ALBERT

Description: Urban parks play an important role in preserving and promoting the health of citizens who are often exposed to noise pollution and the stress of daily life. The present study describes the main results obtained from a survey performed in five urban parks in Milan. Measurements of the acoustic environment were carried out in 29 sites together with interviews with 231 users on certain aspects of the parks not limited to merely sound. Acoustic data show that the surveyed parks mostly do not comply with the noise limit issued by the Italian legislation on protected areas. The unweighted 1/3-octave spectrum centre of gravity G and LA50 perform satisfactorily in discriminating among the acoustic environments. Such clear distinction was not observed in the subjective ratings on the perceived quality of the soundscape, likely due to the influence by non-acoustic factors that act as mediators in the assessment. This hypothesis is supported by the collected data on the perceived quality of quietness, which was rated worse than that of the soundscape. Comparing acoustic data with ratings, the perceived quality of the total environment was found to be less dependent on LAeq than soundscape and quietness.

Description: The search for sustainable land use has increased in Brazil due to the important role that agriculture plays in the country. Soil detailed classification is related with texture attribute. How can one discriminate the same soil class with different textures using proximal soil sensing, as to reach surveys, land use planning and increase crop productivity? This study aims to evaluate soil texture using a regional spectral library and its usefulness on classification. We collected 3750 soil samples covering 3 million ha within strong soil class variations in São Paulo State. The spectral analyses of soil samples from topsoil and subsoil were measured in laboratory (400–2500 nm). The potential of a regional soil spectral library was evaluated on the discrimination of soil texture. We considered two types of soil texture systems, one related with soil classification and another with soil managements. The soil line technique was used to assess differentiation between soil textural groups. Soil spectra were summarized by principal component analysis (PCA) to select relevant information on the spectra. Partial least squares regression (PLSR) was used to predict texture. Spectral curves indicated different shapes according to soil texture and discriminated particle size classes from clayey to sandy soils. In the visible region, differences were small because of the organic matter, while the short wave infrared (SWIR) region showed more differences; thus, soil texture variation could be differentiated by quartz. Angulation differences are on a spectral curve from NIR to SWIR. The statistical models predicted clay and sand levels with R2 = 0.93 and 0.96, respectively. Indeed, we achieved a difference of 1.2% between laboratory and spectroscopy measurement for clay. The spectral information was useful to classify Ferralsols with different texture classification. In addition, the spectra differentiated Lixisols from Ferralsols and Arenosols. This work can help the development of computer programs that allow soil texture classification and subsequent digital soil mapping at detailed scales. In addition, it complies with requirements for sustainable land use and soil management.

Description: Energy efficiency measures in buildings can provide for a significant reduction of greenhouse gas (GHG) emissions. A sustainable design and planning of technologies for energy production should be based on economic and environmental criteria. Life Cycle Assessment (LCA) is used to quantify the environmental impacts over the whole cycle of life of production plants. Optimization models can support decisions that minimize costs and negative impacts. In this work, a multi-objective decision problem is formalized that takes into account LCA calculations and that minimizes costs and GHG emissions for general buildings. A decision support system (DSS) is applied to a real case study in the Northern Italy, highlighting the advantage provided by the installation of renewable energy. Moreover, a comparison among different optimal and non optimal solution was carried out to demonstrate the effectiveness of the proposed DSS.

Description: Carbon Capture and Storage (CCS) is a very innovative and promising solution for greenhouse gases (GHG) reduction, i.e., capturing carbon dioxide (CO2) at its source and storing it indefinitely to avoid its release to the atmosphere. This paper investigates a set of key issues in the development of specific rules for the application of Life Cycle Assessment (LCA) to CCS. The following LCA-based information are addressed in this work: definition of service type, definition of functional unit, definition of system boundaries, choice of allocation rules, choice of selected Life Cycle Inventory (LCI) results or other selected parameters for description of environmental performance. From a communication perspective, the specific rules defined in this study have been developed coherently with the requirements of a type III environment label scheme, the International EPD® System, according to the ISO 14025 standard.

