ALBERT

All Library Books, journals and Electronic Records Telegrafenberg

feed icon rss

Ihre E-Mail wurde erfolgreich gesendet. Bitte prüfen Sie Ihren Maileingang.

Leider ist ein Fehler beim E-Mail-Versand aufgetreten. Bitte versuchen Sie es erneut.

Vorgang fortführen?

Exportieren
Filter
  • Wiley-Blackwell  (175)
  • 1985-1989  (109)
  • 1975-1979  (64)
  • 1915-1919  (2)
Sammlung
Erscheinungszeitraum
Jahr
  • 1
    Digitale Medien
    Digitale Medien
    Stamford, Conn. [u.a.] : Wiley-Blackwell
    Polymer Engineering and Science 26 (1986), S. 1399-1404 
    ISSN: 0032-3888
    Schlagwort(e): Chemistry ; Chemical Engineering
    Quelle: Wiley InterScience Backfile Collection 1832-2000
    Thema: Chemie und Pharmazie , Maschinenbau , Physik
    Notizen: A new capillary rheometer incorporated in an instrumented transfer molding press has been developed. This rheometer is effective for determining the viscosity characteristics of thermoset molding compounds under both isothermal and typical molding conditions. In examples of the rheometer's utility, the power law indices of two commercial epoxy molding compounds have been determined to be approximately 0.7. Additionally it has been shown that preconditioning typical epoxy compounds at 47 percent relative humidity causes a viscosity decrease of about 40 percent owing to plasticization of the epoxy resin.
    Zusätzliches Material: 11 Ill.
    Materialart: Digitale Medien
    Standort Signatur Erwartet Verfügbarkeit
    BibTip Andere fanden auch interessant ...
  • 2
    Digitale Medien
    Digitale Medien
    New York, NY [u.a.] : Wiley-Blackwell
    Biotechnology and Bioengineering 33 (1989), S. 293-299 
    ISSN: 0006-3592
    Schlagwort(e): Chemistry ; Biochemistry and Biotechnology
    Quelle: Wiley InterScience Backfile Collection 1832-2000
    Thema: Biologie , Werkstoffwissenschaften, Fertigungsverfahren, Fertigung
    Notizen: A novel technique has been developed to immobilize plant cells. The cells are deposited on a surface of manmade fibrous material that provides for strong binding of the plant tissue biomass growing in the submerged culture. The immobilized plant cells remain fully viable. Relatively uniform biomass loadings of up to 20 mg d.w. plant cells/cm2 support material have been attained. All plant cells from the inoculum suspension became attached within the first 24-48 h depending on the support matrix configuration and hydraulic culture conditions. The advantages and scale-up potential of this technique are discussed and compared to other culturing modes.
    Zusätzliches Material: 5 Ill.
    Materialart: Digitale Medien
    Standort Signatur Erwartet Verfügbarkeit
    BibTip Andere fanden auch interessant ...
  • 3
    Digitale Medien
    Digitale Medien
    Stamford, Conn. [u.a.] : Wiley-Blackwell
    Polymer Engineering and Science 29 (1989), S. 1796-1796 
    ISSN: 0032-3888
    Schlagwort(e): Chemistry ; Chemical Engineering
    Quelle: Wiley InterScience Backfile Collection 1832-2000
    Thema: Chemie und Pharmazie , Maschinenbau , Physik
    Materialart: Digitale Medien
    Standort Signatur Erwartet Verfügbarkeit
    BibTip Andere fanden auch interessant ...
  • 4
    Digitale Medien
    Digitale Medien
    Stamford, Conn. [u.a.] : Wiley-Blackwell
    Polymer Engineering and Science 29 (1989), S. 749-761 
    ISSN: 0032-3888
    Schlagwort(e): Chemistry ; Chemical Engineering
    Quelle: Wiley InterScience Backfile Collection 1832-2000
    Thema: Chemie und Pharmazie , Maschinenbau , Physik
