ALBERT

Description: We present a crustal-scale seismic profile in the Barents Sea based on new data. Wide-angle seismic data were recorded along a 600 km long profile at 38 ocean bottom seismometer and 52 onshore station locations. The modeling uses the joint refraction/reflection tomography approach where co-located multi-channel seismic reflection data constrain the sedimentary structure. Further, forward gravity modeling is based on the seismic model. We also calculate net regional erosion based on the calculated shallow velocity structure. Our model reveals a complex crustal structure of the Baltic Shield to Barents shelf transition zone, as well as strong structural variability on the shelf itself. We document large volumes of pre-Carboniferous sedimentary strata in the transition zone which reach a total thickness of 10 km. A high-velocity crustal domain found below the Varanger Peninsula likely represents an independent crustal block. Large lower crustal bodies with very high velocity and density below the Varanger Peninsula and the Fedynsky High are interpreted as underplated material that may have fed mafic dykes in the Devonian. We speculate that these lower crustal bodies are linked to the Devonian rifting processes in the East European Craton, or belonging to the integral part of the Timanides, as observed onshore in the Pechora Basin.

Description: We present results from an active-source, onshore–offshore seismic reflection/refraction transect acquired as part of the PETROBAR project (Petroleum-related studies of the Barents Sea region). The 700 km-long profile is oriented NW–SE, coincident with previously published multichannel seismic reflection profiles. We utilize layer-based raytracing in a Markov Chain Monte Carlo (MCMC) inversion to determine a probabilistic velocity model constraining the sedimentary rocks, crystalline crust, and uppermost mantle in a complex tectonic regime. The profile images a wide range of crustal types and ages, fromProterozoic craton to Paleozoic to early Cenozoic rift basins; and volcanics related to Eocene continental breakupwith Greenland. Our analyses indicate a complex architecture of the crystalline crust along the profile,with crystalline crustal thicknesses ranging from43 kmbeneath the Varanger Peninsula to 12 kmbeneath the Bjørnøya Basin. Assuming an original, post-Caledonide crustal thickness of 35 km in the offshore area, we calculate the cumulative thinning (β) factors along the entire profile. The average β factor along the profile is 1.7 ± 0.1, suggesting 211–243 km of extension, consistent with the amount of overlap derived from published plate reconstructions. Local β factors approach 3, where Bjørnøya Basin reaches a depth of more than 13 km. Volcanics, carbonates, salt, diagenesis and metamorphism make deep sedimentary basin fill difficult to distinguish from original, pre-rift crystalline crust, and thus actual stretching may in places exceed our estimates.

Description: Highlights • The basement at the mid-Norwegian Møre Margin is dominantly felsic in composition. • A lower crustal body is interpreted as a mixture of continental blocks and eclogite. • The thickness of the outer lower crustal body is twice as thick on the East Greenland Margin. • The thinning during this first phase of post-Caledonian extension was highest for proto Norway. Abstract The inner part of the volcanic, passive Møre Margin, mid-Norway, expresses an unusual abrupt thinning from high onshore topography with a thick crust to an offshore basin with thin crystalline crust. Previous P-wave modeling of wide-angle seismic data revealed the presence of a high-velocity (7.7–8.0 km/s) body in the lower crust in this transitional region. These velocities are too high to be readily interpreted as Early Cenozoic intrusions, a model often invoked to explain lower crustal high-velocity bodies in the region. We present a Vp/Vs model, derived from the modeling of wide-angle seismic data, acquired by use of Ocean Bottom Seismograph horizontal components. The modeling suggests dominantly felsic composition of the crust. An average Vp/Vs value for the lower crustal body is modeled at 1.77, which is compatible with a mixture of continental blocks and Caledonian eclogites. The results are compiled with earlier results into a transect extending from onshore Norway to onshore Greenland. Back-stripping of the transect to Early Cenozoic indicates asymmetric conjugate magmatism related to the continental break-up. Further back-stripping to the time when most of the Caledonian mountain range had collapsed indicates that the thinning during the first phase of extension was about 25% higher for proto Norway than proto Greenland.

Description: The Møre Margin in the NE Atlantic represents a dominantly passive margin with an unusual abrupt transition from alpine morphology onshore to a deep sedimentary basin offshore. In order to study this transition in detail, three ocean bottom seismometer profiles with deep seismic reflection and refraction data were acquired in 2009; two dip-profiles which were extended by land stations, and one tie-profile parallel to the strike of the Møre–Trøndelag Fault Complex. The modeling of the wide-angle seismic data was performed with a combined inversion and forward modeling approach and validated with a 3D-density model. Modeling of the geophysical data indicates the presence of a 12–15 km thick accumulation of sedimentary rocks in the Møre Basin. The modeling of the strike profile located closer to land shows a decrease in crustal velocity from north to south. Near the coast we observe an intra-crustal reflector under the Trøndelag Platform, but not under the Slørebotn Sub-basin. Furthermore, two lower crustal high-velocity bodies are modeled, one located near the Møre Marginal High and one beneath the Slørebotn Sub-basin. While the outer lower crustal body is modeled with a density allowing an interpretation as magmatic underplating, the inner body has a density close to mantle density which might suggest an origin as an eclogized body, formed by metamorphosis of lower crustal gabbro during the Caledonian orogeny. The difference in velocity and extent of the lower crustal bodies seems to be controlled by the Jan Mayen Lineament, suggesting that the lineament represents a pre-Caledonian structural feature in the basement.

