ALBERT

Description: In surface-wave analysis, S-wave velocity estimations can be improved by the use of higher modes of the surface waves. The vertical component of P-SV waves is commonly used to estimate multimode Rayleigh waves, although Rayleigh waves are also included in horizontal components of P-SV waves. To demonstrate the advantages of using the horizontal components of multimode Rayleigh waves, we investigated the characteristics of the horizontal and vertical components of Rayleigh waves. We conducted numerical modeling and field data analyses rather than a theoretical study for both components of Rayleigh waves. As a result of a simulation study, we found that the estimated higher modes have larger relative amplitudes in the vertical and horizontal components as the source depth increases. In particular, higher-order modes were observed in the horizontal component data for an explosive source located at a greater depth. Similar phenomena were observed in the field data acquired by using a dynamite source at 15-m depth. Sensitivity analyses of dispersion curves to S-wave velocity changes revealed that dispersion curves additionally estimated from the horizontal components can potentially improve S-wave velocity estimations. These results revealed that when the explosive source was buried at a greater depth, the horizontal components can complement Rayleigh waves estimated from the vertical components. Therefore, the combined use of the horizontal component data with the vertical component data would contribute to improving S-wave velocity estimations, especially in the case of buried explosive source signal.

Description: We have developed a method to analytically evaluate the relationship between the source-receiver configuration and the retrieved wavefield in seismic interferometry performed by multidimensional deconvolution (MDD). The MDD method retrieves the wavefield with the desired source-receiver configuration from the observed wavefield without source information. We used a singular-value decomposition (SVD) approach to solve the inverse problem of MDD. By introducing SVD into MDD, we obtained quantities that revealed the characteristics of the MDD inverse problem and interpreted the effect of the initial source-receiver configuration for a survey design. We numerically simulated the wavefield with a 2D model and investigated the rank of the incident field matrix of the MDD inverse problem. With a source array of identical length, a sparse and a dense source distribution resulted in an incident field matrix of the same rank and retrieved the same wavefield. Therefore, the optimum source distribution can be determined by analyzing the rank of the incident field matrix of the inverse problem. In addition, the introduction of scatterers into the model improved the source illumination and effectively increased the rank, enabling MDD to retrieve a better wavefield. We found that the ambiguity of the wavefield inferred from the model resolution matrix was a good measure of the amount of illumination of each receiver by the sources. We used the field data recorded at the two boreholes from the surface sources to support our results of the numerical modeling. We evaluated the rank of incident field matrix with the dense and sparse source distribution. We discovered that these two distributions resulted in an incident field matrix of almost the same rank and retrieved almost the same wavefield as the numerical modeling. This is crucial information for designing seismic experiments using the MDD-based approach.