ISSN:
0003-3146
Keywords:
Chemistry
;
Polymer and Materials Science
Source:
Wiley InterScience Backfile Collection 1832-2000
Topics:
Chemistry and Pharmacology
,
Physics
Description / Table of Contents:
Um die Eignung von stabilen Initiatoren für die Hochdruckpolymerisation von Ethylen zu prüfen, wurden Polymerisationsversuche in einem kontinuierlich betriebenen Rührautoklaven durchgeführt. Der Druck betrug 1700 bar und die mittlere Verweilzeit 30 Sekunden. Die Temperatur wurde im Bereich von 200 bis 360°C eingestellt, die Initiatorkonzentration im Ethylenzulauf wurde zwischen 4 und 40 mol-ppm variiert. Als stabile Initiatoren wurden Di-tert-butylperoxid, Di-tert-amylperoxid, tert-Butylhydroperoxid sowie eine C—Cliable Verbindung, das 3,4-Dimethyl-3,4-diphenylhexan, ausgewählt. Aus den Polymerisationsversuchen wurden der Umsatz und der spezifische Initiatorverbrauch bestimmt. Die erhaltenen Polymeren wurden durch Messung ihrer Dichte, der mittleren Molmasse sowie des Schmelzindexes charakterisiert. Die eingesetzten stabilen Initiatoren zeichnen sich alle durch einen sehr geringen Verbrauch aus. Die optimale Einsatztemperatur liegt bei den Dialkylperoxiden sowie dem Alkylhydroperoxid deutlich über 200 und bei dem C—C-labilen Initiator über 300°C. Unter diesen Bedingungen wurden Polymere mit niedriger Dichte, niedriger Molmasse, engerer Molmassenverteilung und höherem Schmelzindex erhalten.
Notes:
In order to assess the suitability of stable initiators for the high pressure polymerization of ethylene, polymerization tests were carried out in a stirred autoclave in continuous operation. The pressure used was 1700 bar, the average residence time 30 seconds and the temperature was adjusted to between 200 and 360°C. The initiator concentration in the ethylene feed varied between 4 and 40 mol ppm. Di-tert-butyl peroxide, di-tert-amyl peroxide, tert-butyl hydroperoxide, and 3,4-di-methyl-3,4-di-phenyl hexane, a C—C labile compound, were chosen for use as stable initiators. The level of conversion and the specific initiator consumption were determined. The polymers obtained were characterized by measuring their density, average molecular weight, and melt flow index. The stable initiators used were all characterized by a very low level of consumption. In the case of dialkyl peroxides and alkyl hydroperoxide, the optimum application temperature is substantially above 200°C and above 300°C in the case of the C—C labile initiator. Under these conditions, polymers with a low density, a low molecular weight, a narrow molecular weight distribution and a high melt flow index were obtained.
Additional Material:
5 Ill.
Type of Medium:
Electronic Resource
URL:
http://dx.doi.org/10.1002/apmc.1988.051600116
Permalink