ALBERT

Description: Major- and trace-element as well as Pb-isotope data are presented for greenschist- to amphibolite-facies greenstones from two locations: (1) metabasalt-breccias from the Galfipagos Rift at 100°W; and (2) metabasalt-breccias and unbrecciated greenstones from the Chile Ridge at 38°S. Greenstone-breccias from both locations display stockwork-like sulfide mineralizations related to the upflow portion of a hydrothermal convection system. Whereas Galfipagos Rift stockwork sulfides belong to the "normal" type containing Cu-Fe-sulfides, Chile Ridge stockwork sulfides are galena-rich Pb-Zn _ Cu-sulfides and represent a previously unknown type of sulfide mineralisation in a MORB environment. Geochemically, the greenstones can be divided into two types: (1) The unbrecciated galena-free greenstones from both Chile Ridge and Galfipagos Rift show at least a 10-20-fold Pb enrichment compared to fresh MORB. With respect to similar Pb enrichment measured in greenstones from two other locations, i.e. DSDP Hole 504B and Galfipagos Rift near 86°W, we suggest that this may be a general feature of all stockwork-mineralised oceanic greenstones. (2) The galena- and quartz-rich metabasalt-breccias from the Chile Ridge are up to 3000-fold enriched in Pb (up to 1000 Ixg/g Pb in the whole-rock analyses) compared to MORB and indicate Pb mineralisation two orders of magnitude higher than that of the "normal" greenstone-type. A mass-balance calculation carried out using crustal column thickness of 3000 m with a 200-m-thick greenstone layer and 0.15 m of galena-beating breccias shows that at the Chile Ridge ~ 42% of the entire Pb is concentrated in the greenstones. This suggests that the rest of the crustal column is depleted in 58% of its primary Pb content. This degree of depletion matches well with previous calculations that a 56% depletion of Pb in oceanic crust subjected to mantle-recycling via subduction would be necessary to yield a HIMU mantle source within 2 Ga. Despite the need for future investigations into the extent and volume of the Pb enrichment in Chile Ridge greenstones, we believe that this process of major Pb redistribution is capable of creating huge volumes of oceanic crust that on average are extremely Pb-depleted and which when recycled would produce the HIMU source. Keywords: Chile Ridge; Galfipagos Ridge; Hydrothermal alteration; Greenstones; Geochemistry; Mineralogy

Description: Two case studies of the application of geoscientific maps for planning in semi-arid regions are presented, one for the Mediterranean province of Valencia and another for the island of Gran Canaria (Canaries). Both regions are very dynamic from the point of view of population growth and urban-touristic-industrial development, and they suffer from a serious degree of environmental degradation. The provincial/ island governments have undertaken programmes of geoscientific mapping and assessment to serve as a basis for the establishment of guidelines for future planning. Two map sets have been made (1:200,000 in Valencia and 1:50,000 in Gran Canaria), based on initial maps of homogeneous integrated units. These represent a series of hierarchical land subdivisions, progressively smaller and more detailed (morphodynamic environments, systems, units, elements), defined on the basis of morphostructure, climate, lithology, surficial deposits, landforms, topography, active processes, soils, vegetation and human influence. Each individual map unit is described by means of a form which includes 114 items, summarising its environmental features. Morphodynamic units have been evaluated in terms of qualities significant for planning, and a series of derivative maps has been developed (geologic hazards, soil capability, present degree of erosion, potential erodibility, quality for conservation). A final map shows the most advisable types of uses and the main limitations for human activities, mainly due to engineering geological factors. This is a synthesis document which can be used directly by planners.

Description: Middle Pleistocene strata of the Kidnappers Group consist of a conformable sequence of alternating fluvio-lacustrine and shallow marine sediments exposed along coastal cliffs near Cape Kidnappers, southern Hawkes Bay, New Zealand. Three major paleomagnetic polarity intervals are recognised and interpreted as Jaramillo Normal Subchron, upper Matuyama Reversed Chron and Brunhes Normal Chron. This and biostratigraphy indicates an age range of 0.97 to 0.54 Ma for the group, compared to 0.85 to 〈 0.33 Ma previously suggested by fission track ages of tuffs. The new age control and facies interpretations suggest that the upper part of the group represents oxygen isotope stages 22 to 15. The duration and magnitude of isotope stages is reflected in the relative thicknesses of lithological units. Glacial periods are recorded as alluvial aggradation in the form of braidplain conglomerates, while estuarine and subaerial sands and muds with temperate climate pollens represent interglacial periods. This contrasts with many coastal and shelf sequences where glacial periods are represented by unconformities. Chemical and paleomagnetic characterisation of silicic tuffs in the Kidnappers Group establishes correlation to other sections and cores in New Zealand, the Tasman Sea and the western Pacific Ocean, thus providing temporal correlation for a range of sedimentary environments.

