ALBERT

Notes: The intracrystalline diffusion rate of oxygen in diopside was constrained based on natural isotopic variations from a granulite facies marble from Cascade Slide, Adirondacks (New York, USA). The oxygen isotope compositions of the diopsides, measured as a function of grain size, are nearly constant (20.9 ± 0.3‰ vs. SMOW) over the entire measured size range (0.3–3.2 mm diameter). The δ18O values of the cores of calcite grains are 23.0‰. Temperature estimates based on the Δ18O(calcite-diopside) are 800d̀C, in agreement with the highest previous thermometric estimates for these rocks.The lack of isotopic variation in the diopsides as a function of grain size requires that the oxygen intracrystalline diffusion rate in diopside from the Adirondack samples was very slow. The maximum diffusion rates (D800d̀C parallel to the c-axis) were calculated with an infinite reservoir model (IRM) and a finite reservoir model (FRM) that incorporates mineral modal abundances and initial isotopic variations. For an assumed activation energy (Q) = 100 kJ/mol, the IRM diffusion rate estimate of 1.6 times 10-20cm2/s is two orders of magnitude faster than from the FRM; at Q=500kJ/mol, the D800d̀C estimate for both methods is c. 5.6 times 10-20 cm2/s. The present results require that a hydrothermal fluid significantly enhances the diffusion rate of oxygen in diopside if previous data are correct.The δ18O(SMOW) and δ13C(PDB) values of the calcite, measured in situ with a CO2 laser, are 22.9 ± 0.3, 0.1±0.3‰ in the grain cores, 22.1 ±0.3, 0.2 ±0.1‰ at the grain boundaries and 21.7 ±0.4, -0.6±0.1‰ abutting diopside grains. The δ18O and δ13δC values measured conventionally are: crystal cores, 22.96, -0.95‰; abutting diopside grains, 22.38, -0.93‰; bulk, 22.79, -0.95%. Use of the bulk δ18O(calcite) values for thermometry yields unreasonably high temperatures. The lower δ18O values at the calcite grain boundaries are not due to retrograde diffusional exchange with the diopside, they are thought to be a result of a late retrograde fluid infiltration.

Notes: Clay mineral crystallinity and crystallite (domain) size data determined by X-ray diffraction (XRD) are methods extensively used in the characterization of very low-grade metamorphic conditions. However, the lack of sufficient interlaboratory standardization has made comparisons between different research groups unreliable due to significant variations in numerical results obtained, a consequence of the different machine conditions, measurement methods and sample preparations used during analysis. A calibration approach to the standardization of data using rock chip standards is presented, which allows data sets produced by different research groups to be directly and quantitatively compared. A standardized scale, the crystallinity index standard (CIS), is proposed, with illite crystallinity anchizonal boundary limits of 0.25d̀Δ2θ and 0.42d̀Δ2θ, and equivalent illite crystallite sizes of 52 and 23 nm, respectively, determined by the Warren-Averbach method. Calibrating both old and new data will enable more reliable comparisons between similar and contrasting geological environments, and should improve the accuracy and reliability of correlations made between XRD data and other indicators of very low-grade metamorphism, hence increasing the value of such clay mineral studies.

Notes: The Chicago mineral-carbonate oxygen isotope fractionation curves have been combined with mineral-water fractionation data for jadeite, zoisite and rutile and new data for grossular-water to provide a set of self-consistent mineral-pair calibrations. The A coefficients in the equation 1000 In α=A× 106T-2 of the new mineral-pair fractionations areJadeite Zoisite Grossular RutileQuartz 1.69 2.00 3.03 5.02Jadeite 0.31 1.34 3.33Zoisite 1.03 3.02Grossular 1.99The isotopic fractionation properties of natural pyralspite garnet [(Ca, Fe, Mg, Mn)3Al2Si3O12] can be approximated by those of the grossular end-member. Appropriate substitutions also yield coefficients for the solid-solution minerals: sodic pyroxene and epidote, e.g. A quartz-sodic pyroxene= 2.75 - 1.06Xjd, A quartz-epidote= 2.00 + 0.75Xpswhere XJd and XPs are the mole fractions of the jadeite and pistacite components, respectively.The new data set is particularly suitable for the geothermometry of metamorphic rocks. δ18O data from minerals of the high-pressure metamorphic rocks of the Sesia Zone of Italy and Cyclades Complex of Greece yield well-constrained mean temperatures of 572 and 478d̀ C, respectively. Type III blueschist metabasalts of the Franciscan Formation of California give mean quartz-garnet temperatures of 354d̀ C.

Notes: Quantitative modelling of oxygen exchange by diffusion during slow cooling has been compared to the observed oxygen isotope distributions from high-grade metamorphic and granitic rocks of the High Himalayan Crystallines, Langtang Valley, central Nepal, in order to investigate the effect of retrograde diffusional exchange on the preservation of high-temperature, oxygen isotope systematics.Modelled fractionations, using water-present diffusion data reported in the literature, predict quartz-mica fractionations to be much larger than those at peak metamorphic and igneous conditions due to low closure temperatures for micas. Quartz-feldspar fractionations may be less than those at peak conditions, and in some samples may even be slightly negative.The observed oxygen isotope fractionations in the metamorphic rocks are small and largely appear to record equilibrations close to peak conditions determined by other methods. Hence these rocks clearly do not conform to predictions of fluid-present diffusional retrograde exchange. It is suggested that their retrograde history was therefore within an anhydrous closed system in which diffusion was slow and hence mineral closure temperatures were high. The granitic rocks record rather larger quartz-biotite fractionations, approaching those predicted by the diffusion modelling. However, quartz-feldspar fractionations are large and hence, although significant retrograde exchange has clearly occurred, simple diffusion alone is not sufficient to explain the observed data and open-system exchange may be required. The presence of fluids during the retrograde history of this part of the section is supported by petrographic evidence.The different retrograde oxygen exchange histories recorded between the regional metamorphic and magmatic regimes of the Langtang section would appear to support the importance of water on the kinetics of such exchange, and suggests that in its absence, diffusional exchange may become insignificant, allowing oxygen isotope thermometry to record meaningful high-temperature data.

