ALBERT

Description: he three-site Leg 64 Deep Sea Drilling transect at the tip of the Peninsula of Baja California straddled the transition from continental to oceanic crust. The outer site, 474, penetrated mainly mud turbidites and bottomed in "middle" Pliocene oceanic crust about 3 m.y. old. Two sites on the lower continental slope penetrated hemipelagic muddy sediments, a thin section of low-oxygen, phosphoritic, and glauconitic sediments, and a metamorphic cobble conglomerate; one of the sites, 476, bottomed in deeply weathered granite. The oldest marine sediments at this site are early Pliocene, about 4.5 m.y. old. Depth indicators in these holes suggest that all sites were in almost 1000 meters of water by the time oceanic crust was first generated and sea-floor spreading began. Block faulting, subsidence, and deposition of marine sediments on continental crust had preceded the start of sea-floor spreading. Close examination of lineated magnetic anomalies demonstrates that the transition from continental to oceanic crust in this region is diachronous, as early as 4.9 m.y. in some places, but as young as 3.2 m.y. along the line of the transect. We propose a geological history scenario which involves termination of subduction along the western margin of Baja California at 12.5 Ma, a period of transform motion between the Pacific and North American plates along the Tosco Abreojos Transform Fault zone along the west side of Baja California, and a jump of the Pacific-North American plate edge to the alignment of the Gulf at 5.5 Ma. Between 5.5 Ma and about 3.2 Ma, separation of the blocks occurred locally by sea-floor spreading, but elsewhere by "diffuse extension", largely involving listric normal faulting and thinning of the continental crust, accompanied by subsidence and marine inundation. Thus, the plate edge system in the mouth and southern part of the Gulf evolved as early as 5.5 Ma, but the transition from rifting to drifting was diachronous, starting only 3.2 Ma along the line of the transect.

Description: The Pliocene-Quaternary sediments that we drilled at eight sites in the Gulf of California consist of silty clays to clayey silts, diatomaceous oozes, and mixtures of both types. In this chapter I have summarized various measurements of their physical properties, relating this information to burial depth and effective overburden pressure. Rapid deposition and frequent intercalations of mud turbidites may cause underconsolidation in some cases; overconsolidation probably can be excluded. General lithification begins at depths between 200 and 300 meters sub-bottom, at porosities between 55 and 60% (for silty clays) and as high as 70% (for diatomaceous ooze). Diatom-rich sediments have low strength and very high porosities (70-90%) and can maintain this state to a depth of nearly 400 meters (where the overburden pressure = 1.4 MPa). The field compressibility curves of all sites are compared to data published earlier. Where sediments are affected by basaltic sills, these curves clearly show the effects of additional loading and thermal stress (diagenesis near the contacts). Strength measurements on well-preserved hydraulic piston cores yielded results similar to those obtained on selected samples from standard drilling. Volumetric shrinkage dropped to low values at 100 to 400 meters burial depth (0.3 to 2.0 MPa overburden pressure). Porosity after shrinkage depends on the composition of sediments.