ALBERT

Description: Environmental Science & Technology DOI: 10.1021/es401171h

Description: Elastic and polarization lidar was used to measure the vertical profiles of aerosol backscattering coefficients at wavelengths of 355, 532, 735, and 1064 nm, and the depolarization ratio at 532 nm in order to study the aerosol properties in the free troposphere over Tsukuba, Japan, in 2006. An elevated dust layer was observed at altitudes between 3 and 8.5 km on 1 April during the Asian dust period. The wavelength exponents of the aerosol backscattering coefficient (k) were –0.1 to 0.5, and the depolarization ratio (δp) was 25% for the dust layer, suggesting the predominance of supermicrometer-sized (coarse mode) nonspherical particles. An aerosol layer observed at altitudes between 1.5 and 5 km on 19 October during the less-dust period exhibited the values of k=1.0 to 1.6 and δp=1 to 13%, suggesting the predominance of submicrometer-sized (fine mode) particles. In those layers, the values of k and δp varied with height; they were also negatively correlated, suggesting that the proportion of the coarse nonspherical particles to total particles varied. The particle size distributions estimated from the observed values and the theoretical computation revealed number mode radii of 0.3 &mum; for the coarse mode and 0.1 &mum; for the fine mode, assuming bimodal distribution. These results were consistent with those obtained from the sky-radiometer measurements, although they revealed another mode in the larger radius. The column volume concentration derived from the lidar was 48% lower than that derived from the sky-radiometer on 1 April and 16% lower on 19 October. The optical thickness derived from the lidar was 12% lower than that obtained from the sky-radiometer on 1 April and 29% higher on 19 October. Further case study is necessary to validate the method for estimating aerosol properties based on the lidar measurement.

Description: Anthropogenic radionuclides were released into the environment in large quantities by the Fukushima Daiichi Nuclear Power Plant (1FNPP) accident. To evaluate accident-derived 129I, the 129I concentrations in seawater before and after the accident were compared. Before the accident (2009–2010), the 129I concentrations in the western margin of the North Pacific between 36° N and 44° N showed a atitudinal gradient that was expressed as a linear function of latitude. The highest and average 129I concentrations after the accident were 73 times and approximately 8 times, respectively, higher than those before the accident in this study area. Considering the distribution of 129I in surface seawater, the accident-derived 129I in the southern and northern stations of the 1FNPP was predominantly supplied by seawater advection and atmospheric deposition, respectively. As of October 2011, depth profiles of 129I revealed that 129I originating from the 1FNPP existed mainly in the upper 100 m depth. From the depth profiles, the cumulative inventories of accident-derived 129I were estimated to be (1.8–9.9) × 1012 atoms m−2 in this study area. On the basis of the 129I data in the seawater near Fukushima, the effective dose of 129I from seafood ingestion was much smaller than the annual dose limit.

Description: Temporal variations in the amount of radionuclides released into the atmosphere during the Fukushima Dai-ichi Nuclear Power Station (FNPS1) accident and their atmospheric and marine dispersion are essential to evaluate the environmental impacts and resultant radiological doses to the public. In this paper, we estimate a detailed time trend of atmospheric releases during the accident by combining environmental monitoring data with atmospheric model simulations from WSPEEDI-II (Worldwide version of System for Prediction of Environmental Emergency Dose Information), and simulations from the oceanic dispersion model SEA-GEARN-FDM, both developed by the authors. A sophisticated deposition scheme, which deals with dry and fogwater depositions, cloud condensation nuclei (CCN) activation and subsequent wet scavenging due to mixed-phase cloud microphysics (in-cloud scavenging) for radioactive iodine gas (I2 and CH3I) and other particles (CsI, Cs, and Te), was incorporated into WSPEEDI-II to improve the surface deposition calculations. The fallout to the ocean surface calculated by WSPEEDI-II was used as input data for the SEA-GEARN-FDM calculations. Reverse and inverse source-term estimation methods based on coupling the simulations from both models was adopted using air dose rates and concentrations, and sea surface concentrations. The results revealed that the major releases of radionuclides due to FNPS1 accident occurred in the following periods during March 2011: the afternoon of 12 March due to the wet venting and hydrogen explosion at Unit 1, the morning of 13 March after the venting event at Unit 3, midnight of 14 March when the SRV (Safely Relief Valve) at Unit 2 was opened three times, the morning and night of 15 March, and the morning of 16 March. According to the simulation results, the highest radioactive contamination areas around FNPS1 were created from 15 to 16 March by complicated interactions among rainfall, plume movements, and the temporal variation of release rates associated with reactor pressure changes in Units 2 and 3. The modified WSPEEDI-II simulation using the new source term reproduced local and regional patterns of cumulative surface deposition of total 131I and 137Cs and air dose rate obtained by airborne surveys. The new source term was also tested using three atmospheric dispersion models (MLDP0, HYSPLIT, and NAME) for regional and global calculations and showed good agreement between calculated and observed air concentration and surface deposition of 137Cs in East Japan. Moreover, HYSPLIT model using the new source term also reproduced the plume arrivals at several countries abroad showing a good correlation with measured air concentration data. A large part of deposition pattern of total 131I and 137Cs in East Japan was explained by in-cloud particulate scavenging. However, for the regional scale contaminated areas, there were large uncertainties due to the overestimation of rainfall amounts and the underestimation of fogwater and drizzle depositions. The computations showed that approximately 27% of 137Cs discharged from FNPS1 deposited to the land in East Japan, mostly in forest areas.

