ISSN:
0003-3146
Keywords:
Chemistry
;
Polymer and Materials Science
Source:
Wiley InterScience Backfile Collection 1832-2000
Topics:
Chemistry and Pharmacology
,
Physics
Description / Table of Contents:
Die pfropfcopolymerisation von N-Methylolacrylamid auf Flachs/Polyester-Mischgewebe mit Hilfe eines Eisen/Cellulosethiocarbonat/H2O2-Redoxsystems wurde unter verschiedenen Bedingungen, wie Wasserstoffperoxid-Konzentration (1-60 mmol/l), Eisen-Ammoniumsulfat-Konzentration (1-50 mmol/l), N-Methylolacrylamid-Konzentration (5-200%, bezogen auf das Probengewicht), Polymerisationszeit (10-90 min), Temperatur (20-50°C) und pH-Wert des Mediums (1,1-11) untersucht. Zur Berechnung der Pfropfausbeute wurde der Stickstoff-und/oder der Methylolgehalt benutzt. Die erhaltenen Ergebnisse zeigen, daß die Pfropfausbeute, die durch Stickstoffanalyse bestimmt wurde, umso h6her ist, je mehr die H2O2-Konzentration steigt; ab 40 mmol/l bleibt die Ausbeute konstant. Auf der anderen Seite hat die Pfropfausbeute, die aus dem Methylolgehalt bestimmt wurde, einen Maximalwert bei 10 mmol/l H2O2. Die Ergebnisse zeigen, daß die Pfropfung sehr begünstigt abliruft, wenn die Reaktion mit 1 mmol/l Eisen-Ammoniumsulfat bei einem pH von 4,4, einer Temperatur von 30°C und 60 min lang durchgefuhrt wird. Die Aktivierungsenergie der Copolymerisationsreaktion betrirgt 9,74 kJ/mol, und die Pfropfausbeute steigt mit steigender N-Methylolacrylamid-Konzentration. Weiterhin wurde ein Vergleich der Polymerisatonswirksamkeit in Bezug auf die Pfropfung von N-Methylolacrylamid auf Flachs/Polyester-Mischgewebe zwischen einem Eisen-/Cellulosethiocarbonat/H2O2- und einem Eisen/H2O2-Redoxsystem durchgefuhrt. Diese beiden Systeme wurden bezuglich der Pfropfausbeute, des Homopolymeranteils, des Gesamtumsatzes, des Pfropfungsgrades und des Polymerisationsgrades des Homopolymeren untersucht.
Notes:
Graft copolymerization of N-methylolacrylamide onto flax/polyester blend fabric using ferrous cellulose thiocarbonate/H2O2 redox system was investigated under different conditions including hydrogen peroxide concentration (1-60 mmol/l), ferrous ammonium sulphate concentration (1-50 mmol/l), N-methylolacrylamide concentration (5-200%, based on weight of sample), polymerization time (10-90 min), temperature (20-50°C), and pH of the medium (1.1-11). The nitrogen content and/or the methylol content were used for calculation of graft yields. Results obtained indicated that graft yields, derived from nitrogen analysis, are higher the greater the H2O2 concentration increases till 40 mmol/l, then level off. On the other hand, graft yields derived from methylol content exhibit maximum value at 10 mmol/l H2O2. The results indicate also that grafting was highly favoured when it was carried out using 1 mmol/l ferrous ammonium sulphate and pH 4.4 at 30°C for 60 min. The apparent activation energy of the copolymerization reaction amounts to 9.74 kJ/mol. Furthermore, the graft yield increases by increasing N-methylolacrylamide concentration within the range studied. The work was further extended to include a comparison between the polymerization efficiencies of the ferrous cellulose thiocarbonate/H2O2 redox system and the ferrous/H2O2 redox system in inducing grafting of N-methylolacrylamide onto flax/polyester blend fabric. For this reason, the two systems were studied with respect to graft yield, homopolymer proportion, total conversion, graft efficiency, and homopolymer efficiency.
Additional Material:
6 Ill.
Type of Medium:
Electronic Resource
URL:
http://dx.doi.org/10.1002/apmc.1989.051690110
Permalink