Description: Geosciences, Vol. 8, Pages 354: Geological Model of a Storage Complex for a CO2 Storage Operation in a Naturally-Fractured Carbonate Formation Geosciences doi: 10.3390/geosciences8090354 Authors: Yann Le Gallo José Carlos de Dios Investigation into geological storage of CO2 is underway at Hontomín (Spain). The storage reservoir is a deep saline aquifer formed by naturally fractured carbonates with low matrix permeability. Understanding the processes that are involved in CO2 migration within these formations is key to ensure safe operation and reliable plume prediction. A geological model encompassing the whole storage complex was established based upon newly-drilled and legacy wells. The matrix characteristics were mainly obtained from the newly drilled wells with a complete suite of log acquisitions, laboratory works and hydraulic tests. The model major improvement is the integration of the natural fractures. Following a methodology that was developed for naturally fractured hydrocarbon reservoirs, the advanced characterization workflow identified the main sets of fractures and their main characteristics, such as apertures, orientations, and dips. Two main sets of fracture are identified based upon their mean orientation: North-South and East-West with different fracture density for each the facies. The flow capacity of the fracture sets are calibrated on interpreted injection tests by matching their permeability and aperture at the Discrete Fracture Network scale and are subsequently upscaled to the geological model scale. A key new feature of the model is estimated permeability anisotropy induced by the fracture sets.

Description: Prosthetic joint infection (PJI) is a feared complication of total joint arthroplasty associated with increased morbidity and mortality. There is a growing body of evidence that bacterial colonization and biofilm formation are critical pathogenic events in PJI. Thus, the choice of biomaterials for implanted prostheses and their surface modifications may significantly influence the development of PJI. Currently, silver nanoparticle (AgNP) technology is receiving much interest in the field of orthopaedics for its antimicrobial properties and a strong anti-biofilm potential. The great advantage of AgNP surface modification is a minimal release of active substances into the surrounding tissue and a long period of effectiveness. As a result, a controlled release of AgNPs could ensure antibacterial protection throughout the life of the implant. Moreover, the antibacterial effect of AgNPs may be strengthened in combination with conventional antibiotics and other antimicrobial agents. Here, our main attention is devoted to general guidelines for the design of antibacterial biomaterials protected by AgNPs, its benefits, side effects and future perspectives in PJI prevention.

Description: Forests, Vol. 9, Pages 359: Pine Stand Density Influences the Regeneration of Acacia saligna Labill. H.L.Wendl. and Native Woody Species in a Mediterranean Coastal Pine Plantation Forests doi: 10.3390/f9060359 Authors: Emilio Badalamenti Rafael da Silveira Bueno Olimpia Campo Martina Gallo Donato Salvatore La Mela Veca Salvatore Pasta Giovanna Sala Tommaso La Mantia Mediterranean plantations are the most suitable areas to assess vegetation dynamics and competitive interactions between native and exotic woody species. Our research was carried out in a coastal pine plantation (Sicily) where renaturalization by native species (Pistacia lentiscus L. and Olea europaea var. sylvestris) and invasion by Acacia saligna (Labill.) H.L.Wendl. simultaneously occur. The regeneration pattern of woody species in the pine understory was evaluated in six experimental plots along a stand density gradient, from 200 to approximately 700 pines per hectare. Both pine stand density and regeneration by native species had a significant negative relationship with Acacia natural regeneration. Olea regeneration was positively correlated with stand density, while Pistacia showed a non-significant relationship. Saplings of both native species were mostly less than 1 m high, whereas approximately 70% of Acacia individuals were higher than 1 m. We found that 400 pines per hectare should be considered a minimum stand density to keep Acacia under control, while favouring the establishment of native species in the understory. The successful control of Acacia requires an integrated management strategy, including different forest interventions according to stand density: thinning, control measures against Acacia, and renaturalization actions.

