ALBERT

Beschreibung: The MSFC's Experimental Vector Magnetograph (EXVM) is an instrument that observes a 4.4 x 8.8 arcmin field of the sun. The transverse and longitudinal components of the surface magnetic field and the line-of-sight velocities of the photospheric gases can be determined from polarimetric and spectral analysis of the 525.02 nm absorption line of Fe 1. The EXVM has been breadboarded and tested in the laboratory. The optics of the EXVM were tested with a point-diffraction (Smartt) interferometer. The 12 inch Cassegrain telescope was found to have 0.20 waves RMS (at 525.02 nm) of aberration. The post-telescope relay optics were nearly diffraction limited on-axis and had about one wave of primary coma as the predominant aberration at full-field. From theoretical modulation transfer function (MTF) curves of known aberrations, it was concluded that the EXVM should attain a maximum spatial resolution of about 0.5 arcseconds. A resolution test target indicated maximum angular resolutions better than 0.6 arcsec on-axis and 0.7 arcsec at full-field-of-view. A 2D inch heliostat (sun-tracking mirror) was used to direct sunlight into the lab and into the EXVM. Solar images obtained were limited by atmospheric seeing effects. During brief moments of good seeing, angular resolutions of about 1 arcsecond were realized with the EXVM.

Beschreibung: The need for a validation technique for computational fluid dynamics (CFD) codes in STOVL applications has led to research efforts to apply infrared thermal imaging techniques to visualize gaseous flow fields. Specifically, a heated, free-jet test facility was constructed. The gaseous flow field of the jet exhaust was characterized using an infrared imaging technique in the 2 to 5.6 micron wavelength band as well as conventional pitot tube and thermocouple methods. These infrared images are compared to computer-generated images using the equations of radiative exchange based on the temperature distribution in the jet exhaust measured with the thermocouple traverses. Temperature and velocity measurement techniques, infrared imaging, and the computer model of the infrared imaging technique are presented and discussed. From the study, it is concluded that infrared imaging techniques coupled with the radiative exchange equations applied to CFD models are a valid method to qualitatively verify CFD codes used in STOVL applications.

Beschreibung: Accurate measurement of fluctuations in temperature and humidity are needed for determination of the surface evaporation rate and the air-sea sensible heat flux using either the eddy correlation or inertial dissipation method for flux calculations. These measurements are difficult to make over the ocean, and are subject to large errors when sensors are exposed to marine air containing spray droplets. All currently available commercial measurement devices for atmospheric humidity require frequent maintenance. Included in the objectives of the Humidity Exchange over the Sea program were testing and comparison of sensors used for measuring both the fluctuating and mean humidity in the marine atmosphere at high wind speeds and development of techniques for the protection of these sensors against contamination by oceanic aerosols. These sensors and droplet removal techniques are described and comparisons between measurements from several different systems are discussed in this paper. To accomplish these goals, participating groups devised and tested three methods of removing sea spray from the sample airstream. The best performance was given by a rotating semen device, the “spray Ringer.” Several high-frequency temperature and humidity instruments, based on different physical principles, were used in the collaborative field experiment. Temperature and humidity fluctuations were measured with sufficient accuracy inside the spray removal devices using Lyman-α hygrometers and a fast thermocouple psychrometer. Comparison of several types of psychrometers (using electric thermometers) and a Rotronic MP-100 humidity sensor for measuring the mean humidity illustrated the hysteresis of the Rotronic MP-100 device after periods of high relative humidity. Confidence in the readings of the electronic psychrometer was established by in situ calibration with repeated and careful readings of ordinary hand-held Assman psychrometers (based on mercury thermometers). Electronic psychrometer employing platinum resistance thermometers perform very well.