ALBERT

All Library Books, journals and Electronic Records Telegrafenberg

Your email was sent successfully. Check your inbox.

An error occurred while sending the email. Please try again.

Proceed reservation?

Export
Filter
  • 04. Solid Earth::04.06. Seismology::04.06.11. Seismic risk
  • Elsevier  (2)
  • Copernicus Publications
  • MDPI Publishing
  • Periodicals Archive Online (PAO)
  • 2015-2019
  • 2005-2009  (2)
  • 1965-1969
  • 2008  (2)
Collection
Years
  • 2015-2019
  • 2005-2009  (2)
  • 1965-1969
Year
  • 1
    Publication Date: 2017-04-04
    Description: We designed a new seismic source model for Italy to be used as an input for country-wide probabilistic seismic hazard assessment (PSHA) in the frame of the compilation of a new national reference map. We started off by reviewing existing models available for Italy and for other European countries, then discussed the main open issues in the current practice of seismogenic zoning. The new model, termed ZS9, is largely based on data collected in the past 10 years, including historical earthquakes and instrumental seismicity, active faults and their seismogenic potential, and seismotectonic evidence from recent earthquakes. This information allowed us to propose new interpretations for poorly understood areas where the new data are in conflict with assumptions made in designing the previous and widely used model ZS4. ZS9 is made out of 36 zones where earthquakes with Mw 〉= 5 are expected. It also assumes that earthquakes with Mw up to 5 may occur anywhere outside the seismogenic zones, although the associated probability is rather low. Special care was taken to ensure that each zone sampled a large enough number of earthquakes so that we could compute reliable earthquake production rates. Although it was drawn following criteria that are standard practice in PSHA, ZS9 is also innovative in that every zone is characterised also by its mean seismogenic depth (the depth of the crustal volume that will presumably release future earthquakes) and predominant focal mechanism (their most likely rupture mechanism). These properties were determined using instrumental data, and only in a limited number of cases we resorted to geologic constraints and expert judgment to cope with lack of data or conflicting indications. These attributes allow ZS9 to be used with more accurate regionalized depth-dependent attenuation relations, and are ultimately expected to increase significantly the reliability of seismic hazard estimates.
    Description: Published
    Description: 85-108
    Description: 3.2. Tettonica attiva
    Description: 4.2. TTC - Scenari e mappe di pericolosità sismica
    Description: JCR Journal
    Description: reserved
    Keywords: Seismotectonics ; Seismic source zone model ; Seismic hazard ; Italy ; 04. Solid Earth::04.06. Seismology::04.06.03. Earthquake source and dynamics ; 04. Solid Earth::04.06. Seismology::04.06.11. Seismic risk ; 04. Solid Earth::04.07. Tectonophysics::04.07.04. Plate boundaries, motion, and tectonics
    Repository Name: Istituto Nazionale di Geofisica e Vulcanologia (INGV)
    Type: article
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 2
    Publication Date: 2017-04-04
    Description: Providing quantitative microzonation results that can be taken into account in urban land-use plans is a challenging task that requires collaborative efforts between the seismological and engineering communities. In this study, starting from the results obtained by extensive geophysical and seismological investigations, we propose and apply an approach to the Gubbio basin (Italy) that can be easily implemented for cases of moderate-to-low ground motion and that takes into account not only simple 1D, but also more complicated 3D effects. With this method, the sites inside the basin are classified by their fundamental resonance frequencies, estimated from the horizontal-to-vertical spectral ratio applied to noise recordings (HVNSR). The correspondence between estimates of the fundamental frequency from this method and those derived from earthquake recordings was verified at several calibration sites. The amplification factors used to correct the response spectra are computed by the ratio between the response spectra at sites within the basin and the response spectra at a hard-rock site using data from two seismic transects. Empirical amplification functions are then assigned to the fundamental frequencies after applying an interpolation technique. The suitability of the estimated site-specific correction factors for response spectra was verified by computing synthetic response spectra for stations within the basin, starting from the synthetic recording at a nearby rock station, and comparing them with observed ones.
    Description: In press
    Description: 4.1. Metodologie sismologiche per l'ingegneria sismica
    Description: JCR Journal
    Description: reserved
    Keywords: sedimentary basin ; response spectra ; site effects ; 04. Solid Earth::04.06. Seismology::04.06.04. Ground motion ; 04. Solid Earth::04.06. Seismology::04.06.06. Surveys, measurements, and monitoring ; 04. Solid Earth::04.06. Seismology::04.06.09. Waves and wave analysis ; 04. Solid Earth::04.06. Seismology::04.06.10. Instruments and techniques ; 04. Solid Earth::04.06. Seismology::04.06.11. Seismic risk
    Repository Name: Istituto Nazionale di Geofisica e Vulcanologia (INGV)
    Type: article
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
Close ⊗
This website uses cookies and the analysis tool Matomo. More information can be found here...