ALBERT

Notizen: Microstructures in slate belt rocks at the Elura Mine, near Cobar, south-eastern Australia, indicate that volume loss by syntectonic dissolution is coupled with mass accretion by reprecipitation of the dissolved material in dilational sites. The mass accretion is sustained primarily by repetitive tensile microfracturing at high pore-fluid pressures. Oriented growth in the inter- and intragranular microcracks is locally host-controlled, creating lattice- and shape-preferred orientations. The grain-scale crack-seal features throughout the rock reflect rhythmic fluid pressure fluctuations; a balance is achieved between the fracture-induced permeability (and consequent flushing rates), and the rate of fluid build-up in a relatively sealed environment.Instability in the balancing factors can lead to localization and intensification of tensile failure (and hence, tension vein formation) in the grain aggregate. Growth of veins by crack-seal also reflects a steady state, but with more localized fluctuations of fluid flow on the aggregate scale. Still larger imbalances between flushing and fluid accumulation (i.e. pressure variations) induce breccia veining. The larger pressure gradients over greater distances, associated with dilation localization (from pervasive microfracturing to spaced breccia domains), allow fluid channelling with an increased potential for chemical fluid/rock disequilibrium. Therefore, large breccia vein systems tend to be sites of extensive fluid/rock interaction and replacement, as spectacularly illustrated by the syntectonic sulphide orebodies at Elura. The huge amounts of silicate, carbonate and sulphide accumulated during folding at Elura illustrate the large scale of source and sink couples possible in solute mass transfer.

Notizen: The Internal Zone of the Betic Cordilleras consists of several superimposed major thrust sheets with different P-T-t evolutions. On the basis of an integrated field, microscopic and laboratory study, the tectono-metamorphic history of the Mulhacen Complex and Almanzora Unit has been reconstructed in detail. The Mulhacen Complex has been affected by at least five phases of penetrative deformation, which have been labelled Dx-1, Dx, Dx+1, Dx+2 and Dx+3. Dx-1, and Dx are related to continent-continent collision, which is indicated by high pressure-low temperature (HP/LT) and subsequent intermediate P/T metamorphic conditions. Dx+1 is related to crustal thinning and heterogeneous extension. During this event the Almanzora Unit was juxtaposed against the Mulhacen Complex. This phase was succeeded by the establishment of low pressure-high temperature (LP/HT) conditions and at least two phases of folding and overthrusting. The Almanzora Unit shows a comparable tectono-metamorphic evolution post Dx+1. However, the P/T conditions prior to Dx+1 indicate a higher crustal position with respect to the Mulhacen Complex during the collisional event.

Notizen: Following the Middle Devonian Acadian deformation an extensive belt of high grade metamorphism was formed in New England. In south-western Maine, at the northern end of this belt, there occurs a transition along the strike from regional low-pressure/high-temperature metamorphism to contact metamorphism in low-grade rocks. Petrological studies indicate that this transition occurs along a surface plunging to the north-east at about 3.5°, with respect to the Middle-to-Late Devonian erosion surface. In addition, detailed petrological mapping has defined a history of temporally separate, localized metamorphic events associated with plutonism and occurring at increasingly deeper levels to the south-west. Geochronological studies constrain ambient temperatures in the transition zone at the time of metamorphism to be less than 300° C in the north-east and between 350° C and 500° C in the south-west. They also establish a pattern of diachronous cooling due to differential uplift and erosion, with cooling occurring later and most rapidly to the south-west. Geophysical evidence suggests that along with this spatial variation in metamorphic style the shapes of the plutons in Maine undergo a transition from laterally extensive sheet-like bodies in the high grade terrane to more equant-shaped bodies in the low-grade terrane. Using the results of these petrological, geochronological and geophysical studies, as well as those of stratigraphical and structural studies we construct a thermal model for the transition zone. The model suggests that the Acadian metamorphism in south-western Maine is a result of deep-level contact metamorphism near laterally extensive granitic sills dipping to the north-east with respect to the present erosion surface. The plutons themselves are interpreted to be a result of lower crustal melting in response to crustal thickening in the presence of normal or slightly augmented mantle heat flux.

