ALBERT

All Library Books, journals and Electronic Records Telegrafenberg

feed icon rss

Your email was sent successfully. Check your inbox.

An error occurred while sending the email. Please try again.

Proceed reservation?

Export
  • 1
    ISSN: 1089-7623
    Source: AIP Digital Archive
    Topics: Physics , Electrical Engineering, Measurement and Control Technology
    Notes: We have developed a fast measuring system of energy dispersive x-ray diffraction intensity. A solid state detector (SSD) has been used to measure the energy dispersive x-ray diffraction intensities. The energy resolution of SSD is almost ten times higher than that of a scintillation counter or proportional counter. For full use of SSD, a fast processing system of the signal is needed, especially when x rays from synchrotron radiation (SR) are used. When SSD is used for x rays from SR, however, we have two problems. One is that the dead time of conventional signal processing system is long, which prevents the efficient use of synchrotron radiation source. The other is that a fast data recording system is needed, because the number of data of a single diffraction spectrum is large. To solve these two problems, we have designed a new measuring system. The system consists of a personal computer and an interface board of multichannel analyzer function. The interface consists of peak hold, fast ADC, memory, add one, and DMA. (1) Improvement of the dead time. We adopted a successive approximation ADC to shorten the conversion time. The dead time is then 2 μs in the present system, which is much shorter than that of the Wilkinson ADC (about 40 μs). (2) Fast data recording. In most conventional MCA, the memory of MCA is separated from that of computer and the data are transferred between MCA and computer. In this case, the data are transferred by GP-IB or RS232C, and the data transfer time is several ten seconds. In the present system, the same memory is accessed by MCA and computer and the data transfer time is zero. This fast measuring system has already been installed at Photon Factory, KEK and utilized to measure the energy dispersive diffraction intensities. We have observed Pendellösung fringe induced by x-ray resonant scattering to make use of this system.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 2
    ISSN: 1089-7623
    Source: AIP Digital Archive
    Topics: Physics , Electrical Engineering, Measurement and Control Technology
    Notes: The carbon-fiber-reinforced plastic (CFRP) that can be used for window material in place of beryllium is a composite-type material comprising twisted carbon fibers and bisphenol-A plastic. Since the constituent elements of hydrogen, carbon, and nitrogen are thoroughly dispersed as a compound, the mass absorption coefficient of CFRP is somewhat larger than that of beryllium. The diffraction pattern of CFRP shows only a single halo pattern without a Bragg-like peak which is found in Mylar. Through x-ray diffraction, CFRP was confirmed to be practical for use as a non-Bragg window material with a moderately low mass-absorption coefficient and could be substituted for crystalline beryllium.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 3
    Electronic Resource
    Electronic Resource
    [S.l.] : American Institute of Physics (AIP)
    Review of Scientific Instruments 60 (1989), S. 1951-1952 
    ISSN: 1089-7623
    Source: AIP Digital Archive
    Topics: Physics , Electrical Engineering, Measurement and Control Technology
    Notes: A highly sensitive beam position monitor has been designed for use with synchrotron radiation sources. This beam position monitor consists of two gas-flow ionization chambers having three parallel plate conductors. The incident beam is divided by a central plate. Therefore, a displacement of the beam position is detected with the two outside ionization chambers. The position monitor was tested at the BL6Cl beamline of the Photon Factory (PF). The results show a good performance.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 4
    ISSN: 1089-7623
    Source: AIP Digital Archive
    Topics: Physics , Electrical Engineering, Measurement and Control Technology
    Notes: To assess the ability of the high-speed K-edge energy subtraction system which was made at beamline 8C of Photon Factory, Tsukuba, we performed an animal experiment. Rabbits were used for the intravenous K-edge subtraction angiography. In this paper, the actual images of the artery obtained by this system, are demonstrated. The high-speed K-edge subtraction system consisted of movable silicon (111) monocrystals, II–ITV, and digital memory system. Image processing was performed by 68000-IP computer. The monochromatic x-ray beam size was 50×60 mm. Photon energy above and below iodine K edge was changed within 16 ms and 32 frames of images were obtained sequentially. The rabbits were anaesthetized by phenobarbital and a 5F catheter was inserted into inferior vena cava via the femoral vein. 1.5 ml/kg of contrast material (Conlaxin H) was injected at the rate of 0.5 ml/kg/s. TV images were obtained 3 s after the starting point of injection. By using this system, the clear K-edge subtracted images were obtained sequentially as a conventional DSA system. The quality of the images were better than that obtained by DSA. The dynamical blood flow was analyzed, and the best arterial image could be selected from the sequential images. The structures of aortic arch, common carotid arteries, right subclavian artery, and internal thoracic artery were obtained at the chest. Both common carotid arteries and vertebral arteries were recorded at the neck. The diameter of about 0.3–0.4 mm artery could be clearly revealed. The high-speed K-edge subtraction system demonstrates the very sharp arterial images clearly and dynamically.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 5
