ISSN:
0947-5117
Keywords:
Chemistry
;
Polymer and Materials Science
Source:
Wiley InterScience Backfile Collection 1832-2000
Topics:
Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics
Description / Table of Contents:
Improvement of the resistance to corrosion by superheated steam of Incoly Alloy 800 tube material by surface deformation treatmentSpecimens of Incoloy 800 (%, 45.8 Fe, 31.7 Ni + Co, 20 Cr, low additions of Cu, Mn, Al, Ti, Si), having undergone a surface deformation treatment (rolling, bending, sand blasting, needle peening, emery grinding) were exposed to superheated steam (500 and 1000 hrs, 600 and 620 °C, 1, 70 and 145 atm, 0.03 and 3.5 m/s). The weight loss measured has been evaluated as a function of the surface quality. It has been shown that the corrosion losses are inversely proportional to the degree of deformation, corrosion being reduced by 95-96% at 90% deformation. In this context the bending deformation, sand blasting and needle peening are most efficient, while rolling or emery grinding give rise but to deformations in a very thin surface layer which have no “selfhealing” properties. The composition of the corrosion products depends from the degree of deformation: increasing deformation gives rise to a decrease of the iron content, while the contents of nickel, chromium and manganese are increased; this phenomenon is responsible for the protective effect which is due to the formation of chromium oxide coatings.
Notes:
Proben aus Incoloy 800 (%, 45, 8 Fe, 31,7 Ni + Co, 20 Cr, geringe Zusätze von Cu, Mn, Al, Ti, Si) wurden nach einer Oberflächenverformung - Walzen, Biegen, Sandstrahlen, Nadelstrahlen, Schmirgeln - der Einwirkung von überhitztem Wasserdampf (500 und 1000 h, 600 und 620°C, 1, 70 und 145 atm, 0,03 und 3,5 m/s)ausgesetzt. Der gemessene Gewichtsverlust wurde in Beziehung zum Oberflächenzustand ausgewertet. Es zeigte sich, daß die Korrosionsionsverluste umgekehrt proportional dem Verformungsgrad sind: die Korrosion ist bei 90%iger Verformung der Probe um 95-96% verringert. In dieser Hinsicht sind die Biegeverformung, das Sandstrahlen und das Nadelstrahlen am wirksamsten, während beim Walzen oder Schmirgeln nur eine sehr dünne Oberflächenschicht verformt wird, die dann keine selbstheilenden Eigenschaften besitzt. Die Zusammensetzung der Korrosionsprodukte ist abhängig vom Verformungsgrad: zunehmende Verformung führt zu einer Verringerung des Eisengehalts, während die Gehalte an Nickel, Chrom und Mangan in den Korrosionsprodukten ansteigen. Diese Erscheinung ist ursächlich für den Schutzeffekt, der auf der Bildung von Chromoxidschichten beruht.
Additional Material:
13 Ill.
Type of Medium:
Electronic Resource
URL:
http://dx.doi.org/10.1002/maco.19740250103
Permalink