ALBERT

Description: Low temperature alteration of oceanic basement rocks is characterized by net gain of sulfur, which commonly yields low d34S values, suggesting involvement of microbial sulfate reduction. In order to test whether secondary sulfide minerals are consistent with a biogenic source, we apply high precision multiple sulfur isotope analysis to bulk rock sulfide and pyrite isolates from two contrasting types of altered oceanic basement rocks, namely serpentinized peridotites and altered basalts. Samples from two peridotite sites (Iberian Margin and Hess Deep) and from a basalt site on the eastern flank of the Juan de Fuca Ridge yield overlapping d34S values ranging from 0 per mil to -44 per mil. In contrast, sulfides in the basalt site are characterized by relatively low D33S values ranging from -0.06 per mil to 0.04 per mil, compared to those from peridotite sites (0.00 per mil to 0.16 per mil). The observed D33S signal is significant considering the analytical precision of 0.014 per mil (2 sigma). We present a batch reaction model that uses observed d34S and D33S relationships to quantify the effect of closed system processes and constrain the isotope enrichment factor intrinsic to sulfate reduction. The estimated enrichment factors as large as 61 per mil and 53 per mil, for peridotite and basalt sites respectively, suggest the involvement of microbial sulfate reduction. The relatively high D33S values in the peridotite sites are due to sulfate reduction in a closed system environment, whereas negative D33S values in the basalt site reflect open system sulfate reduction. A larger extent of sulfate reduction during alteration of peridotite to serpentinite is consistent with its higher H2 production capacity compared to basalt alteration, and further supports in-situ microbial sulfate reduction coupled with H2 production during serpentinization reactions.

Description: Leg 83 of the Deep Sea Drilling Project has deepened Hole 504B to over 1 km into basement, 1350 m below the seafloor (BSF). The hole previously extended through 274.5 m of sediment and 561.5 m of pillow basalts altered at low temperature (〈 100°C), to 836 m BSF. Leg 83 drilling penetrated an additional 10 m of pillows, a 209-m transition zone, and 295 m into a sheeted dike complex. Leg 83 basalts (836-1350 m BSF) generally contain superimposed greenschist and zeolite-facies mineral parageneses. Alteration of pillows and dikes from 836 to 898 m BSF occurred under reducing conditions at low water/rock ratios, and at temperatures probably greater than 100°C. Evolution of fluid composition resulted in the formation of (1) clay minerals, followed by (2) zeolites, anhydrite, and calcite. Alteration of basalts in the transition zone and dike sections (898-1350 m BSF) occurred in three basic stages, defined by the opening of fractures and the formation of characteristic secondary minerals. (1) Chlorite, actinolite, pyrite, albite, sphene, and minor quartz formed in veins and host basalts from partially reacted seawater (Mg-bearing, locally metal-and Si-enriched) at temperatures of at least 200-250°C. (2) Quartz, epidote, and sulfides formed in veins at temperatures of up to 380°C, from more evolved (Mg-depleted, metal-, Si-, and 18O-enriched) fluids. (3) The last stage is characterized by zeolite formation: (a) analcite and stilbite formed locally, possibly at temperatures less than 200°C followed by (b) formation of laumontite, heulàndite, scolecite, calcite, and prehnite from solutions depleted in Mg and enriched in Ca and 18O, at temperatures of up to 250°C. The presence of small amounts of anhydrite locally may be due to ingress of relatively unaltered seawater into the system during Stage 3. Alteration was controlled by the permeability of the crust and is characterized by generally incomplete recrystallization and replacement reactions among secondary minerals. Secondary mineralogy in the host basalts is strongly controlled by primary mineralogy. The alteration of Leg 83 basalts can be interpreted in terms of an evolving hydrothermal system, with (a) changes in solution composition because of reaction of seawater fluids with basalts at high temperatures; (b) variations in permeability caused by several stages of sealing and reopening of cracks; and (c) a general cooling of the system, caused either by the cooling of a magma chamber beneath the spreading center and/or the movement of the crust away from the heat source. The relationship of the high-temperature alteration in the transition zone and dike sections to the low-temperature alteration in the overlying pillow section remains uncertain.