ISSN:
1420-9136
Schlagwort(e):
Stick-slip friction
;
mining-induced earthquakes
;
seismic efficiency
Quelle:
Springer Online Journal Archives 1860-2000
Thema:
Geologie und Paläontologie
,
Physik
Notizen:
Abstract Although laboratory stick-slip friction experiments have long been regarded as analogs to natural crustal earthquakes, the potential use of laboratory results for understanding the earthquake source mechanism has not been fully exploited because of essential difficulties in relating seismographic data to measurements made in the controlled laboratory environment. Mining-induced earthquakes, however, provide a means of calibrating the seismic data in terms of laboratory results because, in contrast to natural earthquakes, the causative forces as well as the hypocentral conditions are known. A comparison of stick-slip friction events in a large granite sample with mining-induced earthquakes in South Africa and Canada indicates both similarities and differences between the two phenomena. The physics of unstable fault slip appears to be largely the same for both types of events. For example, both laboratory and mining-induced earthquakes have very low seismic efficiencies $$\eta = \tau _a /\bar \tau$$ where τ a is the apparent stress and $$\bar \tau$$ is the average stress acting on the fault plane to cause slip; nearly all of the energy released by faulting is consumed in overcoming friction. In more detail, the mining-induced earthquakes differ from the laboratory events in the behavior of η as a function of seismic momentM 0. Whereas for the laboratory events η≃0.06 independent ofM 0, η depends quite strongly onM 0 for each set of induced earthquakes, with 0.06 serving, apparently, as an upper bound. It seems most likely that this observed scaling difference is due to variations in slip distribution over the fault plane. In the laboratory, a stick-slip event entails homogeneous slip over a fault of fixed area. For each set of induced earthquakes, the fault area appears to be approximately fixed but the slip is inhomogeneous due presumably to barriers (zones of no slip) distributed over the fault plane; at constant $$\bar \tau$$ , larger events correspond to largerτ a as a consequence of fewer barriers to slip. If the inequality τ a / $$\bar \tau$$ ≤ 0.06 has general validity, then measurements of τ a =µE a /M 0, where μ is the modulus of rigidity andE a is the seismically-radiated energy, can be used to infer the absolute level of deviatoric stress at the hypocenter.
Materialart:
Digitale Medien
URL:
http://dx.doi.org/10.1007/BF00876051
Permalink
