ALBERT

Description: We used recordings of the M 6.8 Nisqually earthquake and its M (sub L) 3.4 aftershock to study site response and basin effects for 35 locations in Seattle, Washington. We determined site amplification from Fourier spectral ratios of the recorded horizontal ground motions, referenced to a soft-rock site. Soft-soil sites (generally National Earthquake Hazard Reduction Program [NEHRP] class E) on artificial fill and young alluvium have the largest 1-Hz amplifications (factors of 3-7) for both the mainshock and aftershock. These amplifications are correlated with areas of higher damage from the mainshock to major buildings and liquefaction. There are several indications of nonlinear response at the soft-soil sites for the mainshock ground motions, despite relatively modest peak accelerations in the S waves of 15%-22%g. First, the mainshock spectral ratios do not show amplification at 2-8 Hz as do the aftershock spectral ratios. Spectral peaks at frequencies below 2 Hz generally occur at lower frequencies for the mainshock spectral ratios than for the aftershock ratios. At one soft-soil site, there is a clear shift of the resonant frequency to a lower frequency for the mainshock compared with the aftershock. The frequency of this resonance increases in the coda of the mainshock record, indicating that the site response during the weaker motions of the coda is more linear than that of the initial S wave. Three of the soft-soil sites display cusped, one-sided mainshock accelerograms after the S wave. These soft-soil sites also show amplification at 10-20 Hz in the S wave, relative to the rock site, that is not observed for the aftershock. The cusped waveforms and 10-20-Hz amplification are symptomatic of nonlinear response at the soft-soil sites. These sites had nearby liquefaction. The largest amplifications for 0.5 Hz occur at soft-soil sites on the southern portion of the Seattle Basin. Stiff-soil sites (NEHRP classes D and C) on Pleistocence-age glacial deposits display similar spectral amplification for the mainshock and aftershock, indicating approximately linear response. The stiff-soil sites generally have moderate amplification (factors of 1.1-2.4) at 0.5 and 1 Hz. Amplifications at 1 and 5 Hz for all sites generally increase with decreasing shear-wave velocity measured in the top 30 m (V (sub s) 30). However, larger amplifications at 0.5 and 1 Hz for sites with similar V (sub s) 30 values are observed for sites in the Seattle Basin, illustrating the amplification from the deeper (〉30 m) sediments and the contribution from basin surface waves. Record sections for the mainshock and aftershock show that basin surface waves produce the peak velocities for many of the sites in the Seattle Basin and often dominate the amplitude at 1 Hz and lower frequencies.

Description: We installed a dense array of 41 digital seismographs in San Jose, California, to evaluate in detail the effects of a deep sedimentary basin and shallow sedimentary deposits on earthquake ground motions. This urban array is located near the eastern edge of the Santa Clara Valley and spans the Evergreen sedimentary basin identified by gravity data. Average station spacing is 1 km, with three stations initially spaced 110 m apart. Despite the high-noise urban environment, the stations of the array successfully triggered on and recorded small local earthquakes (M 2.5-2.8 at 10-25 km distance) and larger regional events such as the M 5.0 Bolinas earthquake (90 km distance), M 4.6-5.6 earthquakes near Mammoth Lakes (270 km distance), M 4.9-5.6 events in western Nevada (420 km distance) and the M 7.1 Hector Mine earthquake (590 km distance). Maps of spectral ratios across the array show that the highest amplitudes in all frequency bands studied (0.125-8 Hz) are generally observed at stations farther from the eastern edge of the Santa Clara Valley. Larger spectral amplitudes are often observed above the western edge of the Evergreen Basin. Snapshots of the recorded wavefield crossing the array for regional events to the east reveal that large, low-frequency (0.125-0.5 Hz) arrivals after the S-wave travel from south to north across the array. A moving-window, cross-correlation analysis finds that these later arrivals are surface waves traveling from the south. The timing and propagation direction of these arrivals indicates that they were likely produced by scattering of incident S waves at the border of the Santa Clara Valley to the south of the array. It is remarkable that the largest low-frequency phases at many of the valley sites for regional events to the east are basin surface waves coming from a direction about 70 degrees different from that of the epicenters. Basin surface waves emanating from the eastern edge of the valley are also identified by the cross-correlation analysis.

