ALBERT

All Library Books, journals and Electronic Records Telegrafenberg

X
feed icon rss

Your email was sent successfully. Check your inbox.

An error occurred while sending the email. Please try again.

Proceed reservation?

Export
  • 1
    Electronic Resource
    Electronic Resource
    Biocatalytic synthesis of polymers. II. Preparation of [AA-BB]x polyesters by porcine pancreatic lipase catalyzed transesterification in anhydrous, low polarity organic solvents (1989)
    Bognor Regis [u.a.] : Wiley-Blackwell
    Journal of Polymer Science Part A: Polymer Chemistry 27 (1989), S. 3271-3284 
    Details
    ISSN: 0887-624X
    Keywords: Chemistry ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology
    Notes: Enzyme-catalyzed preparation of polymers offers several potentially valuable advantages over the usual polymerization procedures. (1) Such polymerizations may allow the polymer to retain functionality that would be destroyed under normal polymerization conditions. (2) The selectivity provided by enzyme catalysts may permit polymers, including optically active polymers, to be prepared that are either not accessible or accessible only with difficulty by other methods. (3) The characteristics of the enzyme and the mild polymerization conditions may permit formation of polymers having highly regular sizes and backbone structures. This report describes the first successful use of an enzyme-catalyzed polycondensation to prepare a chiral (AA-BB)x polyesters of more than a few repeat units. Polymerization of bis(2,2,2-trichloroethyl) alkanedioates (BB) with diols (AA) using the enzyme porcine pancreatic lipase (PPL) as a catalyst is detailed. The polycondensations were carried out at ambient temperature in anhydrous, low polarity organic solvents such as ether, THF, and methylene chloride. End group analysis by NMR provided Mn values of 1300-8200 daltons while GPC provided Mw values of 2800-14900 daltons for the polymers. Based on proton NMR spectra obtained during the polymerization, relatively rapid formation of an AA-BB “dimer” and an AA-BB-AA “trimer,” slower formation of a BB-AA-BB “trimer,” and subsequent condensation of these to give higher polymers are suggested to be components of the polymerization mechanism.
    Additional Material: 2 Ill.
    Type of Medium: Electronic Resource
    URL: http://dx.doi.org/10.1002/pola.1989.080271008
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
    Paper (German National Licenses)
    Fulltext
  • 2
    Electronic Resource
    Electronic Resource
    Biocatalytic synthesis of polymers. Synthesis of an optically active, epoxy-substituted polyester by lipase-catalyzed polymerization (1989)
    Bognor Regis [u.a.] : Wiley-Blackwell
    Journal of Polymer Science Part A: Polymer Chemistry 27 (1989), S. 2553-2567 
    Details
    ISSN: 0887-624X
    Keywords: Chemistry ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology
    Notes: The enantioselective polymerization of bis(2,2,2-trichloroethyl) trans-3,4-epoxyadipate with 1,4-butanediol using the enzyme porcine pancreatic lipase as a catalyst is described. The polymerization was carried out at ambient temperature in anhydrous ethyl ether. End group analysis provided MN = 5,300 daltons, whereas GPC provided Mw = 7,900 daltons for the polymer. The unchanged (+)-enantiomer of the diester was shown to have an enantiomeric purity of 〉 95% by proton NMR in the presence of the chiral shift reagent Eu(hfc)3. The stereochemical purity of the (-)-polymer was estimated at 〉 96% by consideration of the amount of the slower reacting enantiomer that could have been incorporated and still attain the observed degree of polymerization (25) when the starting ratio of racemic diester to diol was 2:1. Direct determination of the stereochemical purity of the polymer using Eu(hfc)3 was unsuccessful. Similar studies on polymer having random stereochemical orientations of the epoxide showed that such polymers do not behave as if they are racemic in the presence of the shift reagent. The polymer required for the latter studies was prepared by epoxidation of the product from enzyme catalyzed polymerization of bis(2,2,2-trichloroethyl) trans-3-hexenedioate with 1,4-butanediol.
    Additional Material: 2 Ill.
    Type of Medium: Electronic Resource
    URL: http://dx.doi.org/10.1002/pola.1989.080270807
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
