ALBERT

Description: Author(s): M. Marqués, D. J. González, and L. E. González The melting curve of sodium for a pressure range up to 100 GPa has been evaluated by the orbital free ab initio molecular dynamics method. This method uses the electronic density as the basic variable combined with an approximate electronic kinetic energy functional and a local ionic pseudopotential… [Phys. Rev. B 94, 024204] Published Tue Jul 19, 2016

Description: Most populations of Scots pine in Spain are locally adapted to drought, with only a few populations at the southernmost part of the distribution range showing maladaptations to the current climate. Increasing tree heights are predicted for most of the studied populations by the year 2070, under the RCP 8.5 scenario. These results are probably linked to the capacity of this species to acclimatize to new climates. The impact of climate change on tree growth depends on many processes, including the capacity of individuals to respond to changes in the environment. Pines are often locally adapted to their environments, leading to differences among populations. Generally, populations at the margins of the species’ ranges show lower performances in fitness-related traits than core populations. Therefore, under expected changes in climate, populations at the southern part of the species’ ranges could be at a higher risk of maladaptation. Here, we hypothesize that southern Scots pine populations are locally adapted to current climate, and that expected changes in climate may lead to a decrease in tree performance. We used Scots pine tree height growth data from 15-year-old individuals, measured in six common gardens in Spain, where plants from 16 Spanish provenances had been planted. We analyzed tree height growth, accounting for the climate of the planting sites, and the climate of the original population to assess local adaptation, using linear mixed-effect models. We found that: (1) drought drove differences among populations in tree height growth; (2) most populations were locally adapted to drought; (3) tree height was predicted to increase for most of the studied populations by the year 2070 (a concentration of RCP 8.5). Most populations of Scots pine in Spain were locally adapted to drought. This result suggests that marginal populations, despite inhabiting limiting environments, can be adapted to the local current conditions. In addition, the local adaptation and acclimation capacity of populations can help margin populations to keep pace with climate change. Our results highlight the importance of analyzing, case-by-case, populations’ capacities to cope with climate change.

Description: This paper presents a payload designed to perform semi-autonomous contact inspection tasks without any type of positioning system external to the UAV, such as a global navigation satellite system (GNSS) or motion capture system, making possible inspection in challenging GNSS- denied sites. This payload includes two LiDAR sensors which measure the distance between the UAV and the target structure and their inner orientation angle. The system uses this information to control the approaching of the UAV to the structure and the contact between both, actuating over the pitch and yaw signals. This control is performed using a hybrid automaton with different states that represent all the possible UAV status during the inspection tasks. It uses different control strategies in each state. An ultrasonic gauge has been used as the inspection sensor of the payload to measure the thickness of a metallic sheet. The sensor requires a stable contact in order to collect reliable measurements. Several tests have been performed on the system, reaching accurate results which show it is able to maintain a stable contact with the target structure.

Description: Chokeberry (Aronia melanocarpa L.) contains a large number of bioactive compounds, which make of it a highly nutritional and antioxidant food with anti-cancer and anti-inflammatory properties. It has been recently seen its consumption increased because of its interesting composition and properties as a functional food. The ultrasound-assisted extraction method has been optimized, since it is a simple and fast technique to extract phenolic compounds, as well as anthocyanins, not only separately but also simultaneously. Multiple response has been optimized and demonstrated an effectiveness level similar to the individual ones. This represents a considerable reduction in costs, time and work. The optimal conditions for simultaneous extractions were: 54% methanol as extraction solvent at pH 2.72 and 69.4 °C temperature, 70% amplitude, 0.7 s cycle, and 0.5:18.2 g:mL sample mass/solvent volume ratio. The developed methods showed a high precision level with coefficients of variation lower than 5%. The methods were successfully applied to commercial samples. Additionally, the extraction of other compounds of biological interest, such as organic acids and sugars, was also studied.

Description: In this study, we pursue two objectives. First, we analyse the influence of product, process, and non-technological innovation on environmental performance. Second, we explore the existence of complementarities or substitutabilities between the different combinations of these three types of innovations to learn which combinations improve or worsen environmental performance. The analyses were performed using data from the 2013 Technological Innovation Panel (PITEC) for Spanish manufacturing companies. We use the two-stage least-squares method as an instrumental variable estimator, which allows us to control the endogeneity and obtain consistent estimators. Our findings indicate that product innovation and process innovation have a negative influence on environmental performance. Likewise, we have also found that the simultaneous implementation of product innovation and process innovation is unconditionally substitutive and that the joint implementation of process innovation and non-technological innovation is conditionally substitutive. This result reinforces the position of those researchers who have pointed out that the association between a greater technology orientation and a better firm environmental performance is probably too simplistic. Finally, it should be emphasized that only non-technological innovation contributes to achieving better environmental performance and that the joint implementation of product innovation and non-technology innovation is conditionally complementary.

