ALBERT

All Library Books, journals and Electronic Records Telegrafenberg

feed icon rss

Your email was sent successfully. Check your inbox.

An error occurred while sending the email. Please try again.

Proceed reservation?

Export
  • 1
    Publication Date: 2021-01-11
    Description: The kinetics of hydrated basaltic melts erupted during the present activity at Stromboli have been studied to estimate the growth and dissolution rate of plagioclase. Specifically, a high-K basalt composition (PST-9) has been studied to investigate magma and eruption dynamics at Stromboli volcano by combining crystallization kinetics of plagioclase and CSD measurements on natural samples from literature (Armienti et al., 2007; Fornaciai et al., 2009). A series of water-saturated decompression experiments over a range of final water pressure (Pf = 75–5 MPa) at constant temperature (1075 C) show that plagioclase is systematically present from 50 to 5 MPa at water saturated conditions. Moreover, these experiments show that anorthite (An) content decreases with decreasing PH2O, reaching the same composition as the natural plagioclase in Stromboli scoria at pressure below 20 MPa and that the plagioclase crystal fraction increases as the experimental conditions tend to lower final pressure. Plagioclase growth rate (GL) is observed to increase with undercooling for the Pf investigated during decompression experiments, except for the 75 MPa Pf serie that only has two samples with the presence of plagioclase crystals. The values of GL vary from 10 7 to 10 8 cm/s for Pf from 75 to 25 MPa, while at Pf from 10 to 5 MPa growth rates are approximately of 10 6 cm/s. A series of dissolution experiments at atmospheric pressure and over a range of temperature has been done for plagioclase (T range of 1220–1240 C). Dissolution rate (G-) for plagioclase (10 7 cm/s) tends to be slightly higher at higher temperature in the range of 1220–1240 C and appears to be time independent for the experimental durations investigated (10–30 h). These trends could be related to development of a diffusion-limited boundary layer adjacent to the dissolving crystal. By comparison of the experimental data on plagioclase composition, growth rates and dissolution in Stromboli basalt, it is possible to place the reservoir of the crystal-rich magma in the upper part (from 400 m to the surface) of the volcanic conduit. Kinetic data of the plagioclase, the most important phase of the shallow magmatic system of Stromboli, show that the magmatic processes are quite dynamic and in a relatively short time (hours or several days) the system can change considerably. Furthermore, the results from this work combined with observations on natural samples help to improve our knowledge of the magma plumbing system, of interactions between resident magma and new magmas, the dynamics of volcanic activity of Stromboli, and the time scales of magmatic processes that change in a few hours to 1 month.
    Description: Published
    Description: 135-151
    Description: 2V. Dinamiche di unrest e scenari pre-eruttivi
    Description: JCR Journal
    Description: restricted
    Keywords: Experimental petrology ; Basalts ; magma Kinetics ; 04. Solid Earth::04.08. Volcanology::04.08.03. Magmas
    Repository Name: Istituto Nazionale di Geofisica e Vulcanologia (INGV)
    Type: article
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 2
    Publication Date: 2014-09-09
    Description: An extensive development and testing program on adhesive systems shows that: (1) A closed cell silicone rubber sponge bonded to substrates with thin bond lines of glass filled adhesive exhibits density and modulus values approximately one third that of solid silicone adhesives; (2) utilization of glass or phenolic microballoons as fillers in silicone adhesives reduces density but increases moduli of the vulcanized materials; (3) the silicone elastomer based adhesives appear to be complex systems rather than homogeneous, isotropic materials. Tensile, shear, and compression properties plotted versus temperature verify this conjecture; and (4) constant strain-stress relaxation tests on glass-filled adhesive show that stress relaxation is most pronounced near the glass transition temperature.
    Keywords: MATERIALS, NONMETALLIC
    Type: NASA. Ames Res. Center Symp. on Reusable Surface Insulation for Space Shuttle, Vol. 3; p 935-964
    Format: text
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 3
    Publication Date: 2019-06-27
    Description: The task consisted of conducting mechanical and thermal tests to establish design allowables data on a new room temperature vulcanizing (RTV) silicone adhesive, X3-6004. Low modulus, coupled with relatively low density and good low-temperature properties of this adhesive, places it in contention as a candidate for attaching reusable surface insulation on the space shuttle. Data obtained show that the modulus values of X3-6004 are significantly lower than those of RTV-560 and the other three adhesives characterized at test temperatures from 550 to -175 F. At -175, -200 and -270 F, the modulus of X3-6004 is approximately the same as GE RTV-560 and the other three silicone adhesives. The X3-6004 adhesive exhibits good processing properties. It has a 12 percent lower density than RTV-560. Although lower in overall strength properties as compared to the other adhesives in the program, X3-6004 has adequate adhesion to 2024T81 aluminum to compete as an adhesive for attaching reusable surface insulation. It does exhibit some tendency to revert and soften at temperatures above 350 F when in a confined area.
    Keywords: MATERIALS, NONMETALLIC
    Type: NASA-CR-128888
    Format: application/pdf
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 4
    Publication Date: 2019-07-13
    Description: Results are presented from tests to establish design allowables data for the following room temperature vulcanizing (RTV) silicone rubber based adhesives: (1) General Electric's RTV-560; (2) Dow Corning's 93-046; and (3) Martin Marietta's SLA-561. These adhesives are being evaluated for attaching reusable surface insulation to space shuttle structure.
    Keywords: MATERIALS, NONMETALLIC
    Type: NASA-CR-128887
    Format: application/pdf
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
Close ⊗
This website uses cookies and the analysis tool Matomo. More information can be found here...