Notizen: Abstract Microprobe analyses of feldspars in granite mylonites containing flame perthite give compositions that invariably plot as three distinct clusters on a ternary feldspar diagram: orthoclase (Or92–97), albite and oligoclase-andesine. The albite occurs as grains in the matrix, as flame-shaped lamellae in orthoclase, and in patches within plagioclase grains.We present a metamorphic model for albite flame growth in the K-feldspar in these rocks that is related to reactions in plagioclase, rather than alkali feldspar exsolution. Flame growth is attributed to replacement and results from a combination of two retrograde reactions and one exchange reaction under greenschist facies conditions. Reaction 1 is a continuous or discontinuous (across the peristerite solvus) reaction in plagioclase, in which the An component forms epidote or zoisite. Most of the albite component liberated by Reaction 1 stays to form albite in the host plagioclase, but some Na migrates to form the flames within the K-feldspar. Reaction 2 is the exchange of K for Na in K-feldspar. Reaction 3 is the retrograde formation of muscovite (as ‘sericite’) and has all of the chemical components of a hydration reaction of K-feldspar. The Si and Al made available in the plagioclase from Reaction 1 are combined with the K liberated from the K-feldspar, to produce muscovite in Reaction 3. The muscovite forms in the plagioclase, rather than the K-feldspar, as a result of the greater mobility of K relative to Al. The composition of the albite flames is controlled by both the peristerite and the alkali feldspar miscibility gaps and depends on the position of these solvi at the pressure and temperature that existed during the reaction. Using an initial plagioclase composition of An20, the total reaction can be summarized as:20 oligoclase + 1 K-feldspar + 2 H2O = 2 zoisite + muscovite + 2 quartz + 15 albiteplagioclase+ 1 albiteflame.This model does not require that any additional feldspar framework be accreted at replacement sites: Na and K are the only components that must migrate a significant distance (e.g. from one grain to the next), allowing Al to remain within the altering plagioclase grain. The resulting saussuritization is isovolumetric.The temperature and extent of replacement depends on when, and how much, water infiltrates the rock. The fugacity of the water, and therefore the pressure of the fluid, may have been significantly lower than lithostatic during flame growth.

Notizen: Abstract In metapelitic schists of the north-eastern Weekeroo Inliers, Olary Block, Willyama Supergroup, South Australia, syn-S1 and syn-S2 assemblages involving staurolite, garnet, biotite and another mineral, most probably cordierite, were overgrown by large syn-S3 andalusite porphyroblasts, owing to isobaric heating from metamorphic conditions that existed during the development of S2. Conditions during the development of S3 probably just reached the andalusite—sillimanite transition. During the development of S4, at somewhat lower temperatures than those that accompanied the development of S3, the following reaction occurred:staurolite + chlorite + muscovite ± biotite + andalusite + quartz + H2O.The amount of retrogression is controlled primarily by the amount of H2O added by infiltration. As the syn-S3 matrix assemblage was stable during the development of S4, but the andalusite porphyroblasts were no longer stable with the matrix when H2O was added, the retrogression is focused in and around the porphyroblasts. With enough H2O available, and if quartz was consumed before biotite in a porphyroblast, then the following reaction occurred:staurolite + chlorite + muscovite + corundum ± biotite + andalusite + H2O.This reaction allowed corundum inclusions in the andalusite to grow, regardless of the presence of quartz in the matrix assemblage.

Notizen: Abstract Effects of post-entrapment fluid-inclusion modification are examined with reference to retrogression-related quartz veins from the Caledonian, Øse Thrust, northern Norway. The inclusions occur in secondary trails, and contain high-density hypersaline aqueous fluids. On morphological characteristics, they are subdivided into, Type A: elongate, ellipsoidal and/or irregular inclusions, and Type B: more equant, regular, and/or negative crystal form. With reference to previous research on post-entrapment modification of inclusions in quartz it is proposed that Type A inclusions experienced little or no post-entrapment modification, whereas Type B inclusions show features characteristic of post-entrapment permanent inelastic stretching and/or leakage. This produces increased homogenization temperatures (Th), associated with increased inclusion volume and lowering of density, whilst maintaining constant salinity. The similarity of data for degree of fill and salinity between Type A and Type B inclusions indicates that Type B inclusions have primarily modified by stretch rather than leakage. However, the spread towards slightly larger volume of vapour in Type B inclusions suggests that some leakage has also occurred. Because stretched and/or partially leaked inclusions have increased Th, isochore projections significantly underestimate trapping pressure (Pt) relative to unmodified inclusions. Therefore, recognition of post-entrapment inclusion modification due to overpressure is crucial to avoid misinterpretation of data, but has considerable potential for constraining the detail of P-T trajectories of individual rocks. On this basis, rocks from the Øse Thrust zone, north Norway, are shown to have experienced rapid uplift on a ‘clockwise’P-T-t path during the final stages of Caledonian (Scandian) orogenesis.