Description: Anthropogenic radionuclides were released into the environment in large quantities by the Fukushima Daiichi Nuclear Power Plant (1FNPP) accident. To evaluate accident-derived 129I, the 129I concentrations in seawater before and after the accident were compared. Before the accident (2008–2009), the 129I concentrations in the western margin of the North Pacific between 32° N and 44° N showed a latitudinal gradient that was expressed as a linear function of latitude. The highest and average 129I concentrations after the accident were 73 times and approximately 8 times, respectively, higher than those before the accident in this study area. Considering the distribution of 129I in surface seawater, the accident-derived 129I in the southern and northern stations of the 1FNPP was predominantly supplied by seawater advection and atmospheric deposition (including microbial volatilization), respectively. As of October 2011, depth profiles of 129I revealed that 129I originating from the 1FNPP existed mainly in the upper 100 m depth. From the depth profiles, the cumulative inventories of accident-derived 129I were estimated to be (1.6–9.6) × 1012 atoms m−2 in this study area. On the basis of the 129I data in the seawater near Fukushima, the effective dose of 129I from seafood ingestion was much smaller than the annual dose limit.

Description: A method for forecasting very short-term rainfall to detect potentially hazardous convective cloud that produces heavy local rainfall was developed using actual volumetric C-band polarimetric radar data. Because the rainfall estimation algorithm used in this method removed the effect of ice particles based on polarimetric measurements, it was immune to the high reflectivity associated with hail. The reliability of the algorithm was confirmed by comparing the rainfall rate estimated from the polarimetric radar measurements at the lowest elevation angle with that obtained from optical disdrometers on the ground. The rainfall rate estimated from polarimetric data agreed well with the results obtained from the disdrometers, and was much more reliable than results derived from reflectivity alone. Two small cumulus cells were analyzed, one of which developed and later produced heavy rainfall, whereas the other did not. Observations made by polarimetric radar with a volumetric scan revealed that a high vertical maximum intensity of rainfall rate and a vertical area of enhanced differential reflectivity extending above the freezing level, often termed a high ZDR column, were clearly formed about 10 min prior to the onset of heavy rainfall on the ground. The onset time of the heavy rainfall could be estimated in advance from the polarimetric data, which agreed fairly well with observations. These polarimetric characteristics were not observed for the cumulus cell that did not produce heavy rainfall. The results suggest that both the vertical maximum intensity of the rainfall rate and a high ZDR column, estimated from polarimetric measurements, can be used to identify potentially hazardous clouds. Furthermore, this study shows that polarimetric radar measurements with high spatial and temporal resolutions are invaluable for disaster reduction.

Description: Observations from a wind profiler and a meteorological tower are utilized to study the evolution of a gravity current that passed over the Meteorological Research Institute's (MRI) field site in Tsukuba, Japan. The gravity current was created by katabatic flow originating on the mountainous slopes west of the field site. The passage of the shallow current was marked by a pronounced pressure disturbance and was accompanied by vertical circulations seen in the tower and profiler data. Direct vertical-beam measurements are difficult, especially at low heights during high-gradient events like density currents. In this study vertical velocities from the profiler are derived from the four oblique beams by use of the Minimizing the Variance of the Differences (MVD) method. The vertical velocities derived from the MVD method agree well with in situ vertical velocities measured by a sonic anemometer on the tower. The gravity current is analyzed with surface observations, the wind profiler/RASS and tower-mounted instruments. Observations from the profiler/RASS and the tower-mounted instruments illustrate the structure of the gravity current in both wind and temperature fields. The profiler data reveal that there were three regions of waves in the vertical velocity field: lee-type waves, a solitary wave and Kelvin-Helmholtz waves. The lee-type waves in the head region of the gravity current seem to have been generated by the gravity current acting as an obstacle to prefrontal flow. The solitary wave was formed from the elevated head of the gravity current that separated from the feeder flow. Profiler vertical-motion observations resolve this wave and enable us to classify it as a Benjamin-Davis-Ono (BDO) type solitary wave. The ducting mechanism that enabled the solitary wave to propagate is also revealed from the wind profiler/RASS measurements. The combination of high-resolution instruments at the MRI site allow us to develop a uniquely detailed picture of a shallow gravity current structure.