    Paper (German National Licenses)
    Fulltext
  • 3
    Electronic Resource
    Electronic Resource
    The Structures of the Frenatin Peptides from the Skin Secretion of the Giant Tree Frog Litoria Infrafrenata (1996)
    New York, NY [u.a.] : Wiley-Blackwell
    Journal of Peptide Science 2 (1996), S. 117-124 
    Details
    ISSN: 1075-2617
    Keywords: peptides ; neuropeptide ; antimicrobial agent ; skin secretion ; frogs ; Chemistry ; Biochemistry
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology
    Notes: The granular dorsal glands of the giant tree frog Litoria infrafrenata contain five peptides including caerulein (a known neuropeptide), and four new peptides named frenatins 1 (MH+ = 1140 Da), 2 (1423), 3 (2180) and 4 (2493). The amino acid sequences of the frenatins are detailed: their structures do not correspond to those of peptides isolated from other amphibians or animals. Frenatin 3, Gly-Leu-Met-Ser-Val-Leu-Gly-His-Ala-Val-Gly-Asn-Val-Leu-Gly- Gly-Leu-Phe-Lys-Pro-Lys-Ser-(OH), has wide spectrum antimicrobial properties.
    Additional Material: 6 Ill.
    Type of Medium: Electronic Resource
    URL: http://dx.doi.org/10.1002/psc.60
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
    Paper (German National Licenses)
    Fulltext
  • 4
    Electronic Resource
    Electronic Resource
    Cold compaction molding and sintering of polystyrene (1976)
    Stamford, Conn. [u.a.] : Wiley-Blackwell
    Polymer Engineering and Science 16 (1976), S. 529-536 
    Details
    ISSN: 0032-3888
    Keywords: Chemistry ; Chemical Engineering
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics , Physics
    Notes: It is the objective of this paper to demonstrate the applicability of cold compaction molding followed by a sintering treatment to the processing of polystyrene powders. The influence of pressure, compaction speed, and peak pressure dwell time on the green (as compacted) density and the green tensile strength, as well as the effect of sintering on the tensile strength and dimensional change, were evaluated. The resulting data indicate that room temperature compaction alone is insufficient to provide adequate tensile strength for the compacts. Sintering the green compacts at temperatures of 150 to 173°C markedly improves the tensile strength while simultaneously causing a thickness change in the compacts. This thickness change results from gas evolution, pore shrinkage, and viscoelastic recovery of the residual stresses induced by pressure. For compacts of 0.225 in. thickness, an optimum sintering treatment of 173°C for 30 mins is recommended to provide a tensile strength of 4,000 psi and a thickness change of less than + 7 percent. Coining (repressing) the green compacts does not appreciably affect the sintered strength. However, a finer particle size improves the sintered properties. A review of the literature on the flow behavior of polystyrene suggests that a non-Newtonian viscous flow mechanism is followed by a Newtonian one as sintering progresses.
    Additional Material: 13 Ill.
    Type of Medium: Electronic Resource
    URL: http://dx.doi.org/10.1002/pen.760160802
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
    Paper (German National Licenses)
    Fulltext
  • 5
    Electronic Resource
    Electronic Resource
    Cold compaction molding and sintering of ultra high molecular weight polyethylene (1980)
    Stamford, Conn. [u.a.] : Wiley-Blackwell
    Polymer Engineering and Science 20 (1980), S. 747-755 
    Details
    ISSN: 0032-3888
    Keywords: Chemistry ; Chemical Engineering
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics , Physics
    Notes: Cold Compaction Molding and Sintering of Ultra High Molecular Weight Polyethylene (UHMWPE) has been examined as a function of particle size, sintering time and temperature, and cooling rate. Properties nearly equivalent to those obtained by compression molding can be obtained from samples with a fibrous particle morphology, sintered just above the melting point, with further improvement possible by control of particle size and addition of fine particles of normal molecular weight linear polyethylene. UHMWPE with a nodular particle morphology sintered poorly.
    Additional Material: 12 Ill.
    Type of Medium: Electronic Resource
    URL: http://dx.doi.org/10.1002/pen.760201109
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
    Paper (German National Licenses)
