ALBERT

All Library Books, journals and Electronic Records Telegrafenberg

feed icon rss

Your email was sent successfully. Check your inbox.

An error occurred while sending the email. Please try again.

Proceed reservation?

Export
Filter
  • Polymer and Materials Science  (171)
  • Meteorology and Climatology  (19)
  • 1
    ISSN: 0021-8995
    Keywords: Chemistry ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics , Physics
    Notes: Existing viscosity data on polyethylenes were studied as a function of temperature and molecular weight. New measurements were made on low density polyethylenes which had molecular weights useful for the test of theory. Viscosities of normal alkanes, considered as a lower extension of polyethylenes, were also correlated. The equation, log η = A log (M) - B (where η is absolute viscosity, M is molecular weight, and A and B are constants), is applicable over a wide range of Newtonian viscosities. Bueche's theory postulates that A approaches unity for chain lengths up to a critical molecular weight, Mc, where molecular entanglement abruptly becomes important. Above Mc, the theory requires A to be 3.4. Values of A for normal alkanes are shown to approach unity below Mc. The entanglement point, Mc, is temperature dependent and occurs at relatively low molecular weights. Above Mc, A for linear polyethylenes is near 3.4. However, certain polyethylene data give higher values for A. Activation energies for viscous flow, ΔE*, were obtained for polyethylenes and normal alkanes. They were found to be internally consistent and to vary as a linear function of the log of molecular weight. The change of ΔE* with less general functions of molecular weights shows a maximum curvature near Mc. Results are considered in terms of flow theory.
    Additional Material: 5 Ill.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 2
    ISSN: 0021-8995
    Keywords: Chemistry ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics , Physics
    Notes: A high shear, concentric cylinder viscometer was used to study polyethylene samples which differed in molecular weight. Viscosities were measured at several temperatures in laminar flow at shear rates up to 2.5 × 105 sec.-1. Five high molecular weight normal alkanes were also studied in evaluating shear dependent flow. Viscosities of the normal alkanes and polyethylenes with molecular weights up to about 3300 were Newtonian over the shear range studied. Polyethylenes with higher molecular weights showed large and reversible decreases in viscosity with increasing shear. Viscosity results at high shear were compared with available theory. Previous concepts based on molecular orientation apparently cannot account for the abrupt onset of non-Newtonian flow with increasing molecular weight. An alternate explanation of non-Newtonian flow is offered in terms of molecular disentanglements. This concept permits a qualitative prediction of the magnitude of non-Newtonian flow, as well as the molecular weights for which it will become important.
    Additional Material: 7 Ill.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 3
    ISSN: 0021-8995
    Keywords: Chemistry ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics , Physics
    Notes: A small-scale fractionation of 9 g. and a large-scale fractionation of 90 g. of a polyester were carried out. The polymer was prepared by condensation of isophthalic acid, maleic anhydride, and propylene glycol in the mole ratio 1:2:3. Results from the two fractionations were in good agreement despite different fractionation conditions. By proton magnetic resonance measurements the fractions were found to have nearly constant chemical compositions. The Huggins' constant and the Staudinger relation for this polyester were determined from data on fractions in chloroform at 30°C. Integral and differential molecular weight distributions as well as various molecular weight averages for the polyester were obtained by a computer program. The fractionation data were applied to several popular distribution correlations. The experimental distribution was found to be in good agreement with that expected from the theory of polycondensation kinetics.
    Additional Material: 3 Ill.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 4
    Electronic Resource
    Electronic Resource
    New York, NY [u.a.] : Wiley-Blackwell
    Journal of Applied Polymer Science 10 (1966), S. 1617-1623 
    ISSN: 0021-8995
    Keywords: Chemistry ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics , Physics
    Notes: The n-alkyl α-cyanoacrylates from methyl through n-octyl exhibit a reverse order of polymerization rate on biological substrates compared to that on water. On water, the lower homologs spread and polymerize rapidly, whereas the higher homologs spread but polymerize slowly. On biological substrates, the lower homologs do not spread or spread slightly and the higher homologs exhibit large spreadabilities and very rapid polymerization rates. Determination of the spreading coefficients for these systems by using the monomers or model compounds confirm the observed spreadabilities. It is proposed that the increased rate of polymerization of the higher homologs on biological substrates may be due to increased catalyst concentrations on these surfaces or to the solubilization of the higher homologs at the interface, making the catalyst sites more available to the monomer. The suggestion is made that if the liquid monomers spread and orient on the substrate and subsequently polymerize, the polymers will maintain the orientation. If such is the case, a technique is available for preparing stereospecific vinyl polymers which may have different spatial configurations depending on the polarity of the liquid substrate upon which they have been allowed to spread and polymerize.
    Additional Material: 1 Ill.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 5
    Electronic Resource
    Electronic Resource
    New York, NY [u.a.] : Wiley-Blackwell
    Journal of Applied Polymer Science 11 (1967), S. 335-340 
    ISSN: 0021-8995
    Keywords: Chemistry ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics , Physics