Description: Temporal variations in the amount of radionuclides released into the atmosphere during the Fukushima Daiichi Nuclear Power Station (FNPS1) accident and their atmospheric and marine dispersion are essential to evaluate the environmental impacts and resultant radiological doses to the public. In this paper, we estimate the detailed atmospheric releases during the accident using a reverse estimation method which calculates the release rates of radionuclides by comparing measurements of air concentration of a radionuclide or its dose rate in the environment with the ones calculated by atmospheric and oceanic transport, dispersion and deposition models. The atmospheric and oceanic models used are WSPEEDI-II (Worldwide version of System for Prediction of Environmental Emergency Dose Information) and SEA-GEARN-FDM (Finite difference oceanic dispersion model), both developed by the authors. A sophisticated deposition scheme, which deals with dry and fog-water depositions, cloud condensation nuclei (CCN) activation, and subsequent wet scavenging due to mixed-phase cloud microphysics (in-cloud scavenging) for radioactive iodine gas (I2 and CH3I) and other particles (CsI, Cs, and Te), was incorporated into WSPEEDI-II to improve the surface deposition calculations. The results revealed that the major releases of radionuclides due to the FNPS1 accident occurred in the following periods during March 2011: the afternoon of 12 March due to the wet venting and hydrogen explosion at Unit 1, midnight of 14 March when the SRV (safety relief valve) was opened three times at Unit 2, the morning and night of 15 March, and the morning of 16 March. According to the simulation results, the highest radioactive contamination areas around FNPS1 were created from 15 to 16 March by complicated interactions among rainfall, plume movements, and the temporal variation of release rates. The simulation by WSPEEDI-II using the new source term reproduced the local and regional patterns of cumulative surface deposition of total 131I and 137Cs and air dose rate obtained by airborne surveys. The new source term was also tested using three atmospheric dispersion models (Modèle Lagrangien de Dispersion de Particules d'ordre zéro: MLDP0, Hybrid Single Particle Lagrangian Integrated Trajectory Model: HYSPLIT, and Met Office's Numerical Atmospheric-dispersion Modelling Environment: NAME) for regional and global calculations, and the calculated results showed good agreement with observed air concentration and surface deposition of 137Cs in eastern Japan.

Description: A method for forecasting very short-term rainfall to detect potentially hazardous convective cloud that produces heavy local rainfall was developed using actual volumetric C-band polarimetric radar data. Because the rainfall estimation algorithm used in this method removed the effect of ice particles based on polarimetric measurements, it was immune to the high reflectivity associated with hail. The reliability of the algorithm was confirmed by comparing the rainfall rate estimated from the polarimetric radar measurements at the lowest elevation angle with that obtained from an optical disdrometer on the ground. The rainfall rate estimated from polarimetric data agreed well with the results obtained from the disdrometer, and was much more reliable than results derived from reflectivity alone. Two small cumulus cells were analyzed, one of which developed and later produced heavy rainfall, whereas the other did not. Observations made by polarimetric radar with a volumetric scan revealed that a high vertical maximum intensity of rainfall rate and a vertical area of enhanced differential reflectivity extending above the freezing level, often termed a high ZDR column, were clearly formed about 10 min prior to the onset of heavy rainfall on the ground. The onset time of the heavy rainfall could be estimated in advance from the polarimetric data, which agreed fairly well with observations. These polarimetric characteristics were not observed for the cumulus cell that did not produce heavy rainfall. The results suggest that both the vertical maximum intensity of the rainfall rate and a high ZDR column, estimated from polarimetric measurements, can be used to identify potentially hazardous clouds. Furthermore, this study shows that polarimetric radar measurements with high spatial and temporal resolutions are invaluable for disaster reduction.