    Fulltext
  • 6
    Electronic Resource
    Electronic Resource
    The relationship between the insulin content and inhibitory effects of bovine colostrum on protein breakdown in cultured cells (1982)
    New York, NY [u.a.] : Wiley-Blackwell
    Journal of Cellular Physiology 110 (1982), S. 249-254 
    Details
    ISSN: 0021-9541
    Keywords: Life and Medical Sciences ; Cell & Developmental Biology
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Biology , Medicine
    Notes: Protein degradation in ten mammalian cell lines is markedly inhibited by small amounts of bovine colostrum. This response is consistent with the growth-promoting activity of colostrum that has been reported previously. Fractionation of colostrum on DEAE cellulose showed that most of the inhibitory activity against protein breakdown in H35 cells coeluted with insulin. Insulin concentrations in different batches of bovine colostrum ranged from 0.67 nM to 5.7 nM, approximately 100-fold higher than in blood. The sensitivity of protein breakdown in H35 or MH1C1 hepatoma lines to these colostrum samples was proportional to their insulin concentrations and could largely be accounted for by the amount of insulin present. Removal of insulin from colostrum by means of a protein A-anti-insulin antibody affinity column was accompanied by a loss of the ability of colostrum to inhibit protein breakdown in H35 or MH1C1 cells. However, in IMR90 fibroblasts, a cell line with a similar sensitivity to colostrum as the two hepatomas but very insensitive to insulin, protein breakdown was still inhibited by the insulin-free colostrum. These results suggest that, whereas the effect of bovine colostrum in H35 or MH1C1 cells is actually a response to insulin, different growth factors in colostrum account for the inhibition of protein breakdown in other cell lines.
    Additional Material: 2 Ill.
    Type of Medium: Electronic Resource
    URL: http://dx.doi.org/10.1002/jcp.1041100305
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
    Paper (German National Licenses)
    Fulltext
  • 7
    Electronic Resource
    Electronic Resource
    A novel technique for measuring solute diffusivities in entrapment matrices used in immobilization (1987)
    New York, NY [u.a.] : Wiley-Blackwell
    Biotechnology and Bioengineering 30 (1987), S. 936-945 
    Details
    ISSN: 0006-3592
    Keywords: Chemistry ; Biochemistry and Biotechnology
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Biology , Process Engineering, Biotechnology, Nutrition Technology
    Notes: A novel technique has been developed for measuring effective solute diffusivities in entrapment matrices used for cell immobilization. In this technique radiotracers were used to measure effective diffusivities and equilibrium partition coefficients of the solute between the liquid and solid matrix. Ca-alginate was used in this study, because it is one of the most commonly employed matrices for the immobilization of microbial, plant and mammalian cells. The experimental apparatus consisted of a single spherical Ca-alginate bead which was attached to a rotating rod and immersed in water containing C14-glucose. The rotational speed of the spherical bead was controlled and resulted in excellent mixing, and negligible external film mass transfer resistance, which allowed the measurement of true effective solute diffusivity within the solid matrix. The rates of C14-glucose diffusion within the Ca-alginate sphere were measured using a scintillation spectrometer. A mathematical model of unsteady-state diffusion in a sphere was used with appropriate boundary conditions, and the effective diffusivity of glucose was found from the best fit of the experimental data using a computer regression analysis method. Using 2% (w/v) Ca-alginate beads in this new radiotracer technique the effective diffusivity and partition coefficient of glucose were found to be 6.62 × 10-10 m2/s and 0.98, respectively. The accuracy, advantages, and simplicity of this new method for diffusivity measurements are also compared to other existing methods.
    Additional Material: 6 Ill.
    Type of Medium: Electronic Resource
    URL: http://dx.doi.org/10.1002/bit.260300804
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
    Paper (German National Licenses)
    Fulltext
Close ⊗
This website uses cookies and the analysis tool Matomo. More information can be found here...