    Notes: Gel permeation chromatography was used to follow changes in the molecular weight distribution of a polyisobutene, initial Mv = 466,000, during degradation induced by sonic irradiation. Seven samples taken at times of 200-163,500 sec. were studied. In general, a steady decrease in molecular weight was observed, although a bimodal distribution was present after 20,000 sec. irradiation. Various measures of inhomogeneity, Mw/Mn, U, etc., were examined. The function, σn/Mw, where σn is the standard deviation of the number distribution, is considered as a measure of the relative distribution. It is shown to be almost constant throughout the degradation.
    Additional Material: 4 Ill.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 6
    Electronic Resource
    Electronic Resource
    New York, NY [u.a.] : Wiley-Blackwell
    Journal of Applied Polymer Science 8 (1964), S. 1371-1378 
    ISSN: 0021-8995
    Keywords: Chemistry ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics , Physics
    Notes: To characterize butene polymers, rapid and precise small- and large-scale column fractionation techniques have been developed for low molecular weight pure polyisobutenes and for mixed butene polymers. Fractionation results have been used to determine molecular weight distribution curves of typical commercial butene polymers. Narrow distribution fractions obtained from fractionation have been used to investigate viscosity-molecular weight correlations for both pure polyisobutenes and for mixed butene polymers. Molecular weights were predominantly determined with the relatively new technique of vapor pressure osmometry. Molecular weights and distributions were also checked with cryoscopic and light scattering molecular weights. The chemical composition of several fractions was determined by high resolution nuclear magnetic resonance. The Huggins' constant was measured for several bulk polymers and established for low molecular weight butene polymers.
    Additional Material: 4 Ill.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 7
    Electronic Resource
    Electronic Resource
    New York, NY [u.a.] : Wiley-Blackwell
    Journal of Applied Polymer Science 7 (1963), S. S33 
    ISSN: 0021-8995
    Keywords: Chemistry ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics , Physics
    Additional Material: 2 Ill.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 8
    Electronic Resource
    Electronic Resource
    New York, NY [u.a.] : Wiley-Blackwell
    Journal of Applied Polymer Science 7 (1963), S. S33 
    ISSN: 0021-8995
    Keywords: Chemistry ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics , Physics
    Additional Material: 2 Ill.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 9
    ISSN: 0021-8995
    Keywords: Chemistry ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics , Physics
    Notes: A group of C14-tagged ethylene and propylene polymers consisting of physical mixtures of homopolymers, block copolymers made up of two homopolymer sequences, and block copolymers made up of several homopolymer segments has been studied by differential thermal analysis (DTA). The effect of randomness in copolymers has also been studied in this set of systems, which contains 0-51 wt.-% ethylene. Block copolymers and physical mixtures have been found to have thermograms with endothermal minima at approximately 138 and 163°C. The ratio of heights of the two minima has been found to be a function of the ethylene and propylene content for mixtures of homopolymers and for block copolymers without randomness. DTA thus provides an analysis for monomer ratios in physical mixtures and in block copolymers of ethylene and propylene. The cooling thermograms of block copolymers have been demonstrated to have two exotherms in all cases where the block ethylene content exceeded 10%; the propylene limit was not fixed. Mixed homopolymers do not exhibit two freezing exotherms. The total heat of fusion of the polymer has been found to be a usable measure of chain randomness and block nature. The conditions for observation of single and multiple transitions have been extended.
    Additional Material: 3 Ill.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 10
    ISSN: 0021-8995
    Keywords: Chemistry ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics , Physics
    Notes: A concentric cylinder viscometer was used to measure high shear viscosities of polyisobutene solutions. Data were obtained in laminar flow from 20-100°C. and at shear rates from 5 × 102 to 8 × 105 sec.-1. Three polymer molecular weights, 4.0 × 104-2.2 × 106, in three concentrations from 11.5-49.2 wt.-% polymer were tested in cetane. The viscosity of cetane at all test temperatures was low and independent of shear rate up to 106 sec.-1. Therefore, variations in viscosity with shear were due totally to the effect of polymer. Viscosities of 11.5% solutions of low molecular weight polyisobutene, 4-6 × 104, approached limiting viscosities at both high and low rates of shear. Viscosity changed markedly between the limiting values as did the flow activation energy at constant shear rate, ΔE*r. At extremes of both high and low shear rate ΔE*r appeared to be insensitive to polymer molecular weight. Solutions containing the highest molecular weight and concentration of polyisobutene reached shear stresses for polymer degradation before a limiting high shear viscosity could be observed. For all solutions, ΔE*r was independent of temperature form 20-100°C. At low shear, ΔE*r increased with polymer concentration. At high shear, the concentration dependence was reversed, with the highest concentration having the lowest ΔE*r. A simple shear correlation was found to superimpose all data for which reduced viscosities could be derived. Reduced specific viscosities superimposed on a master curve when plotted against log (shear stress/T°K). The correlation covered data at all temperatures and concentrations for the two lower molecular weight polymer solutions.
    Additional Material: 7 Ill.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
Close ⊗
This website uses cookies and the analysis tool Matomo. More information can be found here...