-D4/5 crystallization of kyanite, sillimanite (fibrolite), porphyroblastic tourmaline, magnetite, rutile, cordierite and muscovite–biotite–plagioclase pseudomorphs after staurolite was most localized at and near D4 shear zones. (3) A syn- to post-D5 generation of andalusite, ilmenohematite and sheet silicates after staurolite and after cordierite occurred near D5 faults.The evolution outlined here permits the relative dating of the PjF parageneses, which is used in the second part of the study (Tuisku & Laajoki, 1990), and, together with the knowledge of the pressure–temperature conditions during various growth events, makes it possible to compile pressure–temperature–deformation paths for the PjF.

Notes: Within the Çokkul synform, Caledonian metamorphic rocks of the Middle Köli Nappe Complex (MKNC) are in low-angle fault contact with the basement mylonites derived from the Precambrian Tysfjord granite-gneiss. In the synform, the MKNC is composed of four fault-bounded nappes each of which has a distinct tectonic stratigraphy composed of amphibolite-facies metamorphosed pelitic and psammitic schists with minor lensoidal bodies of mafic and ultramafic rocks.Pelitic rocks from the three structurally lowest nappes contain the low-variance AFM mineral assemblages gar + bio + staur and staur + ky + bio with mu + qtz + ilm, whereas staur and ky are absent from the highest nappe, the Kallakvare nappe. AFM mineral assemblages in the three lowest nappes indicate peak metamorphic temperatures of 610–660°C and peak pressures in excess of 600 MPa. Mineral assemblages from the Kallakvare nappe are not as diagnostic of metamorphic grade. However, rocks from that nappe contain coexisting plagioclases from both sides of the peristerite gap, suggesting lower-grade peak P–T conditions than those of the structurally lower nappes. In addition, biotite from the lower nappes is more Ti-rich than biotite from the Kallakvare nappe. However, gar–bio–mu–plag and gar–bio–ky–plag–qtz thermobarometry suggests that all four nappes equilibrated at approximately 525 ± 25°C and 700 ± 100 MPa.Gibbs method thermodynamic modelling of garnet zoning profiles suggests that the lower three nappes followed clockwise P–T paths that involved heating and compression to a metamorphic peak of approximately 575–625°C, 800 MPa followed by cooling and decompression to 525°C, 700 MPa. P–T paths calculated for the Kallakvare nappe show decompression and minor heating to a peak T of 500–525°C. In the lower nappes, staur and ky grew during the heating phase not seen by the highest nappe. The outer parts of the paths from all four nappes are approximately parallel, possibly recording the emplacement of the Kallakvare nappe onto the already stacked lower three nappes at some time following the metamorphic peak. These P–T paths suggest that the sole fault of the Kallakvare nappe is a normal fault. Garnet zonation thus appears to record a previously unrecognized phase of uplift and tectonic thinning of the MKNC. This event appears to be restricted to the MKNC and to have occurred prior to the emplacement of the MKNC onto the Tysfjord granite-gneiss basement of Baltoscandia under greenschist-facies conditions. It may have been responsible for the uplift and cooling of the MKNC from 25–30 km amphibolite-facies conditions prior to its emplacement onto Baltoscandia under 15–20 km greenschist-facies conditions.The deformation zone associated with this normal fault is relatively narrow, generally less than 1 m thick. If this is typical of other detachment faults in the metamorphic infrastructure of the Scandinavian Caledonides, they may be relatively common, but not often recognized due to the detailed study needed to document them.