Notes: The assemblages chlorite-pumpellyite-lawsonite-albite-quartz, chlorite-lawsonite-quartz-epidote and chlorite-epidote-albite-quartz occur in metabasaltic blocks and veins in a metamorphosed tectonic mélange in the structurally highest unit of the autochthonous and parautochthonous section underlying the Semail ophiolite in Saih Hatat, north-east Oman. The pre-Permian basement of this section contains mafic units characterized by the assemblage crossite-epidote-chlorite-quartz-albite /el actinolite. These assemblages indicate a down-section increase in metamorphic grade from ‘lawsonite-albite facies' conditions in the mélange to ‘epidote-blueschist’ facies conditions in the basement.Application of empirically and experimentally based thermobarometers as well as petrogenetic grids calculated for a model basaltic system indicates that the P-T conditions of metamorphism ranged from 3 to 6 kbar and 250 to 300d̀ C for the mélange and P 〉 6.8 kbar, T 〉 310d̀ C for the basement units. Textural relations interpreted in the context of petrogenetic grids indicate that these units followed clockwise P-T paths of evolution. The estimated P-T conditions and down-section increase in metamorphic grade in central, western and northern Saih Hatat are consistent with the hypothesis relating metamorphism to the Late Cretaceous tectonic loading of the continental margin by an ophiolite slab 〈 18 km in thickness. These results contrast with field and petrological observations documented for blueschists and eclogites exposed along the eastern coast of Saih Hatat which may have formed at an earlier stage in response to an Early Cretaceous collisional event.

Notes: Books reviewed in this article: Perspectives on Biodiversity: Case Studies of Genetic Resource Conservation and Development. Christopher S. Potter, foci 1. Cohen, and Dianne Janczewski, editors

Notes: To evaluate reclamation success on the Wooley Valley phosphate mine in southeastern Idaho, we compared vegetation structure and soil physical, chemical, and elemental properties of several different reclamation treatments with those of a nearby reference area (a native Artemisia tridentata vaseyana/Festuca idahoensis association) after 14 years. Vegetation data had been collected four years after reclamation, and we were able to compare differences in biomass and species composition between dates on the reclaimed area. Four years after reclamation there were no differences in total biomass between topsoil or spoil or between seed only, seed + mulch, or control treatments on the different soil types. Most treatments were dominated by seeded perennial grasses. Fourteen years after reclamation there were no differences in biomass or cover between spoil and topsoil plots, but on spoil plots the seeded and mulched treatment had higher total biomass and vegetation cover than on control or seed-only treatments. The seeded perennial legume Medicago sativa was codominant with the seeded forage grasses on all of the treatments. High initial fertilization rates probably facilitated the early establishment and dominance of the forage grasses; once nutrient levels, especially nitrogen, began to decline, the legume increased in abundance. Similarity between the reclaimed area and the reference or native area was low. Reclaimed treatments had higher biomass but lower species richness. The topsoil and spoil plots had similar soil texture, bulk density, pH, cation exchange capacity, electrical conductivity, and phosphorus. Differences in organic carbon, total nitrogen, carbon: nitrogen ratios, and available moisture were related more to treatments than to soil type. High biomass and, thus, litter input on the seed + mulch treatment on spoil plots resulted in both higher OC and TN than any on other soil/treatment combination. The reclaimed area had lower OC, TN, and available moisture than did the reference area on all but seed + mulch spoil plots. Bulk density was higher on reclaimed plots. The long-term differences observed between the reclaimed and reference areas parallel those obtained for other western reclamation sites. Although successional trajectories depend on the attribute measured, similarity to native reference areas depends on the initial reclamation methods. We discuss reclamation methods that would increase the structural and functional similarity of reclaimed and reference areas on the Wooley Valley phosphate mine.

Notes: In land restoration it is imperative to study the potential role of disturbances, biotic or abiotic, that may provide sites for colonization by specific plants. Disturbances can alter community composition by removing species or allowing others to become established. In communities where animal-generated disturbances open sites for seedling establishment, animals may have important indirect effects on several aspects of plant community structure. Animal disturbances in Quercus havardii communities of western Texas appear to open sites for colonization by herbaceous species. These animal disturbances vary in spatial distribution, density, and abiotic and biotic characteristics. The abundance of herbaceous plant seedlings is positively related to bare ground and the number of distinct disturbances. Thus, the density and the spatial distribution of these disturbances may be expected to have an important influence on the abundance and dispersion of plant species. Therefore, successful restoration efforts of sand shinnery oak communities and other similar habitats must consider the effects of animal disturbances and the role of plant-animal and plant-soil microbe interactions on plant community composition and the maintenance of plant species diversity.