Description: We used the 3D finite-difference method to model observed seismograms of two earthquakes (M (sub L) 4.9 and 3.5) in the Seattle region and to simulate ground motions for hypothetical M 6.5 and M 5.0 earthquakes on the Seattle fault, for periods greater than 2 sec. A 3D velocity model of the Seattle Basin was constructed from studies that analyzed seismic-reflection surveys, borehole logs, and gravity and aeromagnetic data. The observations and the simulations highlight the importance of the Seattle Basin on long-period ground motions. For earthquakes occurring just south of the basin, the edge of the basin and the variation of the thickness of the Quaternary deposits in the basin produce much larger surface waves than expected from flat-layered models. The data consist of seismograms recorded by instruments deployed in Seattle by the USGS and the University of Washington (UW). The 3D simulation reproduces the peak amplitude and duration of most of the seismograms of the June 1997 Bremerton event (M (sub L) 4.9) recorded in Seattle. We found the focal mechanism for this event that best fits the observed seismograms in Seattle by combining Green's functions determined from the 3D simulations for the six fundamental moment couples. The February 1997 event (M (sub L) 3.5) to the south of the Seattle Basin exhibits a large surface-wave arrival at UW whose amplitude is matched by the synthetics in our 3D velocity model, for a source depth of 9 km. The M 6.5 simulations incorporated a fractal slip distribution on the fault plane. These simulations produced the largest ground motions in an area that includes downtown Seattle. This is mainly caused by rupture directed up dip toward downtown, radiation pattern of the source, and the turning of S waves by the velocity gradient in the Seattle basin. Another area of high ground motion is located about 13 km north of the fault and is caused by an increase in the amplitude of higher-mode Rayleigh waves caused by the thinning of the Quaternary deposits.

Description: Displacement waveforms and high-frequency acceleration envelopes from stations at distances of 3-300 km were inverted to determine the source process of the M 7.9 Denali fault earthquake. Fitting the initial portion of the displacement waveforms indicates that the earthquake started with an oblique thrust subevent (subevent #1) with an east-west-striking, north-dipping nodal plane consistent with the observed surface rupture on the Susitna Glacier fault. Inversion of the remainder of the waveforms (0.02-0.5 Hz) for moment release along the Denali and Totschunda faults shows that rupture proceeded eastward on the Denali fault, with two strike-slip subevents (numbers 2 and 3) centered about 90 and 210 km east of the hypocenter. Subevent 2 was located across from the station at PS10 (Trans-Alaska Pipeline Pump Station #10) and was very localized in space and time. Subevent 3 extended from 160 to 230 km east of the hypocenter and had the largest moment of the subevents. Based on the timing between subevent 2 and the east end of subevent 3, an average rupture velocity of 3.5 km/sec, close to the shear wave velocity at the average rupture depth, was found. However, the portion of the rupture 130-220 km east of the epicenter appears to have an effective rupture velocity of about 5.0 km/sec, which is supershear. These two subevents correspond approximately to areas of large surface offsets observed after the earthquake. Using waveforms of the M 6.7 Nenana Mountain earthquake as empirical Green's functions, the high-frequency (110 Hz) envelopes of the M 7.9 earthquake were inverted to determine the location of high-frequency energy release along the faults. The initial thrust subevent produced the largest high-frequency energy release per unit fault length. The high-frequency envelopes and acceleration spectra (〉0.5 Hz) of the M 7.9 earthquake can be simulated by chaining together rupture zones of the M 6.7 earthquake over distances from 30 to 180 km east of the hypocenter. However, the inversion indicates that there was relatively little high-frequency energy generated along the 60-km portion of the Totschunda fault on the east end of the rupture.