Description: Multiphase machines allow enhancing the performance of wind energy conversion systems from the point of view of reliability and efficiency. The enhanced robustness has been traditionally achieved with a mandatory post-fault control reconfiguration. Nevertheless, when the regulation of x-y currents in multiphase drives is done in open-loop mode, the reconfiguration can be avoided. As a consequence, the reliability of the system increases because fault detection errors or delays have no impact on the post-fault performance. This capability has been recently defined as natural fault tolerance. From the point of view of the efficiency, multiphase machines present a better power density than three-phase machines and lower per-phase currents for the same voltage rating. Moreover, the implementation of control strategies based on a variable flux level can further reduce the system losses. Targeting higher reliability and efficiency for multiphase wind energy conversion systems, this work proposes the implementation of an efficient model predictive control using virtual voltage vectors for six-phase induction machines. The use of virtual voltage vectors allows regulation of the x-y currents in open-loop mode and achieving the desired natural fault tolerance. Then, a higher efficiency can be achieved with a simple and universal cost function, which is valid both in pre- and post-fault situations. Experimental results confirm the viability and goodness of the proposal.

Description: Power electronic development determines the introduction of nonlinear devices in electric power systems. Introduction of nonlinear devices increase current harmonics in transmission and distribution power systems. Distribution transformers and feeders increase power losses and their nominal parameters are reduced. The present work introduces a procedure to evaluate maximum permissible load in single phase distribution transformers with the introduction of a new type of nonlinear load which changes daily demand graphs.

Description: The proliferation of residential photovoltaic (PV) prosumers leads to detrimental impacts on the low-voltage (LV) distribution network operation such as reverse power flow, voltage fluctuations and voltage imbalances. This is due to the fact that the strategies for the PV inverters are usually designed to obtain the maximum energy from the panels. The most recent approach to these issues involves new inverter-based solutions. This paper proposes a novel comprehensive control strategy for the power electronic converters associated with PV installations to improve the operational performance of a four-wire LV distribution network. The objectives are to try to balance the currents demanded by consumers and to compensate the reactive power demanded by them at the expense of the remaining converters’ capacity. The strategy is implemented in each consumer installation, constituting a decentralized or distributed control and allowing its practical implementation based on local measurements. The algorithms were tested, in a yearly simulation horizon, on a typical Portuguese LV network to verify the impact of the high integration of the renewable energy sources in the network and the effectiveness and applicability of the proposed approach.

Description: Research interest regarding maqui (Aristotelia chilensis) has increased over the last years due to its potential health benefits as one of the most antioxidant-rich berries. Ultrasound-assisted extraction (UAE) is an advanced green, fast, and ecological extraction technique for the production of high quality extracts from natural products, so it has been proposed in this work as an ideal alternative extraction technique for obtaining extracts of high bioactivity from maqui berries. In order to determine the optimal conditions, the extraction variables (percentage of methanol, pH, temperature, ratio “sample mass/volume of solvent”, amplitude, and cycle) were analyzed by a Box-Behnken design, in conjunction with the response surface method. The statistical analysis revealed that the temperature and the percentage of methanol were the most influential variables on the extraction of the total phenolic compounds and total anthocyanins, respectively. The optimal extraction time was determined at 15 min for total phenolic compounds, while it was only 5 min for anthocyanins. The developed methods showed a high precision level with a coefficient of variation of less than 5%. Finally, the new methods were successfully applied to several real samples. Subsequently, the results were compared to those that were obtained in previous experiments by means of microwave assisted extraction (MAE). Similar extraction yields were obtained for phenolic compounds under optimized conditions. However, UAE proved to be slightly more efficient than MAE in the extraction of anthocyanins.

Description: Author(s): A. K. Nowak, E. Gallardo, H. P. van der Meulen, J. M. Calleja, J. M. Ripalda, L. González, and Y. González A continuous and systematic red shift of the exciton emission energy in small InP/InGaP quantum dots is observed for increasing excitation energies and intensities. Superposed on this red shift, emission energy minima appear which show a one-to-one correspondence to emission intensity maxima as a fu... [Phys. Rev. B 83, 245447] Published Tue Jun 28, 2011