ALBERT

Notes: New experimental data are presented for the thermal conductivity of ethane. The thermal conductivity has been measured with a parallel-plate method as a function of temperature along eleven different isochores so as to obtain detailed information on the enhancement of the thermal conductivity in the critical region. The experimental results appear to be consistent with a recently proposed theoretical equation that accounts for both the asymptotic and nonasymptotic critical behavior of the thermal conductivity of fluids.

Notes: We have measured the thermal conductivity of argon at temperatures from 302 K down to 150.8 K and at densities up to 25 mol L−1. The data were obtained with a steady-state method and we employed a guarded parallel-plate apparatus designed especially for investigating the thermal conductivity of fluids in the critical region. To interpret the data in the critical region a scaled crossover equation of state for argon in the critical region has been constructed. Equations for the thermal conductivity and viscosity of argon as a function of density and temperature are presented.

Notes: A description is given of the construction and operating procedure of a parallel-plate apparatus for the measurement of the thermal conductivity coefficient of fluids. This instrument can be operated at pressures up to 150 MPa and at temperatures down to 77 K. The use of platinum resistance temperature sensors allows measurements with temperature differences between upper and lower plate as small as 1 mK, which together with the small plate separation of 155 μm, makes the instrument suitable for both the normal fluid region as well as for the region very close to the critical point. The complete working equations for the instrument are presented and evaluated.

Notes: We have measured the thermal conductivity of methane at temperatures from 308 K down to 190.585 K, which is just 21 mK above the critical temperature, and at densities up to 14 mol L−1. The data were obtained with an improved guarded parallel-plate cell with a new cryostat that was built especially for measurements in the critical region of methane. The new experimental data have a higher accuracy than those reported previously in the literature and enable us to examine the validity of the currently available theoretical description of the asymptotic and nonasymptotic behavior of the thermal conductivity of fluids in the critical region. Equations for the thermal conductivity of methane in a wide range of temperatures and densities are also presented. © 1996 American Institute of Physics.

Notes: We have measured the thermal conductivity of an equimolar mixture of methane and ethane in the vicinity of the critical point. The new experimental data confirm that the thermal conductivity of a mixture does not diverge at the critical point but crosses over to a finite limiting behavior at the critical point. A quantitative representation of the thermal-conductivity data has been obtained in terms of a recently developed extension of the mode-coupling theory that incorporates the crossover between the behavior of the thermal conductivity close to and far away from the critical point. The same theory enables us also to predict other transport properties of the mixture in the vicinity of the critical point. © 1998 American Institute of Physics.

Notes: A magnetization model is presented that is used to cover trilayers containing two magnetic layers that are exchange coupled via an intermediate nonmagnetic layer and that have different crystalline anisotropies. The interfaces are coupled to the bulk by a twisted magnetization configuration which is evaluated using the Ritz method. By minimizing the total energy, experimental magnetization curves of strongly coupled Co/Ru sandwiches can be reproduced with a good precision and with the same set of parameters in two perpendicular field directions. These physical parameters can be determined with a good reliability and are in agreement with the literature except for the bulk anisotropy of the Co layer first deposited, which is twice as large as the known bulk value. This originates in the magnetoelastic contributions due to lattice misfit and interface roughness. It is shown that the interlayer exchange coupling forces the magnetization of both layers to be along the same axis in the low-field range notwithstanding the opposite sign of the anisotropy constants in most stacks. It is also demonstrated that the differences in the orientations of the moments in one Co layer are modest and depend on the various parameters. In particular, the bulk exchange constant is a decisive parameter that makes the calculated curves close to the experimental ones. © 1996 American Institute of Physics.

Notes: A significant loss in the giant magnetoresistive signal of magnetic stacks with antiferromagnetic coupling across nonmagnetic intermediate layers is caused by regions with a ferro- rather than an antiferromagnetic coupling. The impact of these ferromagnetic coupling regions extends itself into the lateral direction due to the bulk exchange coupling. The present micromagnetic model provides a tool by which a detailed quantitative evaluation of the impact of periodic arrays of parallel line defects is possible. These defects have deviating exchange-coupling constants, and/or anisotropy constants or directions, bulk exchange constants, saturation magnetization, etc., in specific regions. Previously, we developed a phenomenological model of trilayers with two magnetic films separated by a nonmagnetic interlayer that contains one such defect. This model, with a relatively small number of free parameters, allows one to trace complete hysteresis curves. A large number of mode branches reveal themselves and jumpwise transitions between these modes frequently occur along the hysteresis loops. The present micromagnetic model requires a sufficiently accurate assessment of the starting magnetization configuration in order to get a convergence of the code. In general, the micromagnetic code is not capable of overcoming the above irreversible mode conversions. The mode branches evaluated by the phenomenological model are applied to provide the micromagnetic model with appropriate starting configurations after meeting a situation of nonstability.The micromagnetic theory of Brown constitutes the basis of the present approach. The micromagnetic effective field is calculated at grid points and the torque exerted by it on the magnetic dipole is made zero at each grid side by an iteration scheme. The long ranging magnetostatic fields are given by convolution integrals and are evaluated in the Fourier space by using two-dimensional fast Fourier transforms. The single defect is micromagnetically studied by zero padding techniques. Depending on the course of the external field, two different wall regions reveal themselves, to wit, the wall core and the so-called Néel tails. These tails were not incorporated into the phenomenological model. Provided that the defects are sufficiently wide spaced, the agreement between both models is rather good in the core regions. The impact on the GMR signal, in particular of the Néel tails, will be discussed with emphasis on systems with weak interlayer coupling, e.g., the decoupled systems.