ALBERT

Description: The Mw = 9.3 Sumatra earthquake of 26 December 2004 generated a tsunami that affected the entire Indian Ocean region and caused approximately 230 000 fatalities. In the response to this tragedy the German government funded the German Indonesian Tsunami Early Warning System (GITEWS) Project. The task of the GEOFON group of GFZ Potsdam was to develop and implement the seismological component. In this paper we describe the concept of the GITEWS earthquake monitoring system and report on its present status. The major challenge for earthquake monitoring within a tsunami warning system is to deliver rapid information about location, depth, size and possibly other source parameters. This is particularly true for coast lines adjacent to the potential source areas such as the Sunda trench where these parameters are required within a few minutes after the event in order to be able to warn the population before the potential tsunami hits the neighbouring coastal areas. Therefore, the key for a seismic monitoring system with short warning times adequate for Indonesia is a dense real-time seismic network across Indonesia with densifications close to the Sunda trench. A substantial number of supplementary stations in other Indian Ocean rim countries are added to strengthen the teleseismic monitoring capabilities. The installation of the new GITEWS seismic network – consisting of 31 combined broadband and strong motion stations – out of these 21 stations in Indonesia – is almost completed. The real-time data collection is using a private VSAT communication system with hubs in Jakarta and Vienna. In addition, all available seismic real-time data from the other seismic networks in Indonesia and other Indian Ocean rim countries are acquired also directly by VSAT or by Internet at the Indonesian Tsunami Warning Centre in Jakarta and the resulting "virtual" network of more than 230 stations can jointly be used for seismic data processing. The seismological processing software as part of the GITEWS tsunami control centre is an enhanced version of the widely used SeisComP software and the well established GEOFON earthquake information system operated at GFZ in Potsdam (http://geofon.gfz-potsdam.de/db/eqinfo.php). This recently developed software package (SeisComP3) is reliable, fast and can provide fully automatic earthquake location and magnitude estimates. It uses innovative visualization tools, offers the possibility for manual correction and re-calculation, flexible configuration, support for distributed processing and data and parameter exchange with external monitoring systems. SeisComP3 is not only used for tsunami warning in Indonesia but also in most other Tsunami Warning Centres in the Indian Ocean and Euro-Med regions and in many seismic services worldwide.

Description: The increasingly dense coverage of Europe with broad-band seismic stations makes it possible to image its lithospheric structure in great detail, provided that structural information can be extracted effectively from the very large volumes of data. We develop an automated technique for the measurement of interstation phase velocities of (earthquake-excited) fundamental-mode surface waves in very broad period ranges. We then apply the technique to all available broad-band data from permanent and temporary networks across Europe. In a new implementation of the classical two-station method, Rayleigh and Love dispersion curves are determined by cross-correlation of seismograms from a pair of stations. An elaborate filtering and windowing scheme is employed to enhance the target signal and makes possible a significantly broader frequency band of the measurements, compared to previous implementations of the method. The selection of acceptable phase-velocity measurements for each event is performed in the frequency domain, based on a number of fine-tuned quality criteria including a smoothness requirement. Between 5 and 3000 single-event dispersion measurements are averaged per interstation path in order to obtain robust, broad-band dispersion curves with error estimates. In total, around 63,000 Rayleigh- and 27,500 Love-wave dispersion curves between 10 and 350 s have been determined, with standard deviations lower than 2 per cent and standard errors lower than 0.5 per cent. Comparisons of phase-velocity measurements using events at opposite backazimuths and the examination of the variance of the phase-velocity curves are parts of the quality control. With the automated procedure, large data sets can be consistently and repeatedly measured using varying selection parameters. Comparison of average interstation dispersion curves obtained with different degrees of smoothness shows that rough perturbations do not systematically bias the average dispersion measurement. They can, therefore, be treated as random but they do need to be removed in order to reduce random errors of the measurements. Using our large new data set, we construct phase-velocity maps for central and northern Europe. According to checkerboard tests, the lateral resolution in central Europe is ≤150 km. Comparison of regional surface-wave tomography with independent data on sediment thickness in North-German Basin and Polish Trough confirms the high-resolution potential of our phase-velocity measurements. At longer periods, the structure of the lithosphere and asthenosphere around the Trans-European Suture Zone (TESZ) is seen clearly. The region of the Tornquist-Teisseyre-Zone in the southeast is associated with a stronger lateral contrast in lithospheric thickness, across the TESZ compared to the region across the Sorgenfrei-Tornquist-Zone in the northwest.