    Notizen: Multi-cavity transfer molding is an important process step in several electronic and photonic technologies. In some applications, uniform filling of the cavities of the mold, or mold balancing, is required. A semi-empirical flow model to predict mold filling patterns was developed. The algorithm is a one-dimensional network flow simulation that uses experimental pressure drop data to determine the volumetric flow rate through the gates and runners. A comprehensive experimental program was undertaken to determine these hydraulic resistances for different flow rates and mold geometries. A theoretical treatment is also described to compute hydraulic resistance from gate geometry. Uniform gate resistances provide unbalanced filling and higher velocities in the cavities. Balanced filling can significantly reduce the molding compound velocity and the flow induced stresses, but imperfect balancing compromises the benefits. Experimental filling patterns were obtained for two sets of gates. The agreement between the model and the experiments was satisfactory, and the discrepancies were attributed to correctable phenomena.
    Zusätzliches Material: 12 Ill.
    Materialart: Digitale Medien
    Standort Signatur Erwartet Verfügbarkeit
    BibTip Andere fanden auch interessant ...
  • 5
    Digitale Medien
    Digitale Medien
    Chichester : Wiley-Blackwell
    Biological Mass Spectrometry 14 (1987), S. 221-227 
    ISSN: 0887-6134
    Schlagwort(e): Chemistry ; Analytical Chemistry and Spectroscopy
    Quelle: Wiley InterScience Backfile Collection 1832-2000
    Thema: Chemie und Pharmazie
    Notizen: Human exposure to aromatic amines may be monitored by measuring the amount of sulfinamide adduct bound to hemoglobin. In order to develop a sensitive and selective method for measuring aromatic amines present in low concentrations the mass spectra of the pentafluoropropionamide derivatives of a series of aromatic amines were determined under various ionization conditions. With electron ionization the aromatic amine derivatives typically yield intense molecular ions with fragmentation leading to elimination of C2F5 and COC2F5. Higher molecular weight polycyclic aromatic amines, e.g., 6-aminochrysene, give prominent molecular ions as well as intense ions corresponding to M-174 (loss of CNHCOC2F5). With positive chemical ionization using methane as reagent gas the derivatives give protonated molecular ions as the base peaks, as well as the associated ions at M + 29 and M + 41. Negative ion chemical ionization yields, primarily, peaks corresponding to the loss of HF from the molecular anions. Negative ion chemical ionization with selected ion monitoring is generally more suitable than positive chemical ionization or electron ionization for the quantitative analysis of aromatic amines present in biological samples in the mid femtomolar range. Exposure of human subjects to aromatic amines was determined via basic hydrolysis of the isolated sulfinic acid amide hemoglobin adducts. Analysis of the derivatized extracts by gas chromatography/negative ion chemical ionization/mass spectrometry demonstrated the presence of aniline, ortho-, meta-, and para-toluidine, 2-naphthylamine, and 4-aminobiphenyl. The hemoglobin adduct levels of these amines in both cigarette smokers and nonsmokers were determined. The mean values of the adduct levels of ortho- and para-toluidine, 2-naphthylamine, and 4-aminobiphenyl were higher in smokers than in nonsmokers, while the mean adduct values of aniline and meta-toluidine were similar in both groups. Adducts of 2-, 3-, 4-ethylaniline, 2,3-, 2,4-, 2,5-, 2,6-dimethylaniline, and 3-aminobiphenyl have been detected in smokers' blood. 1-Aminoanthracene, 9-aminophenanthrene, and 6-aminochrysene have not been detected. GC/MS procedures were also used to determine the extent of binding of aniline-2,3,4,5,6-d5 to hemoglobin in rats administered aniline-d5.
    Zusätzliches Material: 4 Ill.
    Materialart: Digitale Medien
    Standort Signatur Erwartet Verfügbarkeit
    BibTip Andere fanden auch interessant ...
  • 6
    ISSN: 0887-6134
    Schlagwort(e): Chemistry ; Analytical Chemistry and Spectroscopy
    Quelle: Wiley InterScience Backfile Collection 1832-2000
    Thema: Chemie und Pharmazie
    Notizen: A highly sensitive (subpicomole level), structure-specific method of analysis has been developed for characterizing and quantitating the dinucleotide thymidylyl(3′ → 5′)thymidine methyl phosphotriester by desorption chemical ionization tandem mass spectrometry. The methodology can be applied to related compounds such as the parent dinucleotide and employs either positive or negative ionization mass spectra or daughter spectra. The procedure allows specification of the site of methyl attachment.
