ALBERT

Description: IGMAS+ is a software for 3-D modelling of potential fields and its derivatives under the condition of constraining data and independent information. It comes with tools for forward and inverse modelling. IGMAS+ has a long history starting 1988 and has seen continuous improvement since then with input by many contributors.

Description: This data set includes images and videos depicting the evolution of deformation and topography in 17 analogue experiments of passive margin development, to better understand the ongoing tec-tonics along the western margin of Afar, East Africa. The tectonic background that forms the basis for the experimental design is described in Zwaan et al. 2020a-d, and references therein. The ex-periments, in an enhanced gravity field in a large-capacity centrifuge, examined the influence of brittle layer thickness, strength contrast, syn-rift sedimentation and oblique extension on a brittle-viscous system with a strong and weak viscous domain. All experiments were performed at the Tectonic Modelling Laboratory of the Istituto di Geoscience e Georisorse - Consiglio Nazionale delle Ricerche (CNR-IGG) and of the Earth Sciences Department of the University of Florence (CNR/UF). The brittle layer (sand) thickness ranged between 6 and 20 mm, the underlying viscous layer, split in a competent and weak domain (both viscous mixtures), was always 10 mm thick. Asymmetric extension was achieved by removing a 1.5 mm thick spacer at the side of the model at every time step, allowing the analogue materials to spread when en-hanced gravity was applied during a centrifuge run. Differential stretching of the viscous material creates flexure and faulting in the overlying brittle layer. Total extension amounted to 10.5 mm over 7 intervals for Series 1 models that aimed at un-derstanding generic passive margin development in a generic orthogonal extension setting, where-as up to 16.5 mm of extension was applied for the additional Series 2 models aiming to reproduce the tectonic phases in Afar. In models involving sedimentation, sand was filled in at time steps 2, 4 and 6 (i.e. after 3, 6 and 9 mm of extension). Detailed descriptions of the experiments, monitoring techniques and tectonic interpretation of the model results are presented in Zwaan et al. (2020a).