ALBERT

Beschreibung: Downhole electrical resistivity measurements can be exploited for gas hydrate concentration estimates. However, to do so requires that several assumptions be made, in particular about in situ pore water salinity and porosity. During Integrated Ocean Drilling Program Expedition 311, electrical resistivity was measured in four boreholes along a transect across the northern Cascadia margin, offshore Vancouver Island, Canada. Logging-while-rilling and conventional wireline logging data of resistivity, density, and neutron-porosity are used together with measurements of porosity and pore water salinity of the recovered core to systematically estimate gas hydrate concentrations at these four sites. Using Ar- chie’s law, empirical parameters a and m are determined from gas hydrate–free zones by means of a Pickett plot. The in situ salinity baseline trend for each site was estimated directly from the measured pore water salinity values, as well as indirectly by calculating the trend using Archie’s law and simultaneously solving for gas hydrate saturation and in situ salinity. Results showed that the in situ salinities at Sites U1325, U1326, and U1329 were well determined from a smooth trend through the highest measured salinity values of the recovered core. Only Site U1327 exhibitsstrongly decreasing pore water salinity, reaching 22‰ at the base of the gas hydrate stability field. This regional low salinity requires special analyses to estimate gas hydrate concentration from resistivity and introduces a large uncertainty. It is suggested that the decreased salinity results largely (90%) from a deeper fresh water source with the remaining freshening being the result of dissociation of pervasive gas hydrate (~3% of the pore space). Considering estimates from density porosity to be the most accurate, gas hydrate saturations average ~9% ± 7% at Site U1326, ~10% ± 7% at Site U1325, and 11% ± 7% at Site U1327 over the entire range of gas hydrate occurrence. No significant gas hydrate is inferred at Site U1329, although small am ounts may be present just above the bottom-simulating reflector. In two localized zones at Site U1326 (60–100 mbsf [meters below seafloor]) and Site U1327 (120–150 mbsf), significantly higher gas hydrate concentrations of 〉30% of the pore space were encountered.

Beschreibung: Integrated Ocean Drilling Program Expedition 311 is based on extensive site survey data and historic research at the northern Cascadia margin since 1985. This research includes various regional geophysical surveys using a broad spectrum of seismic techniques, coring and logging by the Ocean Drilling Program Leg 146, heat flow measurements, shallow piston coring, and bottom video observations across a cold-vent field, as well as novel controlled-source electromagnetic and seafloor compliance surveying techniques. The wealth of data available allowed construction of structural cross-sections of the margin, development of models for the formation of gas hydrate in an accretionary prism, and estimation of gas hydrate and free gas concentrations. Expedition 311 established for the first time a transect of drill sites across the northern Cascadia margin to study the evolution of gas hydrate formation over the entire gas hydrate stability field of the accretionary complex. This paper reviews the tectonic framework at the northern Cascadia margin and summarizes the scientific studies that led to the drilling objectives of Expedition 311 Cascadia gas hydrate.

Beschreibung: Three arrays of ocean bottom seismographs have been deployed to study the seismicity at the northern end of the Juan de Fuca ridge system off western Canada. Nearly 100 events were located with estimated accuracies generally better than ±10 km, all lying on or near the en echalon ridge-transform fault plate boundaries as defined in this area by the magnetic anomalies, the seafloor morphology and by other geophysical data. The depths of 12 events were determined to lie between 2 and 6 km below the top of the crust. The seismograms exhibit clear P and S wave arrivals along with phases that involve P to S and sometimes S to P conversion probably at the base of the sediments beneath the instruments. The event magnitudes have been estimated from signal duration using four calibration events that were well recorded by a land station. The magnitude estimates permit the determination of rough magnitude-frequency of occurrence relations over the magnitude range of 1 to 3 that are in surprisingly good agreement with the recurrence relations for the area at larger magnitudes from 75 years of land station data. The mean P wave velocity in the uppermost mantle from the earthquake data recorded by the sea floor arrays is 7.6 km s-1 and the mean Vp/Vs ratio is 1.71 or a Poisson's ratio of 0.24.

Beschreibung: Key Points: - Fluid flow is focused along Nootka Fault traces resulting in shallow bright spots - Two seafloor mounds are the result of basaltic intrusions in the Nootka Fault zone - Gas hydrates occur at the Nootka Slope and are imaged seismically as bottom- simulating reflectors suggesting a regional heat-flow of ~80 mW/m2 along the slope Abstract Geophysical and geochemical data indicate there is abundant fluid expulsion in the Nootka fault zone (NFZ) between the Juan de Fuca and Explorer plates and the Nootka continental slope. Here we combine observations from 〉 20 years of investigations to demonstrate the nature of fluid‐flow along the NFZ, which is the seismically most active region off Vancouver Island. Seismicity reaching down to the upper mantle is linked to near‐seafloor manifestation of fluid flow through a network of faults. Along the two main fault traces, seismic reflection data imaged bright spots 100 – 300 m below seafloor that lie above changes in basement topography. The bright spots are conformable to sediment layering, show opposite‐to‐seafloor reflection polarity, and are associated with frequency‐reduction and velocity push‐down indicating the presence of gas in the sediments. Two seafloor mounds ~15 km seaward of the Nootka slope are underlain by deep, non‐conformable high amplitude reflective zones. Measurements in the water column above one mound revealed a plume of warm water, and bottom‐video observations imaged hydrothermal vent system biota. Pore fluids from a core at this mound contain predominately microbial methane (C1) with a high proportion of ethane (C2) yielding C1/C2 ratios 〈 500 indicating a possible slight contribution from a deep source. We infer the reflective zones beneath the two mounds are basaltic intrusions that create hydrothermal circulation within the overlying sediments. Across the Nootka continental slope, gas hydrate related bottom‐simulating reflectors are widespread and occur at depths indicating heat‐flow values of 80 – 90 mW/m2.