    Zusätzliches Material: 4 Ill.
    Materialart: Digitale Medien
    Standort Signatur Erwartet Verfügbarkeit
    BibTip Andere fanden auch interessant ...
  • 7
    Digitale Medien
    Digitale Medien
    Weinheim : Wiley-Blackwell
    Zeitschrift für anorganische Chemie 92 (1915), S. 363-368 
    ISSN: 0863-1786
    Schlagwort(e): Chemistry ; Inorganic Chemistry
    Quelle: Wiley InterScience Backfile Collection 1832-2000
    Thema: Chemie und Pharmazie
    Zusätzliches Material: 2 Tab.
    Materialart: Digitale Medien
    Standort Signatur Erwartet Verfügbarkeit
    BibTip Andere fanden auch interessant ...
  • 8
    Digitale Medien
    Digitale Medien
    Weinheim : Wiley-Blackwell
    Zeitschrift für anorganische Chemie 92 (1915), S. 385-396 
    ISSN: 0863-1786
    Schlagwort(e): Chemistry ; Inorganic Chemistry
    Quelle: Wiley InterScience Backfile Collection 1832-2000
    Thema: Chemie und Pharmazie
    Zusätzliches Material: 3 Tab.
    Materialart: Digitale Medien
    Standort Signatur Erwartet Verfügbarkeit
    BibTip Andere fanden auch interessant ...
  • 9
    Digitale Medien
    Digitale Medien
    Weinheim : Wiley-Blackwell
    Materialwissenschaft und Werkstofftechnik 6 (1975), S. 361-367 
    ISSN: 0933-5137
    Schlagwort(e): Chemistry ; Polymer and Materials Science
    Quelle: Wiley InterScience Backfile Collection 1832-2000
    Thema: Maschinenbau
    Beschreibung / Inhaltsverzeichnis: The Use of Titanium Castings to Produce a Complex Shaped Intermediate Casing of RB 199.This paper describes the present position on a highly stressed casing and its functions in the RB 199-34 R engine. When the parts of the casing are made from solid forged titanium billets, up to 93% of the material used is machined away. For this reason, the most complicated parts of the casing were procured as castings and welded together by TIG welding. The paper describes the present quality standard of the titanium castings. The tests on the materials and their mechanical properties show that the castings are inferior to the forgings only with respect to their HCF behaviour and their elongation at rupture. Macroscopic flaws are not entirely inevitable but can be detected by X-ray tests. The future prospects for titanium castings are considered favourable.
    Notizen: Der Bericht beschreibt die Lage eines hochbeanspruchten Gehäuses und dessen Funktionen im Triebwerk RB 199-34 R. Bei der Herstellung der Einzelteile des Gehäuses aus massiv geschmiedeten Titanblöcken wird bis zu 93% des eingesetzten Materials zerspant. Die kompliziertesten Partien des Gehäuses wurden deshalb als Gußteil bezogen und mittels WIG-Schweißung verbunden. Der Bericht beschreibt den heutigen Qualitätsstand der Titangußteile. Die Ergebnisse der Werkstoff- und Festigkeitsuntersuchungen weisen nur im HCF-Verhalten und der Bruchdehnung Nachteile des Gusses gegenüber dem geschmiedeten Material aus. Makroskopische Fehler sind nicht vollständing vermeidbar, aber durch Röntgenprüfung nachzuweisen. Die künftigen Aussichten des Titangusses werden positiv beurteilt.
    Zusätzliches Material: 14 Ill.
    Materialart: Digitale Medien
    Standort Signatur Erwartet Verfügbarkeit
    BibTip Andere fanden auch interessant ...
  • 10
    Digitale Medien
    Digitale Medien
    Weinheim : Wiley-Blackwell
    Journal of High Resolution Chromatography 8 (1985), S. 169-169 
    ISSN: 0935-6304
    Schlagwort(e): Chemistry ; Analytical Chemistry and Spectroscopy
    Quelle: Wiley InterScience Backfile Collection 1832-2000
    Thema: Chemie und Pharmazie
    Materialart: Digitale Medien
    Standort Signatur Erwartet Verfügbarkeit
    BibTip Andere fanden auch interessant ...
Schließen ⊗
Diese Webseite nutzt Cookies und das Analyse-Tool Matomo. Weitere Informationen finden Sie hier...