Notes: Numerical models of the progressive evolution of pelitic schists in the NCMnKFMASH system with the assemblage garnet + biotite + chlorite ± staurolite + plagioclase + muscovite + quartz + H2O are presented with the goal of predicting compositional changes in garnet and plagioclase along different P-T paths. The numerical models support several conclusions that should prove useful for interpreting the P-T paths of natural parageneses: (i) Garnet may grow along P-T vectors ranging from heating with decompression to cooling with compression. P-T paths deduced from garnet zoning that are inconsistent with these growth vectors are self-contradictory. (ii) There is a systematic relation between garnet and plagioclase composition and growth such that for most P-T paths, garnet growth requires plagioclase consumption. Furthermore, mass balance in a closed system requires that as plagioclase is consumed the remaining plagioclase becomes increasingly albitic. Inclusions of plagioclase in the core of garnet should be more anorthitic than those near the rim and zoned matrix plagioclase should have rims that are more albitic than the cores. Complex plagioclase textures may arise from the local variability of growth and precipitation kinetics. (iii) A decrease of Fe/(Fe + Mg) in a garnet zoning profile is a reliable indicator of increasing temperature for the assemblage modelled. However, there is no single reliable ΔP monitor and inferences about ΔP can only be made by considering plagioclase and garnet together. (iv) Consumption of garnet during the production of staurolite removes material from the outer shell of a garnet and may make recovery of peak metamorphic compositions and P-T conditions impossible. Low ‘peak’temperatures typically recorded by staurolite-bearing assemblages may reflect this phenomenon. (v) Diffusional homogenization of garnet affects the computed P-T path and results in a clockwise rotation of the computed P-T vector relative to the true P-T path.

Notes: CO2–CH4 fluid inclusions are present in anatectic layer-parallel leucosomes from graphite-bearing metasedimentary rocks in the Skagit migmatite complex, North Cascades, Washington. Petrological evidence and additional fluid inclusion observations indicate, however, that the Skagit Gneiss was infiltrated by a water-rich fluid during high-temperature metamorphism and migmatization.CO2-rich fluid inclusions have not been observed in Skagit metasedimentary mesosomes or melanosomes, meta-igneous migmatites, or unmigmatized rocks, and are absent from subsolidus leucosomes in metasedimentary migmatites. The observation that CO2-rich inclusions are present only in leucosomes interpreted to be anatectic based on independent mineralogical and chemical criteria suggests that their formation is related to migmatization by partial melting. Although some post-entrapment modification of fluid inclusion composition may have occurred during decompression and deformation, the generation of the CO2-rich fluid is attributed to water-saturated partial melting of graphitic metasedimentary rocks by a reaction such as biotite + plagioclase + quartz + graphite ± Al2SiO5+ water-rich fluid = garnet + melt + CO2–CH4. The presence of CO2-rich fluid inclusions in leucosomes may therefore be an indication that these leucosomes formed by anatexis.Based on the inferences that (1) an influx of fluid triggered partial melting, and (2) some episodes of fluid inclusion trapping are related to migmatization by anatexis, it is concluded that a free fluid was present at some time during high-temperature metamorphism. The infiltrating fluid was a water-rich fluid that may have been derived from nearby crystallizing plutons. Because partial melting took place at pressures of at least 5 kbar, abundant free fluid may have been present in the crust during orogenesis at depths of at least 15 km.

Notes: The solid-solid reaction magnesiocarpholite = sudoite + quartz has been bracketed between 350 and 500°C, 6.3 and 7.8 kbar. Because it is impossible to synthesize end-member sudoite, all experiments were carried out using natural minerals as starting materials. Although mineral compositions were very close to those of the end-members, the effect of the fluorine content in carpholite was significant. Particularly in those experiments where sudoite grows at the expense of carpholite, electron microprobe analysis of the run products shows that a more stable F-rich carpholite crystallizes too, and consumes the fluorine released in solution by the breakdown of the original carpholite.Our experimental results are combined, through a thermodynamic analysis, with a previous data set and with previous experimental data concerning the relative stability of chlorite, talc and magnesiocarpholite with excess of quartz and water as a function of P–T and AlAl(SiMg)-1 substitutions in phyllosilicates. This allows us to constrain the feasible thermodynamic parameters (H°f, sud; S° sud) and (H°f,car; S°car) for the Mg end-members. Using the partition coefficients calculated from natural parageneses, we have computed a petrogenetic grid for the system FeO–MgO–Al2O3–SiO2–H2O. It demonstrates that parageneses involving sudoite and carpholite can be used as indicators of P–T conditions, up to 600° C, 8 kbar for sudoite, and at higher pressure for carpholite.