Abstract
An investigation of the flow dynamics through the peripheral clearance (the gap formed between the occluder tip and the metal housing in the closed position) of a tilting disc heart valve at the moment of valve closure is presented. A Medtronic Hall valve in the mitral position of anin vitro experimental set up is employed to measure the transient pressure pulses near the entrance (ventricular side) and exit (atrial side) of the peripheral clearance at valve closure. Flow within the peripheral clearance is analyzed employing a two-dimensional quasisteady computational fluid dynamics model with the measured peak pressures specified as the boundary conditions inducing the flow. The valve is visualized from its inflow (atrial) side using a stroboscopic lighting technique to investigate the presence of cavitation bubbles within the clearance. The pressure measurements showed that a relatively large pressure drop exists between the entrance and the exit to the clearance for about 0.5 msec at the moment of valve closure. The numerical simulation resulted in relatively large magnitudes of wall shear stress and pressure reduction within the clearance due to the flow established by the large pressure drop between the entrance and the exit. Cavitation bubbles visualized within the peripheral clearance at higher loading rates for valve closure correlated with the presence of large pressure reduction within the clearance. Analysis of the results of this study indicates that the back flow through the clearance at the instant of valve closure may contribute toward injury to formed elements in blood in spite of the short duration of the flow.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
Baldwin, J.T.; Tarbell, J.M.; Deutsch, S.; Rosenberg, D.B. Mean velocities and Reynolds stresses within regurgitation jets produced by tilting disc valves. ASAIO. 37;M348-M349; 1991.
Chandran, K.B. Heart valve prostheses: in vitro flow dynamics. In: Webster, J.G., ed. Encyclopedia of medical devices and instrumentation. New York: John Wiley & Sons; 1988: pp. 1475–1483.
Chandran, K.B. Cardiovascular Biomechanics. New York: New York University Press; 1992: pp. 84.
Chandran, K.B.; Lee, C.S.; Chen, L.D. Pressure field in the vicinity of mechanical valve occluders at the instant of valve closure: correlation with cavitation initiation. J. Heart Valve Dis. 3(Suppl. I):565–576.
Graf, T.; Reul, H.; Rau, G. Cavitation potential of mechanical heart valve prostheses. Artif. Org. 14:169–174; 1991.
Graf, T.; Reul, H.; Dietz, W.; Wilmes, R.; Rau, G. Cavitation of mechanical heart valves under physiologic conditions. J Heart Valve Dis. 1:131–141; 1992.
Horstkotte, D.; Korfer, R.; Seipel, L.; Bricks, W.; Loogen, F. Late complications in patients with Bjork-Shiley and St. Jude Medical heart valve replacement. Circulation (Suppl. II) 68:175–184; 1983.
Jones, I. P.; Kightley, J.R.; Thompson, C.P.; Wilkes, N.S. FLOW3D, a computer program for the prediction of laminar and turbulent flow, and heat transfer: release 1. AERE-R 11825; 1985.
Klepetko, W. Leaflet fracture in Edwards-Duromedics bileaflet valves. J. Thoracic Cardiovasc. Surg. 97:90–97; 1989.
Kuiper, G. Reflections on cavitation inception. Proc. ASME Cav. Multiphase Flow Forum, 1989; pp. 1–13.
Lamson, T.C.; Rosenberg, G.; Geselowitz, D.B.; Deutsch, S.; Stinebring, D.R.; Frangos, J.A.; Tarbell, J.M. Relative blood damage in the three phases of a prosthetic heart valve flow cycle. ASAIO 39:M626-M633; 1993.
Lawrie, J.W. Glycerol and the glycols. New York: The Chemical Engineering Catalog Co.; 1928.
Lee, C.S.; Chandran, K.B.; Chen, L.D. Cavitation dynamics of mechanical heart valve prostheses. Artif. Organs; 1994. In press.
Lee, C.S.; Clausen, J.D.; Chandran, K.B. Flow dynamics in the disc clearance region of a bileaflet mechanical heart valve prosthesis during the closing phase. Proc. of 3rd USA-China-Japan Conference on Biomechanics, Georgia Institute of Technology, Atlanta, Georgia; 1991: pp. 137–138.
Leuer, L. In vitro evaluation of drive parameters and valve selection for the total artificial heart. Annual meeting of the Canadian Council of Cardiovascular Perfusionists, Ottawa, Ontario, Canada; 1986.
Morishita, Y.; Arikawa, K.; Yamashita, M.; Yuda, T.; Shimokawa, S. Fatal hemolysis due to unidentified causes following mitral valve replacement with bileaflet tilting disc valve prosthesis. Heart Vessels 3:100–103; 1987.
Reif, T.H. A numerical analysis of the back flow between the leaflets of a St. Jude medical cardiac valve prosthesis. J. Biomech. 24:733–741; 1991.
Stinebring, D.R.; Lamson, T.C.; Deutsch, S. Technique for in vitro observation of cavitation in prosthetic heart valves. Proceedings of ASME Cavitation and Multiphase Flow Forum 1991; pp. 119–124.
Tiederman, W.G.; Steinle M.J.; Phillips, W.M. Two component laser velocimeter measurements downstream of heart valve prostheses in pulsatile flow. ASME J. Biomech. Eng. 108:59–64; 1986.
White, F.M. Fluid mechanics, 2nd ed. New York: McGraw-Hill Book Co.; 1986: pp. 210.
Yoganathan, A.P.; Woo, Y.R.; Sung, H.W. Turbulent shear stress measurements in the vicinity of aortic valve prostheses. J. Biomech. 119:433–442; 1986.
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
Lee, C.S., Chandran, K.B. Instantaneous back flow through peripheral clearance of medtronic hall tilting disc valve at the moment of closure. Ann Biomed Eng 22, 371–380 (1994). https://doi.org/10.1007/BF02368243
Received:
Accepted:
Issue Date:
DOI: https://doi.org/10.1007/BF02368243