ALBERT

Description: Observational evidence favoring the local regulation of solar-wind heat flux at 1 AU is reviewed, and four months of IMP 6 plasma and magnetic-field data are merged and analyzed in order to investigate what might be regulating the heat flux. A statistical analysis of the data shows that the solar-wind Alfven speed is probably regulating the heat flux locally at 1 AU and that the Alfven speed, the velocity difference between the peak of low-energy electrons and the bulk plasma velocity, and the solar-wind velocity component projected along the local spiral angle are statistically well correlated for Alfven speeds not exceeding about 70 km/s. A time-series analysis of the data indicates that only the Alfven speed and the velocity difference between the peak of low-energy electrons and the bulk plasma velocity are well correlated both qualitatively and quantitatively on a microscopic time scale. It is strongly suggested that, at times, the solar-wind heat flux is locally regulated by the magnitude of the Alfven speed at 1 AU. Uncertainties in the results are discussed.

Description: The reported results are mainly based on data obtained during the first part of the Helios-1 mission. The sun was very quiet during the considered period. The data are, therefore, representative for comparatively stationary conditions in the solar corona. Data obtained concerning the protons were evaluated by means of a special computer routine. The significance of the data is discussed, taking into account the status of the corona and the interplanetary plasma during the considered part of the Helios-1 mission, fast stream structures in the region between 0.3 and 1 AU, radial gradients of fast and slow solar wind, and the separation of proton double streams and alpha-particles. Attention is also given to the 'strahl' in the electron distribution, differences between fast streams and slow plasma on the basis of the observed electron distributions, and radial gradients in the case of solar wind electron parameters.

Description: A low-NOx emission combustor concept has been developed for NASA's Environmentally Responsible Aircraft (ERA) program to meet N+2 emissions goals for a 70,000 lb thrust engine application. These goals include 75 percent reduction of LTO NOx from CAEP6 standards without increasing CO, UHC, or smoke from that of current state of the art. An additional key factor in this work is to improve lean combustion stability over that of previous work performed on similar technology in the early 2000s. The purpose of this paper is to present the final report for the NASA contract. This work included the design, analysis, and test of a multi-point combustion system. All design work was based on the results of Computational Fluid Dynamics modeling with the end results tested on a medium pressure combustion rig at the UC and a medium pressure combustion rig at GRC. The theories behind the designs, results of analysis, and experimental test data will be discussed in this report. The combustion system consists of five radially staged rows of injectors, where ten small scale injectors are used in place of a single traditional nozzle. Major accomplishments of the current work include the design of a Multipoint Lean Direct Injection (MLDI) array and associated air blast and pilot fuel injectors, which is expected to meet or exceed the goal of a 75 percent reduction in LTO NOx from CAEP6 standards. This design incorporates a reduced number of injectors over previous multipoint designs, simplified and lightweight components, and a very compact combustor section. Additional outcomes of the program are validation that the design of these combustion systems can be aided by the use of Computational Fluid Dynamics to predict and reduce emissions. Furthermore, the staging of fuel through the individually controlled radially staged injector rows successfully demonstrated improved low power operability as well as improvements in emissions over previous multipoint designs. Additional comparison between Jet- A fuel and a hydrotreated biofuel is made to determine viability of the technology for use with alternative fuels. Finally, the operability of the array and associated nozzles proved to be very stable without requiring additional active or passive control systems. A number of publications have been publish

Description: A summary of NASA's High Speed Aeroservoelasticity (ASE) project is provided with a focus on a low-boom supersonic configuration developed by Lockheed-Martin and referred to as the N+2 configuration. The summary includes details of the computational models developed to date including a linear finite element model (FEM), linear unsteady aerodynamic models, structured and unstructured CFD grids, and discussion of the FEM development including sizing and structural constraints applied to the N+2 configuration. Linear results obtained to date include linear mode shapes and linear flutter boundaries. In addition to the tasks associated with the N+2 configuration, a summary of the work involving the development of AeroPropulsoServoElasticity (APSE) models is also discussed.