ALBERT

Notes: In the BAT ground water sampling system, a stainless steel probe with a porous filter element is pushed vertically to the desired sampling depth. An evacuated glass sampling tube is then lowered down the penetration rods where it makes contact with the filter via a hypodermic needle and draws a pore fluid sample.An investigation of the system was carried out at a number of sites contaminated by leaking underground gasoline storage tanks. Ground water samples obtained using the BAT system and adjacent monitoring wells were analyzed for volatile organic compounds (VOCs).Because the BAT system is an in situ penetration device with a small filter length, it is possible to determine variations in contaminant concentration with depth. BAT samples in general exhibited higher recovery of VOCs than did bailer samples from adjacent monitoring wells screened over large intervals.Much higher levels of VOCs were recovered when the probe was used with its 316 stainless steel filter than when using the high-density polyethylene (HDPE) filter. Significant sorption apparently occurred on the latter filter.Because the BAT sample tubes are sealed and remain a closed system, the in situ water pressure is maintained. No significant loss of VOCs was found in sampling tubes containing headspace. Samples from the upper tube in the cascaded setup with headspace recovered levels of VOCs as high, or in a few cases higher, than the lower, no-headspace tubes.

Notes: Reagents that enhance the aqueous solubility of non-aqueous phase organic liquid (NAPL) contaminants are under investigation for use in enhanced subsurface remediation technologies. Cyclodextrin, a glucose-based molecule, is such a reagent. In this paper, laboratory experiments and numerical model simulations are used to evaluate and understand the potential remediation performance of cyclodextrin. Physical properties of cyclodextrin solutions such as density, viscosity, and NAPL-aqueous inter-facial tension are measured. Our analysis indicates that no serious obstacles exist related to fluid properties that would prevent the use of cyclodextrin solutions for subsurface NAPL remediation. Cyclodextrin-enhanced solubilization for a large suite of typical ground water contaminants is measured in the laboratory, and the results are related to the physicochemical properties of the organic compounds. The most-hydrophobic contaminants experience a larger relative solubility enhancement than the less-hydrophobic contaminants but have lower aqueous-phase apparent solubilities. Numerical model simulations of enhanced-solubilization flushing of NAPL-contaminated soil demonstrate that the more-hydrophilic compounds exhibit the greatest mass-removal rates due to their greater apparent solubilities, and thus are initially more effectively removed from soil by enhanced-solubilization-flushing reagents. However, the relatively more hydrophobic contaminants exhibit a greater improvement in contaminant mass-removal (compared with water flushing) than that exhibited for the relatively hydrophilic contaminants.

Notes: Results of three independent experimental methods for determination of sorption coefficients were compared on sieved aquifer material samples from Columbus AFB, Columbus, Mississippi. These aquifer materials contained 〈0.1% organiccarbon, and sorption coefficients for naphthalene ranged from 0.06 to 0.20 I/kg. There was low correlation between organic carbon contents and sorption coefficients. Good agreement was found among sorption coefficients measured by batch, dynamic column, and dynamic box methods. Similarity of the coefficients was attributed to measured fast sorption kinetics and to linearity of isotherms observed for naphthalene sorption on Columbus aquifer material. Results indicate that channeling, wall and end effects, and particle loss were insignificant in the dynamic systems. Since laboratory sorption coefficient measurements were found impractical on whole sand-gravel aquifer samples, an equation is proposed to convert laboratory measured sorption coefficients on the separated sand (〈2 mm) fraction to sorption coefficients on wholesand-gravel aquifer materials.

Notes: Recent studies demonstrating a concentration dependence of elimination of 2,3,7,8-tetrachlorodibenzo-p-dioxin (TCDD) suggest that previous estimates of exposure for occupationally exposed cohorts may have underestimated actual exposure, resulting in a potential overestimate of the carcinogenic potency of TCDD in humans based on the mortality data for these cohorts. Using a database on U.S. chemical manufacturing workers potentially exposed to TCDD compiled by the National Institute for Occupational Safety and Health (NIOSH), we evaluated the impact of using a concentration- and age-dependent elimination model (CADM) (Aylward et al., 2005) on estimates of serum lipid area under the curve (AUC) for the NIOSH cohort. These data were used previously by Steenland et al. (2001) in combination with a first-order elimination model with an 8.7-year half-life to estimate cumulative serum lipid concentration (equivalent to AUC) for these workers for use in cancer dose-response assessment. Serum lipid TCDD measurements taken in 1988 for a subset of the cohort were combined with the NIOSH job exposure matrix and work histories to estimate dose rates per unit of exposure score. We evaluated the effect of choices in regression model (regression on untransformed vs. ln-transformed data and inclusion of a nonzero regression intercept) as well as the impact of choices of elimination models and parameters on estimated AUCs for the cohort. Central estimates for dose rate parameters derived from the serum-sampled subcohort were applied with the elimination models to time-specific exposure scores for the entire cohort to generate AUC estimates for all cohort members. Use of the CADM resulted in improved model fits to the serum sampling data compared to the first-order models. Dose rates varied by a factor of 50 among different combinations of elimination model, parameter sets, and regression models. Use of a CADM results in increases of up to five-fold in AUC estimates for the more highly exposed members of the cohort compared to estimates obtained using the first-order model with 8.7-year half-life. This degree of variation in the AUC estimates for this cohort would affect substantially the cancer potency estimates derived from the mortality data from this cohort. Such variability and uncertainty in the reconstructed serum lipid AUC estimates for this cohort, depending on elimination model, parameter set, and regression model, have not been described previously and are critical components in evaluating the dose-response data from the occupationally exposed populations.

Notes: Of primary concern are irreversible effects, such as cancer induction, that formaldehyde exposure could have on human health. Dose-response data from human exposure situations would provide the most solid foundation for risk assessment, avoiding problematic extrapolations from the health effects seen in nonhuman species. However, epidemiologic studies of human formaldehyde exposure have provided little definitive information regarding dose-response. Reliance must consequently be placed on laboratory animal evidence. An impressive array of data points to significantly nonlinear relationships between rodent tumor incidence and administered dose, and between target tissue dose and administered dose (the latter for both rodents and Rhesus monkeys) following exposure to formaldehyde by inhalation. Disproportionately less formaldehyde binds covalently to the DNA of nasal respiratory epithelium at low than at high airborne concentrations. Use of this internal measure of delivered dose in analyses of rodent bioassay nasal tumor response yields multistage model estimates of low-dose risk, both point and upper bound, that are lower than equivalent estimates based upon airborne formaldehyde concentration. In addition, risk estimates obtained for Rhesus monkeys appear at least 10-fold lower than corresponding estimates for identically exposed Fischer-344 rats.