Description: A standard, universally useful classification scheme for deepwater habitats needs to be established so that descriptions of these habitats can be accurately and efficiently applied among scientific disciplines. In recent years many marine benthic habitats in deep water have been described using geophysical and biological data. These descriptions can vary from one investigator to another, which makes it difficult to compare habitats and associated biological assemblages among geographic regions. Using geophysical data collected with a variety of remote sensor systems and in situ biological and geologic observations, we have constructed a classification scheme that can be used in describing marine benthic habitats in deep water.

Description: The kinetics of methane hydrate decomposition was studied using a semibatch stirred-tank reactor. The decomposition was accomplished by reducing the pressure on a hydrate slurry in water to a value below the three-phase equilibrium pressure at the reactor temperature. The data were obtained at temperatures from 274 to 283 K and pressures from 0.17 to 6.97 MPa. The stirring rates were high enough to eliminate mass-transfer effects. Analysis of the data indicated that the decomposition rate was proportional to the particle surface area and to the difference in the fugacity of methane at the equilibrium pressure and the decomposition pressure. The proportionality constant showed an Arrhenius temperature dependence. An estimate of the hydrate particle diameters in the experiments permitted the development of an intrinsic model for the kinetics of hydrate decomposition.

Description: A structural model encompassing the southern North Sea basin west of the Central Graben has been developed. This model consists of a rift system affecting the post-salt section around the basin margin and a large area of detached compressional buckle folds within the basin. This pattern is initially a response to gravity sliding of the post-salt section on the salt within the basin during the late Triassic to late Jurassic. A close relationship between the location and trend of the peripheral graben system and basement structures in the pre-salt is noted. Pre-Jurassic extension across the peripheral graben systems was balanced by the sum of fault heaves at the pre-salt (Rotliegend) level and shortening across salt-cored buckle folds in the post-salt section. Salt pillows and swells passively infilled the cores of these gravity-induced buckle folds. Cretaceous and Tertiary inversion involved basin tilt and renewed movement on basin-bounding basement faults; notably, reverse movements did not propagate from basement structures up into the peripheral graben systems. The post-salt sedimentary section experienced gravity spreading in response to inversion-related uplift, resulting in syn-inversion extensional faulting in the Sole Pit High, where the Mesozoic section was thickest. This extension, combined with a loss of fault heave in the pre-salt section, was balanced by amplification of salt-cored buckle folds in the centre of the basin. In the context of the model described here, salt pillows represent passive infill of thin-skinned, compressional buckle folds which later amplified during thick-skinned basement shortening. Crestal collapse of such folds occurs via normal faulting, accompanied by reactive diapirism. Such reactive diapirs establish conduits through which salt may leak, leading to pillow deflation and ultimately conduit preservation as a salt wall (flanked by rim synclines in areas where the buckle folds were emergent). The salt structures described here are related to cover folds and faults, which in turn reflect episodes of basin extension, tilting and inversion. Hence individual salt structures can be said to be only remotely connected with regional, intraplate stresses.

Description: Normal faulting and halokinesis have been important controls on the deposition and subsequent deformation of Mesozoic and Tertiary strata in the North Sea. In addition to the previously documented mechanisms of salt withdrawal, dissolution and differential sedimentary loading, it is recognized that gravity-driven thin-skinned extension above inclined salt layers has played an important part in North Sea basin development. Commercial section restoration software has been used to facilitate depth conversion, restoration and decompaction of seismic sections selected from an interpreted regional database in the western central North Sea, allowing validation of the interpretations, and a graphical and highly quantitative description of salt-assisted extension. Results of this work show that Zechstein Group evaporites were deposited in shallow sag basins during the Permian. Triassic sedimentary pods were generated by localized deposition in synclinal basins and grabens above the evaporites. Bedded salt became folded, while mobile salt flowed to fill anticline cores. Since the early Jurassic, regional tectonic tilting related to post-rift subsidence and increasing sedimentary overburden have caused allochthonous Mesozoic and Tertiary strata to extend by gravity spreading above the mobile salt layer, which detaches the allochthon from the underlying autochthonous Late Palaeozoic rocks. Concave-up listric normal faults sole out in the salt layer, propagate into the overlying cover sewuence, and have been active at different geological times causing stratal thickening and folding within the allochthon. Antithetic and synthetic normal faults have developed, producing complex upward branching fault systems. In map view, the listric faults form curvilinear en echelon arrays, the faults linked by relay ramps. Fault blocks are typically 3–7 km wide, 2–3 km thick and 7–10 km long. Salt movement during the Jurassic-Tertiary has been driven by active extension of the cover, causing salt to fill potential voids created by fault block rotation. Thus salt highs occur beneath sites of extension. The listric faults generally dip in the same direction as the sub-salt surface, although there are also some major counter-regional faults. During extension, regional dips have increased up to about 5, which is sufficient for gravity-driven extension above a salt layer. A total extension of about 6% has occurred. The gravity-driven thin-skinned extension documented in the western central North Sea is a phenomenon which can be recognized elsewhere in the North Sea basin, and can be readily compared with similar phenomena already documented in offshore Angola, Brazil, Nova Scotia and the Gulf of Mexico.