Description: Controlled source seismic investigation of crustal structure below ice covers is an emerging technique. We have recently conducted an explosive refraction/wide-angle reflection seismic experiment on the ice cap in east-central Greenland. The data-quality is high for all shot points and a full crustal model can be modelled. A crucial challenge for applying the technique is to control the sources. Here, we present data that describe the efficiency of explosive sources in the ice cover. Analysis of the data shows, that the ice cap traps a significant amount of energy, which is observed as a strong ice wave. The ice cap leads to low transmission of energy into the crust such that charges need be larger than in conventional onshore experiments to obtain reliable seismic signals. The strong reflection coefficient at the base of the ice generates strong multiples which may mask for secondary phases. This effect may be crucial for acquisition of reflection seismic profiles on ice caps. Our experience shows that it is essential to use optimum depth for the charges and to seal the boreholes carefully.

Description: We constrain the lithospheric mantle density of the North China Craton (NCC) at both in situ and standard temperature‐pressure (STP) conditions from gravity data. The lithosphere‐asthenosphere boundary (LAB) depth is constrained by our new thermal model, which is based on a new regional heat flow data set and a recent regional crustal model NCcrust. The new thermal model shows that the thermal lithosphere thickness is 〈120 km in most of the NCC, except for the northern and southern parts with the maximum depth of 170 km. The gravity calculations reveal a highly heterogeneous density structure of the lithospheric mantle with in situ and STP values of 3.22–3.29 and 3.32–3.40 g/cm3, respectively. Thick and reduced‐density cratonic‐type lithosphere is preserved mostly in the southern NCC. Most of the Eastern Block has a thin (90–140 km) and high‐density lithospheric mantle. Most of the Western Block has a high‐density lithospheric mantle and a thin (80–110 km) lithosphere typical of Phanerozoic regions, which suggests that the Archean lithosphere is no longer present there. We conclude that in almost the entire NCC the lithosphere has lost its cratonic characteristics by geodynamic processes that include, but are not limited to, the Paleozoic closure of the Paleo‐Asian Ocean in the north, the Mesozoic Yangtze Craton flat subduction in the south, the Mesozoic Pacific subduction in the east, the Cenozoic remote response to the Indian‐Eurasian collision in the west, and the Cenozoic extensional tectonics (possibly associated with the slab roll‐back) in the center.

Description: Antarctica has traditionally been considered continental inside the coastline of ice and bedrock since Press and Dewart (1959). Sixty years later, we reconsider the conventional extent of this sixth continent. Geochemical observations show that subduction was active along the whole western coast of West Antarctica until the mid-Cretaceous after which it gradually ceased towards the tip of the Antarctic Peninsula. We propose that the entire West Antarctica formed as a back-arc basin system flanked by a volcanic arc, similar to e.g. the Japan Sea, instead of a continental rift system as conventionally interpreted. Globally, the fundamental difference between oceanic and continental lithosphere is reflected in hypsometry, largely controlled by lithosphere buoyancy. The equivalent hypsometry in West Antarctica (−580 ± 335 m on average, extending down to −1.6 km) is much deeper than in any continent, but corresponds to back-arc basins and oceans proper. This first order observation questions the conventional interpretation of West Antarctica as continental, since even continental shelves do not extend deeper than −200 m in equivalent hypsometry. We present a suite of geophysical observations that supports our geodynamic interpretation: a linear belt of seismicity sub-parallel to the volcanic arc along the Pacific margin of West Antarctica; a pattern of free air gravity anomalies typical of subduction systems; and extremely thin crystalline crust typical of back-arc basins. We calculate residual mantle gravity anomalies and demonstrate that they require the presence of (1) a thick sedimentary sequence of up to ca. 50% of the total crustal thickness or (2) extremely low density mantle below the deep basins of West Antarctica and, possibly, the Wilkes Basin in East Antarctica. Case (2) requires the presence of anomalously hot mantle below the entire West Antarctica with a size much larger than around continental rifts. We propose, by analogy with back-arc basins in the Western Pacific, the existence of rotated back-arc basins caused by differential slab roll-back during subduction of the Phoenix plate under the West Antarctica margin. Our finding reduces the continental lithosphere in Antarctica to 2/3 of its traditional area. It has significant implications for global models of lithosphere-mantle dynamics and models of the ice sheet evolution.