ALBERT

Description: This dataset provides friction data from ring-shear tests on feldspar sand FS900S used for the simulation of brittle behaviour in crust- and lithosphere-scale analogue experiments at the Tectonic Modelling Laboratory of the University of Bern (Zwaan et al. in prep; Richetti et al. in prep). The materials have been characterized by means of internal friction parameters as a remote service by the Helmholtz Laboratory for Tectonic Modelling (HelTec) at the GFZ German Research Centre for Geosciences in Potsdam (Germany). According to our analysis both materials show a Mohr-Coulomb behaviour characterized by a linear failure envelope. Peak, dynamic and reactivation friction coefficients of the feldspar sand are μP = 0.65, μD = 0.57, and μR = 0.62, respectively, and the Cohesion of the feldspar sand is in the order of 5-20 Pa. An insignificant rate-weakening of less than 1% per ten-fold rate change is registered for the feldspar sand. Granular healing is also minor.

Description: This dataset includes five stations of an Ocean Bottom Seismometer (OBS) experiment conducted at the southern end of the Fonualei Rift and Spreading Center in the Lau Basin, southwestern Pacific. The OBS recorded continuously for 32-days on 4 components, including a hydrophone and a 3-component 4.5 Hz geophone. The experiment was conducted during RV Sonne cruise SO267, project ARCHIMEDES I. In the article, the authors report an increasing trend of methane emissions for June and July at a permafrost site in Siberia (Lena River Delta). Using the longest set of observational methane flux data in the Arctic, the authors demonstrate that the continuous warming has begun to trigger the projected enhancement of methane release in Arctic permafrost ecosystems. This software is written in MATLAB. Running the codes ([.m files](Code)) and loading the data files ([.mat files](Data)) requires the pre-installation of [MATLAB](/https://de.mathworks.com/products/matlab.html). IMPORTANT: The repository only contains dummy data. The data that is needed to run the code can be requested by Torsten Sachs and Christian Wille (contact authors). Although the scripts and the data files have been tested for newer versions of MATLAB (〉= MATLAB R2017a). The code might also run in older versions of MATLAB, but this has not been tested.

Description: Orbital products describe positions and velocities of satellites, be it the Global Navigation Satellite System (GNSS) satellites or Low Earth Orbiter (LEO) satellites. These orbital products can be divided into the fastest available ones, the Near Realtime Orbits (NRT), which are mostly available within 15 to 60 minutes delay, followed by Rapid Science Orbit (RSO) products with a latency of two days and finally the Precise Science Orbit (PSO) which, with a latency of up to a few weeks, are the most delayed. The absolute positional accuracy increases with the time delay. This dataset compiles the RSO products for various LEO missions and the appropriate GNSS constellation in sp3 format. The individual solutions for each satellite mission are published with individual DOI as part of this compilation. GNSS Constellation: • GNSS 24h (v01) • GNSS 30h (v02) LEO Satellites: • CHAMP • GRACE • GRACE-FO • SAC-C • TanDEM-X/ TerraSAR-X Each solution is given in the Conventional Terrestrial Reference System (CTS). • The GNSS RSOs are 30-hour long arcs starting at 21:00 the day before the actual day and ending at 03:00 the day after. The accuracy of the GPS RSO sizes at the 3-cm level in terms of RMS values of residuals after Helmert transformation onto IGS combined orbit solutions (Version 1 GNSS RSOs are 24-hour long arcs starting at 00:00 and ending at 24:00 the actual day). • The LEO RSOs are generated based on these 30-hour GNSS RSOs in two pieces for the actual day with arc lengths of 14 hours and overlaps of 2 hours. One starting at 22:00 and ending at 12:00, one starting at 10:00 and ending at 24:00. The accuracy of the LEO RSOs is at the level of 1-2 cm in terms of SLR validation. The exact time covered by an arc is defined in the header of the files and indicated as well as in the filename. This dataset compiles RSO products for various LEO missions and the corresponding GNSS constellation in sp3 format in a revised processing version 2. The switch from previous version 1 to 2 was performed on 18-Feb-2019. Major changes from version 1 to 2 are the change from IERS 2003 to IERS 2010 conventions and ITRF 2008 to ITRF-2014, as well as the temporal extension of the GNSS constellation from previous 24 hours (version 1) to 30 hours (version 2) arcs. This temporal expansion eliminates the chaining of two consecutive 24-hour GNSS constellation solutions previously used to process day-overlapping LEO arcs in Version 1. This 24h GNSS constellation (Version 1) will continue to operate and be stored on the ISDC ftp server, as discussed in more detail in Section 8.1. All RSO LEO arcs will no longer be continued in version 1 after the changeover date and will only be available in version 2 since then.

Description: The airborne hyperspectral image was acquired by the AVIRIS-Next Generation (AVIRIS-NG) instrument during the AVIRIS-NG Europe 2021 HyperSense campaign that has been conducted as a joint effort of ESA, NASA/JPL and the University of Zurich. Acquired was an agricultural area near Irlbach, Germany on May 30th, 2021. The data was preprocessed (radiometrically, geometrically and atmospherically corrected) to contain 419 bands in the 402 - 2495 nm spectral range. Metadata was acquired on the same day for the variables Leaf Area Index (LAI), Leaf Chlorophyll content, crop height and phenology. An overview of metadata acquisition and processing can be found in the HYPERedu YouTube videos on ground reference data acquisition in the field and ground reference data acquisition in the lab. More details on LAI and chlorophyll acquisition can be found in the field data guides assembled by the authors of this dataset via enmap.org (Danner et al., 2015; Süß et al., 2015). The dataset is made publically available within the massive open online course (MOOC) "Beyond the Visible - Introduction to Imaging Spectroscopy for Agricultural Applications", available from December 2022.