    Electronic Resource
    Electronic Resource
    [S.l.] : American Institute of Physics (AIP)
    Journal of Applied Physics 83 (1998), S. 3379-3385 
    ISSN: 1089-7550
    Source: AIP Digital Archive
    Topics: Physics
    Notes: Laser ablation of NiO at 266 nm has been studied by measuring absorption spectra and emission spectra which are resolved both temporally and spatially. The spectra were measured at several points 1 mm apart from the laser spot and with several detection angles. Ablated species in different electronic states such as the ground state, lower lying states, and excited states are distinguished from absorption and emission spectroscopy. Time-of-flight spectra of these species and their angular dependence are obtained. It is revealed that excited Ni neutrals are generated mainly by the recombination of Ni+ ions with electrons, and Ni+ ions ejected nearly normal to the surface are exclusively excited due to multiple collisional effect. The isotropic angular dependence of most probable velocities of Ni+ ions and Ni neutrals are explained by ambipolar diffusion of the plume. The mechanism of species ejection is also discussed. © 1998 American Institute of Physics.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 6
    Electronic Resource
    Electronic Resource
    Woodbury, NY : American Institute of Physics (AIP)
    Applied Physics Letters 69 (1996), S. 1113-1115 
    ISSN: 1077-3118
    Source: AIP Digital Archive
    Topics: Physics
    Notes: Vanadium ion (V+) implantation has been successfully applied to the formation of semiinsulating 6H-SiC layers. The resistivity of V+-implanted layers strongly depended on the conduction type of initial 6H-SiC crystals. The resistivity at room temperature exceeded 1012 Ω cm and 106 Ω cm for p- and n-type samples, respectively. Compensation mechanism is discussed based on the temperature dependence of resistivity. This technique will be useful for device isolation, edge termination, and reduction of parasitic impedance of SiC devices. © 1996 American Institute of Physics.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 7
    Electronic Resource
    Electronic Resource
    College Park, Md. : American Institute of Physics (AIP)
    The Journal of Chemical Physics 84 (1986), S. 2112-2119 
    ISSN: 1089-7690
    Source: AIP Digital Archive
    Topics: Physics , Chemistry and Pharmacology
    Notes: We develop a theory of quantum beats in molecular fluorescence taking into account collision effects (such as pure dephasing due to elastic collision) without invoking the Markoff approximation. Model calculations of the time dependent fluorescence from molecules with two excited levels are performed in order to see how the non-Markoffian character in the collision process exerts influence upon the quantum beat pattern. It is suggested that if the pure dephasing between the excited states is a Markoffian "the degree of modulation of the beats'' decreases exponentially with time; if it is in the static limit the degree of modulation of the beats decreases as a Gaussian function (the non-Markoffian behavior in the quantum beats). A given case can be classified as either Markoffian or non-Markoffian, depending on the relative magnitudes of the collision duration time τc, the beat frequency ω, and the coupling strength v which is characteristic of the pure dephasing process. The Markoff approximation holds only if the condition ω〈v〈1/τc is satisfied; the non-Markoffian behavior appears in the quantum beat pattern when ω〉v, even if v2τ2c〈1 .
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 8
    Publication Date: 2016-04-12
    Description: Quantum dot arrays provide a promising platform for quantum information processing. For universal quantum simulation and computation, one central issue is to demonstrate the exhaustive controllability of quantum states. Here, we report the addressable manipulation of three single electron spins in a triple quantum dot using a technique combining electron-spin-resonance and a micro-magnet. The micro-magnet makes the local Zeeman field difference between neighboring spins much larger than the nuclear field fluctuation, which ensures the addressable driving of electron-spin-resonance by shifting the resonance condition for each spin. We observe distinct coherent Rabi oscillations for three spins in a semiconductor triple quantum dot with up to 25 MHz spin rotation frequencies. This individual manipulation over three spins enables us to arbitrarily change the magnetic spin quantum number of the three spin system, and thus to operate a triple-dot device as a three-qubit system in combination with the existing technique of exchange operations among three spins.
    Print ISSN: 0003-6951
    Electronic ISSN: 1077-3118
    Topics: Physics
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
Close ⊗
This website uses cookies and the analysis tool Matomo. More information can be found here...