ALBERT

Notes: Nitridation of the gate oxide is known to improve the radiation resistance of metal-oxide-semiconductor devices on silicon. However, it has generally been found that high-temperature, long-time anneals are required to produce the hardest dielectrics. We report results of 1–5 Mrad (Si) total dose radiation testing of thin gate oxides which have received relatively light nitridations, followed by a reoxidation step. These devices exhibit substantially reduced fixed charge and interface state buildup compared with oxide, and appear to be harder than the more heavily nitrided oxides previously reported.

Notes: Precise isosbestic points occur in the Raman OH-stretching spectra from liquid water between 3 and 85 °C if cell alignment is accomplished with Newton's rings. Isosbestic frequencies measured for the orientations X(Y,X+Z)Y=6β2, X(ZX)Y=3β2, X(Y+Z,X+Z)Y=45α2+13β2, X(Z,X+Z)Y=45α2+7β2, and X(ZZ)Y=45α2+4β2 are 3524, 3522 (note β2 agreement), 3468, 3425, and 3403 cm−1, respectively. Isosbestic points from two different measurements calculated by the relations, X(ZZ)Y-(4/3)X(ZX)Y and X(Z,X+Z)Y-(7/6)X(Y,X+Z)Y agree exactly for 45α2, 3370 cm−1. (α and β2 correspond to the mean polarizability and square of the anisotropy.) The pure α2 isosbestic frequency, 3370 cm−1, coincides with the peak of the highest frequency hydrogen-bonded (HB) Gaussian OH-stretching component. The pure β2 isosbestic point, 3522–3524 cm−1, coincides with the peak of the nonhydrogen-bonded (NHB) Gaussian OH-stretching component, next above in frequency. The α2 and β2 isosbestic points are thus thought to provide an experimental distinction between, and a clear definition of, the HB and NHB OH-oscillator classes for water. Moreover, the various OH-stretching combinations of α2 and β2 simply provide different measures of theHB→NHB equilibrium—no special information concerning the temperature dependence of this equilibrium results from use of any one linear polarizability combination over any other, including pure α2 or pure β2. The present results agree with mercury-excited data [Walrafen, J. Chem. Phys. 47, 114 (1967)] for X(Y+Z,X+Z)Y and with the corrected α2 data of d'Arrigo et al. [J. Chem. Phys. 75, 4264 (1981)]. Furthermore, the new data are in accord with the spectroscopic mixture model, but the continuum model conflicts with the observation of exact points. The isosbestic frequencies are also found to be strongly nonlinear in the amount of α2 or β2 involved in the spectra.

Notes: Low frequency Δν¯=0–350 cm−1, Raman intensity data were obtained from liquid water between 3.5 and 89.3 °C using holographic grating double and triple monochromators. The spectra were Bose–Einstein (BE) corrected, I/(1+n), and the total integrated (absolute) contour intensities were treated by an elaboration of the Young–Westerdahl (YW) thermodynamic method, assuming conservation of hydrogen-bonded (HB) and nonhydrogen-bonded (NHB=bent and/or stretched, O–H O) nearest-neighbor O–O pairs. A ΔH°1 value of 2.6±0.1 kcal/mol O–H ⋅⋅⋅ O or 5.2±0.2 kcal/mol H2O (11 kJ/mol O–H ⋅⋅⋅ O, or 22 kJ/mol H2O) resulted for the HB→NHB process. This intermolecular value agrees quantitatively with Raman and infrared ΔH° values from the one- and two-phonon OH-stretching regions, and from molecular dynamics, depolarized light scattering, neutron scattering, and ultrasonic absorption, thus indicating a common process. A population involving partial covalency of, i.e., charge transfer into, the H ⋅⋅⋅ O units of linear and/or weakly bent hydrogen bonds, O–H ⋅⋅⋅ O; is transformed into a second high energy population involving bent, e.g., 150° or less, and/or stretched, e.g., 3.2 A(ring), but otherwise strongly cohesive O–H O interactions. All difference spectra from the fundamental OH-stretching contours cross at the X(Z,X+Z)Y isobestic frequency of 3425 cm−1. Also, total integrated Raman intensity decreases occurring below 3425 cm−1 with temperature rise were found to be proportional to the total integrated intensity increases above 3425 cm−1, indicating conservation among the HB and NHB OH-stretching classes. From the enthalpy of vaporization of water at 0 °C, and the ΔH°1 of 2.6 kcal/mol O–H ⋅⋅⋅ O, the additionalenthalpy, ΔH°2, needed for the complete separation of the NHB O–O nearest neighbors is ∼3.2 kcal/mol O–H ⋅⋅⋅ O or ∼6.4 kcal/mol H2O (13 kJ/mol O–H ⋅⋅⋅ O or 27 kJ/mol H2O). The NHB O–O nearest neighbors are held by forces other than those involving H ⋅⋅⋅ O partial covalency, i.e., electrostatic (multipole), induction, and dispersion forces. The NHB O–O pairs do not appear to produce significant intermolecular Raman intensity because they lack H ⋅⋅⋅O bond polarizability, but the corresponding NHB OH oscillators do contribute weakened Raman intensity above 3425 cm−1. An ideal solution thermodynamic treatment employing ΔH°1 =2.6 kcal/mol O–H ⋅⋅⋅ O, the HB mole fraction, and the vapor heat capacity, yielded a very satisfactory specific heat value of 1.1 cal deg−1 g−1 H2O at 0 °C. The NHB mole fraction, fu, from the YW treatment is negligibly small, 0.06 or less, for t〈−50 °C. However, fu increases to 0.16 at 0 °C, and fu≈1 at 1437 °C, where recent shock-wave Raman measurements indicate loss of all partially covalent, charge transfer hydrogen bonding.

Notes: Summary Limit analysis studies the asymptotic behavior of elastic-plastic materials and structures. The asymptotic material properties exist for a class of ductile metals and are designed into optimal structural members such as I-beams and composite plates. The analysis automatically ignores the relatively small elastic deformations. Classical lower and upper bound theorems in the form of inequalities are mathematically incomplete. A duality theorem equates the greatest lower bound and the least upper bound. Although some general statement has been made on the duality relation of limit analysis, each yield criterion will lead to a specific duality theorem. The duality theorem for a class of plastic plates is established in this paper. The family of β-norms is used to represent the yield functions. Exact solutions for circular plates under a uniform load are obtained for clamped and simply supported boundaries as examples of the specific duality relations. Two classical solutions associated with Tresca and Johansen yield functions are also presented in the spirit of their own duality relations, providing interesting comparison to the new solutions. A class of approximate solutions by a finite element method is presented to show the rapid mesh convergence property of the dual formulation. Complete and general forms of the primal and dual limit analysis problems for the β-family plates are stated in terms of the components of the moment and curvature matrices.