Description: Energies, Vol. 10, Pages 2063: Performance Evaluation and Durability Enhancement of FEP-Based Gas Diffusion Media for PEM Fuel Cells Energies doi: 10.3390/en10122063 Authors: Saverio Latorrata Paola Gallo Stampino Cinzia Cristiani Giovanni Dotelli Nowadays, micro-porous layers (MPLs) for polymer electrolyte membrane fuel cells (PEMFCs) are commonly deposited onto gas diffusion layer (GDL) substrates starting from hydrophobic carbon-based dispersions. In this work, different quantities of fluorinated ethylene propylene (FEP), a fluorinated copolymer proven to be superior to polytetrafluoroethylene (PTFE) for a proper water management, were used to make both GDL and MPL hydrophobic. After the identification of the optimal amount of FEP, carboxymethylcellulose (CMC) was also added to gas diffusion media (GDM) to reduce overall ohmic resistance of the whole device and adhesion of MPLs to GDLs. Ex-situ chemical and mechanical accelerated stress tests (ASTs) were carried out to accelerate degradation of materials aiming to assess their durability. The highest quantity of FEP in GDMs led to the best electrochemical and diffusive properties. The presence of CMC allowed reducing overall ohmic resistance due to a better electrolyte hydration. A satisfactory durability was proven since the fundamental properties related to gas diffusion medium, such as wettability, ohmic and mass transport resistances, revealed to be quasi-stable upon ASTs.

Description: IJERPH, Vol. 15, Pages 41: Selection of a Very Active Microbial Community for the Coupled Treatment of Tetramethylammonium Hydroxide and Photoresist in Aqueous Solutions International Journal of Environmental Research and Public Health doi: 10.3390/ijerph15010041 Authors: Giulio Moretti Federica Matteucci Matteo Saraullo Francesco Vegliò Maddalena del Gallo Aerobic treatment of wastewater containing Tetramethylammonium hydroxide (TMAH) and photoresist was investigated using a lab scale reactor inoculated with activated sludge coming from urban wastewater treatment that never received TMAH before. The consumption of TMAH was monitored by liquid ion chromatography. Biodiversity indices were calculated from Denaturing Gradient Gel Electrophoresis (DGGE) bands distribution and used to estimate changes in community composition related to adaptation to the new feeding compound. The first week of adaptation was crucial, and it was analyzed in detail: many organisms died, and the microbial community suffered a great shock. TMAH levels remained constant through the first four days, and then suddenly dropped to undetectable, and at the same time NH4+ increased. When the community showed complete adaptation, predominant groups of bacteria were obtained by the Illumina sequencing of 16s rDNA amplicons, to provide insights on ecology of the adapted community, focusing on the main actors of TMAH abatement. Richness of species (Rr) peaks suggest that the development of TMAH-consuming bacteria leads to persistent consortia that maintain toxicity resistance over time. This showed adaptation and changes of the population to the different feeding conditions, and it opens new perspectives in the in situ treatment of these important residues of industrial processes without relying on external processing plants.

Description: IJERPH, Vol. 15, Pages 49: Impact of Interprofessional Relationships from Nurses’ Perspective on the Decision-Making Capacity of Patients in a Clinical Setting International Journal of Environmental Research and Public Health doi: 10.3390/ijerph15010049 Authors: Jesús Molina-Mula Julia Gallo-Estrada Catalina Perelló-Campaner Interprofessional relationships may impact the decision making of patients in a clinical setting. The objective of this study was to analyse the decision-making capabilities of patients from nurses’ perspectives of interprofessional relationships using Foucauldian ethics. This qualitative study was based on poststructuralist Foucault references with in-depth interviews of nurses working in internal medicine and specialties in a general hospital. The patients constantly appeared in the definition of teamwork, but also as a passive element used by every professional to communicate with others. Nurses continue modelling a type of patient passivity, or what Foucault called passive subjectivity in relation to oneself, because the patient is guided and directed to take charge of a truth provided by professionals. Nurses must break the rigid design of sections or professional skills, and adopt a model of teamwork that meets the needs of the patient and increases their decision-making power. The quality of care will increase to the extent that professionals establish a relationship of equality with the patient, allowing the patient to make real decisions about their care. An egalitarian model of teamwork is beneficial to the patient, abandoning the idea of a team where the patient and family are constantly excluded from decisions about their care.