Description: This dataset was collected during field-based monitoring in the Kali Gandaki River catchment be-tween the years 2013 and 2017. The monitoring aims to understand the hydrological fluxes and feedback with weathering and erosion processes across the mountain range. The Kali Gandaki River sources its water in the North and traverses through the Himalayan Mountain Range, along a north-south transect. The field-based monitoring comprises targeted field campaigns to revisit locations at different years and seasons in order to constrain the annual and intra-annual variability. This is complemented by permanent installations and routine river and rain sampling at two loca-tions, Lete and Purtighat. Lete is situated at the orographic barrier, at ~2500 m asl. and the up-stream catchment integrates the northern part of the Himalayan Range as well as some of the southern edge of the Tibetan Plateau. Purtighat is located further south and integrates the north-ern part as well as south-facing flanks of the Higher and Lower Himalayas. At both locations, auto-mated river monitoring is installed as well as a trained station ward for daily routine sampling. At Lete, rainfall samples are obtained on a daily resolution during the monsoon. This sampling was not feasible at Purtighat for logistic reasons. Instead, rain was sampled daily in Kathmandu. This dataset contains five tables of stable water isotope analysis. One containing grab samples from the Kali Gandaki river in its vicinities and 4 tables with time series sampling from the Kali Gandaki River and from rainfall.

Description: The scope of the Science Plan is to describe the scientific background, applications, and activities of the Environmental Mapping and Analysis Program (EnMAP) imaging spectroscopy mission. Primarily, this document addresses scientists and funding institutions, but it may also be of interest to environmental stakeholders and governmental agencies. It is designed to be a living document that will be updated throughout the entire mission lifetime. Chapter 1 provides a brief overview of the principles and current state of imaging spectroscopy. This is followed by an introduction to the EnMAP mission, including its objectives and impact on international programs as well as major environmental and societal challenges. Chapter 2 describes the EnMAP system together with data products and access, calibration/validation, and synergies with other missions. Chapter 3 gives an overview of the major fields of application such as vegetation and forests, geology and soils, coastal and inland waters, cryosphere, urban areas, atmosphere and hazards. Finally, Chapter 4 outlines the scientific exploitation strategy, which includes the strategy for community building and training, preparatory flight campaigns and software developments. A list of abbreviations is provided in the annex to this document and an extended glossary of terms and abbreviations is available on the EnMAP website.

Description: The dataset is composed of Neo HySpex (VNIR/SWIR) hyperspectral imagery acquired during airplane overflights on June 6th, 2015 covering the Omongwa Pan located in the South-West Kalahari, Namibia. The dataset includes three cloud-free flight lines with 408 spectral bands ranging from VNIR to SWIR wavelength regions (0.4-2.5 µm). The dataset also includes Level 2A EnMAP-like imagery simulated using the end-to-end Simulation tool (EeteS). The overall goal of the campaign was to acquire imagery over the Omongwa Pan and use the spectral reflectance for the analyses of surface sediments, specifically the mineralogical composition of exposed surface evaporites / salts on the airborne and spaceborne scale. The data are highly novel and can be used to test estimation of surface sediment properties in a highly saline and dynamic environment.

Description: The dataset is composed of Neo HySpex (VNIR/SWIR) hyperspectral imagery acquired during the GFZ/DIMAP Geoarchive airborne campaign on June 6th, 2015 covering the Omongwa salt pan located in the South-West Kalahari, Namibia. The dataset includes 9 merged cloud-free flight lines with 408 spectral bands ranging from VNIR to SWIR wavelength regions (0.4-2.5 μm). The dataset also includes Level 2A EnMAP-like imagery simulated using the end-to-end Simulation tool (EeteS). The overall goal of the campaign was to test the potential of advanced optical hyperspectral remote sensing, or imaging spectroscopy, for the analysis of surface processes in the Omongwa salt pan and for the quantification of surface sediments. Specifically, the mineralogical composition of exposed evaporites such as halite, gypsum and calcite were investigated at the airborne and spaceborne scale, associated with comprehensive field campaigns, ich which spectral reflectance and ground-truth chemical data of field samples have been collected. The data are highly novel and can be used as testbeds for the development and validation of retrieval algorithms based on air- and space-borne hyperspectral imagery for estimation of surface sediment properties in a highly saline and dynamic environment.

Description: This dataset provides results from rheological tests of glucose syrup from two suppliers tested within the EPOS Multi-scale Laboratories (MSL) trans-national access (TNA) program 2019 at the Laboratory of Experimental Tectonics (LET), Univ. Roma TRE, Italy. Syrups Glucowheat 45/81 (GW45) and Glucowheat 60/79 (GW60) are produced by Blattmann Schweiz AG, Switzerland (2019 batch). Syrups GlucoSweet 44 (GS44) and GlucoSweet 62 (GS62) are produced by ADEA (Amidi Destrini ed Affini), Italy (2019 batch) . The four tested glucose syrups are labeled according to their DE value (dextrose equivalent value). For tested products from Blattmann Schweiz AG, the second number refers to the weight percentage of dry substance. Glucose syrup GS44 is used in full lithospheric scale analogue experiments at the Tectonic Modelling Lab (TecLab) at the University of Bern, Switzerland as a low-viscosity material simulating the asthenospheric mantle lithosphere to provide isostatic equilibration. The materials have been analyzed using a MCR301 Rheometer (Anton Paar) equipped with parallel plates geometry and rotational regime . To prevent the evaporation of the samples during the measurements, an external water-lock device has been used.

Description: This interactive webpage contains supplementary information for the publication by Jamalreyhani et al., 2020: Seismicity related to the eastern sector of Anatolian escape tectonics: A seismic gap partly filled by the 24 January 2020 Mw 6.8 Elazığ-Sivrice earthquake.