ISSN:
0029-5981
Keywords:
Engineering
;
Engineering General
Source:
Wiley InterScience Backfile Collection 1832-2000
Topics:
Mathematics
,
Technology
Notes:
This paper attempts to answer two commonly raised questions during the preparation of a finite element mesh, for the linear elastic fracture analysis of cracked structure: how to set up the finite element mesh around the crack tip, and what level of accuracy is to be expected from such a modelling.Two test problems, with known analytical expressions for their stress intensity factors, are analysed by the finite element method using the isoparametric quadratic singular element. The modified parameters were the order of integration, aspect ratio, number of elements surrounding the crack tip, use of transition elements, the singular element length over the total crack length, the symmetry of the mesh around the crack tip. Based on these analyses, a data base is created and various plots produced. The results are interpreted, the accuracy evaluated and recommendations drawn.Contrary to previous reports, it is found that the computed stress intensity factor (SIF) remains within engineering accuracy (10 per cent) throughout a large range of l/a (singular element length over crack length) for problems with a uniform non-singular stress distribution ahead of the crack tip (i.e. double edge notch), and l/a should be less than 0·1 for problems with a non-singular stress gradient (i.e three-point bend). Also, it is found that the best results are achieved by using at least four singular elements around the crack tip, with their internal angles around 45 degrees, and a reduced (2 × 2) numerical integration.
Additional Material:
28 Ill.
Type of Medium:
Electronic Resource
URL:
http://dx.doi.org/10.1002/nme.1620200907
Permalink