Notizen: Abstract The Erzgebirge Crystalline Complex (ECC) is a rare example where both‘crustal’eclogites and mantle-derived garnet-bearing ultramafic rocks (GBUs) occur in the same tectonic unit. Thus, the ECC represents a key complex for studying tectonic processes such as crustal thickening or incorporation of mantle-derived material into the continental crust. This study provides the first evidence that high-pressure metamorphism in the ECC is of Variscan age. Sm-Nd isochrons define ages of 333 ± 6 (Grt-WR), 337± 5 (Grt-WR), 360± 7 (Grt-Cpx-WR) (eclogites) and 353 ± 7 Ma (Grt-WR) (garnet-pyroxenite). 40Ar/39Ar spectra of phengite from two eclogite samples give plateau ages of 348 ± 2 and 355 ± 2 Ma. The overlap of ages from isotopic systems with blocking temperatures that differ by about 300 ° C indicates extremely fast tectonic uplift rates. Minimum cooling rates were about 50° C Myr-1. As a consequence, the closure temperature of the specific isotopic system is of minor importance, and the ages correspond to the time of high-pressure metamorphism. Despite textural equilibrium and metamorphic temperatures in excess of 800° C, clinopyroxene, garnet and whole rock do not define a three-point isochron in three of four samples. The metamorphic clinopyroxenes seem to have inherited their isotopic signature from magmatic precursors. Rapid tectonic burial and uplift within only a few million years might be the reason for the observed Sm-Nd disequilibrium. The εNd values of the eclogites (+4.4 to +6.9) suggest the protoliths were derived from a long-term depleted mantle, probably a MORB source, whereas the isotopically enriched garnet-pyroxenite (εNd–2.9) might represent subcontinental mantle material, emplaced into the crust prior to or during collision. The similarity of ages of the two different rock types suggests a shared metamorphic history.

Notizen: Abstract The crystalline core of the Himalayan orogen in the Langtang area of Nepal, located between the Annapurna-Manaslu region and the Everest region, contains middle to upper amphibolite grade pelitic gneisses and schists. These rocks are intimately associated with the Main Central Thrust (MCT), one of the major compressional structures in the northern Indian plate, which forms a 3.7-km-wide zone containing rocks of both footwall and hangingwall affinity. An inverted metamorphic gradient is noticeable from upper footwall through hangingwall rocks, where metamorphic conditions increase from garnet grade near the MCT zone to sillimanite + K-feldspar grade in the upper hangingwall. Petrographic data distinguish two metamorphic episodes that have affected the area: a high-pressure, moderate-temperature episode (M1) and a moderate-pressure, high-temperature episode (M2). Comparison with appropriate reaction boundaries suggests that conditions for M1 in the hangingwall were approximately 900–1200 MPa and 425–525°C. Thermobarometric results for 24 samples from the footwall, MCT zone and hangingwall reflect P-T conditions during the M2 phase of 400–1200 MPa and 490–660° C. The decrease in estimated palaeopressures from footwall to hangingwall approximate a lithostatic gradient of 27 MPa km-1, with slight fluctuations in the MCT zone reflecting structural discontinuities. In contrast to the palaeopressures, palaeotemperatures are indistinguishable across the entire area sampled. Although field evidence suggests the presence of the inverted palaeothermal gradient well known in the Himalaya, quantitative thermobarometry indicates that temperatures of final equilibration were all within error of each other across 17 km of section. At Langtang, change in pressure is responsible for the presence of the sequence of index minerals through the section. I interpret these data to reflect diachronous attainment of equilibrium temperature conditions in a lithostatic palaeopressure profile after ductile faulting of the sequence.