ALBERT

Description: Highlights • Seismic depth imaging gives insight into the southern Hikurangi subduction zone. • Velocities reveal regional variations in compaction and drainage of input sediments. • Dewatering of subducted sediments might influence décollement strength. • Thrusts at the leading edge of deformation are upper-plate dewatering pathways. • Stratigraphic host of the décollement changes at the southern end of the margin. Abstract The southern end of New Zealand's Hikurangi subduction margin accommodates highly oblique convergence between the Pacific and Australian plates. We carry out two-dimensional (2D) seismic reflection tomography and pre-stack depth migrations on two seismic lines to gain insight into the nature of subducted sediments and upper plate faulting and dewatering at the toe of the wedge. We also investigate the NE to SW evolution of emergent upper plate thrust faulting using 47 seismic lines spanning an along-strike distance of ∼270 km. The upper sequence of sediments that ultimately gets subducted (the MES sequence) has an anomalously-low seismic velocity character. At the southwestern end of the margin, ∼150 km east of Kaikōura, the MES sequence has experienced greater compaction (for an equivalent effective vertical stress) than it has some 200 km further to the northeast. This difference is likely attributable to greater horizontal compression in the southwest caused by impingement of the Chatham Rise on the deformation front. Relationships between velocity and effective vertical stress suggest that the MES sequence is well-drained in the vicinity of frontal thrusts, corroborated by evidence for upper plate dewatering along those thrusts. Effective drainage of the MES sequence likely promotes interplate coupling on the southern Hikurangi margin. The décollement is generally hosted near a seismic reflector known as “Reflector 7”. East of Kaikōura, however, Reflector 7 becomes accreted, indicating that subduction slip at the southwestern end of the margin is no longer hosted at (or above) this reflector. Instead, the décollement steps down to a deeper stratigraphic level further inboard. Further to the SW, approximately in line with the lower Kaikōura Canyon, the offshore manifestation of subduction-driven compression ceases.

Description: We analyse reflection seismic profiles across the outer accretionary wedge at the convergent New Zealand Hikurangi margin. We identify several, in some case stacked, bottom simulating reflections (BSRs). We interpret these multiple BSRs to record changes in gas hydrate stability. With the aid of gas hydrate systems modelling, we identify two geological drivers that affect gas hydrate stability: (1.) rapid sedimentation in trough basins and (2.) uplift and erosion of thrust ridges. Rapid sedimentation in trough basins buries gas hydrates that formed above the former base of gas hydrate stability (BGHS). Locally, we observe a remnant BSR from this process, likely due to residual gas and possibly gas hydrate. The combined effects of uplift and erosion, in contrast, result in the preservation of a remnant BSR within the gas hydrate stability zone, whilst a new BSR forms locally at the present-day BGHS. However, the limited occurrence of double BSRs in seismic data and the model both suggest that the formation of a deeper BSR is limited by gas supply. Formation of significant gas hydrate at this deeper level only occurs in areas of focused gas migration. This slow formation of gas hydrate also has implications for the response to glacio-eustatic sea-level rise: gas hydrates are more likely to accumulate above the BGHS corresponding to the last glacial maximum, whereas only small amounts formed above the deeper present-day BGHS. Hence, future bottom water warming will, at least initially, not lead to significant methane release from dissociating gas hydrates in deep water.