ALBERT

All Library Books, journals and Electronic Records Telegrafenberg

feed icon rss

Your email was sent successfully. Check your inbox.

An error occurred while sending the email. Please try again.

Proceed reservation?

Export
  • 1
    facet.materialart.
    Unknown
    AGU (American Geophysical Union)
    In:  Journal of Geophysical Research: Atmospheres, 101 (D2). pp. 4289-4298.
    Publication Date: 2019-09-23
    Description: A three-dimensional Monte Carlo transfer model for polarized radiation is developed and used to study three-dimensional (3-D) effects of raining clouds on the microwave brightness temperature. The backward method is combined with the forward method to treat polarization correctly within the cloud. In comparison with horizontally homogeneous clouds, two effects are observed: First, brightness temperatures from clouds are reduced in the 3-D case due to net leakage of radiation from the sidewalls of the cloud. Second, radiation which is emitted by the warm cloud and then reflected from the water surface increases the brightness temperatures of the cloud-free areas in the vicinity of the cloud. Both effects compete with each other, leading to either lower or higher overall brightness temperatures, depending on the geometry of the cloud, the satellite viewing angle, the coverage, and the position of the cloud within the field of view (FOV) of the satellite. At 37 GHz, for example, up to 10 K differences can occur for a cloud of 50% coverage. Finite homogeneous raining clouds matching the size of the FOV of the satellite show a similar relationship between rain rates and brightness temperatures (TB) as horizontally infinite clouds. Namely, an increase of TB with increasing rain rates at low rain rates, due to emission effects, is followed by a decrease due to temperature and scattering effects. For small horizontal cloud diameter, however, the 3-D brightness temperatures may show a second maximum due to the decrease of the leakage effect with increasing rain rates. At nadir, 3-D brightness temperatures are always lower than the 1-D values with differences up to 20 K for a cloud of 5-km vertical extent and a base of 1 × 1 km. To quantify the 3-D effects for more realistic cloud structures, we used results of a three-dimensional dynamic cloud model as input for the radiative transfer codes. The same 3-D effects are obtained, but the differences between 1-D and 3-D modeling are smaller. In general, most of the differences between the 1-D and 3-D results for off-nadir view angles are pure geometry effects, which can be accounted for in part by a modified 1-D model.
    Type: Article , PeerReviewed
    Format: text
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 2
    Publication Date: 2018-03-13
    Description: A radiative transfer model to compute brightness temperatures in the microwave frequency range for polar regions including sea ice, open ocean, and atmosphere has been developed and applied to sensitivity studies and retrieval algorithm development. The radiative transfer within sea ice is incorporated according to the “many layer strong fluctuation theory” of Stogryn [1986, 1987] and T. Grenfell [Winebrenner et al., 1992]. The reflectivity of the open water is computed with the three-scale model of Schrader [1995]. Both surface models supply the bistatic scattering coefficients, which define the lower boundary for the atmospheric model. The atmospheric model computes the gaseous absorption by the Liebe et al. [1993] model. Scattering by hydrometeors is determined by Mie or Rayleigh theory. Simulated brightness temperatures have been compared with special sensor microwave imager (SSM/I) observations. The comparison exhibits shortcomings of the ice model for 37 GHz. Applying a simple ad hoc correction at this frequency gives consistent comparison results within the range of observational accuracy. The simulated brightness temperatures show the strong influence of clouds and variations of wind speed over the open ocean, which will affect the sea ice retrieval even for an ice-covered ocean. Simulated brightness temperatures have been used to train a neural network algorithm for the total sea ice concentration, which accounts for these effects. Sea ice concentrations sensed from the SSM/I data using the network and the NASA sea ice algorithm show systematic differences in dependence on cloudiness.
    Type: Article , PeerReviewed
    Format: text
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 3
    facet.materialart.
    Unknown
    AGU (American Geophysical Union)
    In:  Journal of Geophysical Research: Oceans, 103 (C11). pp. 24983-24989.
    Publication Date: 2018-04-30
    Description: A Monte Carlo model is developed to calculate the microwave emissivity of the sea surface based on the Kirchhoff approximation combined with modified Fresnel coefficients. The modified Fresnel coefficient depends on the incident angle of the electromagnetic wave and the height variance of small‐scale roughness, which is an approximation to account partly for the scattering effect from small ripples. The advantage of the Monte Carlo model is its inherent capability to treat multiple scattering events. Using a two‐dimensional Gaussian distribution for the sea surface slope variability, the model is capable of simulating the azimuthal dependency of the microwave emission caused by the alignment of waves perpendicular to the wind direction. Good agreement between model calculations and measurements is obtained.
    Type: Article , PeerReviewed
    Format: text
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
Close ⊗
This website uses cookies and the analysis tool Matomo. More information can be found here...