ALBERT

Description: Peroxy radicals were measured by a PeRCA (Peroxy Radical Chemical Amplifier) instrument in the boundary layer during the DOMINO (Diel Oxidant Mechanisms In relation to Nitrogen Oxides) campaign at a coastal, forested site influenced by urban-industrial emissions in southern Spain in late autumn. Total peroxy radicals (RO2* = HO2 + ΣRO2) generally showed a daylight maximum between 10 and 50 pptv at 13:00 UTC, with an average of 18 pptv over the 15 days of measurements. Emissions from the industrial area of Huelva often impacted the measurement site at night during the campaign. The processing of significant levels of anthropogenic organics leads to an intense nocturnal radical chemistry accompanied by formation of organic peroxy radicals at comparable levels to those of summer photochemical conditions with peak events up to 60–80 pptv. The RO2 production initiated by reactions of NO3 with organic trace gases was estimated to be significant, but not sufficient to account for the concentrations of RO2* observed in air masses carrying high pollutant loading. The nocturnal production of peroxy radicals in those periods seems therefore to be dominated by ozonolysis of volatile organic compounds, in particular alkenes of industrial petrochemical origin. RO2* diurnal variations were consistent with HO2 measurements available at the site. HO2/RO2* ratios generally varied between 0.3 and 0.6, though on some occasions this ratio was likely to have been affected by instrumental artifacts (overestimated HO2) associated with high RO2 loads.

Description: In situ airborne measurements of OH and HO2 with the HORUS (HydrOxyl Radical measurement Unit based on fluorescence Spectroscopy) instrument were performed in the summertime upper troposphere across Europe during the HOOVER 2 (HOx OVer EuRope) campaign in July 2007. Complementary measurements of trace gas species and photolysis frequencies were conducted to obtain a broad data set, which has been used to quantify the significant HOx sources and sinks. In this study we compare the in situ measurement of OH and HO2 with simulated mixing ratios from the constrained box model CAABA/MECCA (Chemistry As A Box Model Application/Module Efficiently Calculating the Chemistry of the Atmosphere), and the global circulation model EMAC (ECHAM5/MESSy Atmospheric Chemistry Model). The constrained box model reproduces the observed OH and HO2 mixing ratios with better agreement (obs/mod median 98% OH, 96% HO2) than the global model (median 76% OH, 59% HO2). The observations and the computed HOx sources and sinks are used to identify deviations between the models and their impacts on the calculated HOx budget.

Description: Atmospheric carbon monoxide (CO) distributions are controlled by anthropogenic emissions, biomass burning, transport and oxidation by reaction with the hydroxyl radical (OH). Quantifying trends in CO is therefore important for understanding changes related to all of these contributions. Here we present a comprehensive record of satellite observations from 2000 through 2011 of total column CO using the available measurements from nadir-viewing thermal infrared instruments: MOPITT, AIRS, TES and IASI. We examine trends for CO in the Northern and Southern Hemispheres along with regional trends for Eastern China, Eastern USA, Europe and India. We find that all the satellite observations are consistent with a modest decreasing trend ~ −1 % yr−1 in total column CO over the Northern Hemisphere for this time period and a less significant, but still decreasing trend in the Southern Hemisphere. Although decreasing trends in the United States and Europe have been observed from surface CO measurements, we also find a decrease in CO over E. China that, to our knowledge, has not been reported previously. Some of the interannual variability in the observations can be explained by global fire emissions, but the overall decrease needs further study to understand the implications for changes in anthropogenic emissions.

Description: The largest increase in export production in the eastern Pacific of the last 5.3 Myr (million years) occurred between 2.2 and 1.6 Myr, a time of major climatic and oceanographic reorganization in the region. Here, we investigate the causes of this event using reconstructions of export production, nutrient supply and oceanic conditions across the Pliocene-Pleistocene in the eastern equatorial Pacific (EEP) for the last 3.2 Myr. Our results indicate that the export production peak corresponds to a cold interval marked by high nutrient supply relative to consumption, as revealed by the low bulk sedimentary 15N/14N (δ15N) and alkenone-derived sea surface temperature (SST) values. This ~ 0.6 million years long episode of enhanced delivery of nutrients to the surface of the EEP was predominantly initiated through the upwelling of nutrient-enriched water sourced in high latitudes. In addition, this phenomenon was likely promoted by the regional intensification of upwelling in response to the development of intense Walker and Hadley atmospheric circulations. Increased nutrient consumption in the polar oceans and enhanced denitrification in the equatorial regions restrained nutrient supply and availability and terminated the high export production event.

Description: Mediterranean areas are characterized by a strong spatial variability that makes highly complex the soil hydrological response. Moreover, Mediterranean climate has a marked seasonal variability that provokes dramatic changes on the soil properties determining the hydrological behavior, such as soil water content, crust formation or soil water repellency (SWR). Thus, soil hydrological and erosive response in Mediterranean areas can be highly time- as well space-dependant. The main goal of this study was to characterize the relations between SWR, aspect and vegetation, determining the soil hydrological and erosive response throughout the rainy period in different microenvironments of opposite hillslopes. This study was undertaken in a small catchment located in the South of Spain. Erosion plots were installed in the north- and the south-facing hillslope, in areas with different vegetal cover, and runoff and sediments were collected. Moreover, precipitation parameters were recorded and SWR measurements were performed. SWR proved to have a significant effect on the soil hydrological response, but this influence was modulated by seasonal changes and by the discontinuities on the repellent layer. In general, the influence of SWR was restricted to the first rains after the summer and was greater on the north-facing hillslope due to the more continuous vegetation cover. The more important precipitation parameter influencing runoff generated was maximum rainfall intensity in ten minutes (Imax). The relation between Imax and overland flow showed a contrasting seasonal behavior in the north-facing hillslope and, on the contrary, remained homogeneous throughout the year in the south-facing hillslope.

Description: Mediterranean areas are characterized by a strong spatial variability that makes the soil hydrological response highly complex. Moreover, Mediterranean climate has marked seasons that provoke dramatic changes on soil properties determining the runoff rates, such as soil water content or soil water repellency (SWR). Thus, soil hydrological and erosive response in Mediterranean areas can be highly time- as well as space-dependant. This study shows SWR, aspect and vegetation as factors of the soil hydrological and erosive response. Erosion plots were set up in the north- and the south-facing hillslope and rainfall, runoff, sediments and SWR were monitored. Soil water repellency showed a seasonal behaviour and it was presented in three out of four microenvironments after the summer, disappearing in the wet season. In general, runoff rate was higher in shrubs patches (0.47 ± 0.67 mm) than in inter-shrub soils (1.54 ± 2.14 mm), but it changed seasonally in different ways, depending on the aspect considered, decreasing in the north-facing hillslope and increasing in the south-facing one. The main factor determining the hydrological and erosive response was the rainfall intensity, regardless of the rainfall depth of the event. This response was modulated mainly by SWR in the north-facing hillslope and the vegetation pattern in the south-facing one.

Description: In agricultural ecosystems the use of evapotranspiration (ET) to improve irrigation water management is generally widespread. Commonly, the crop ET (ETc) is estimated by multiplying the reference crop evapotranspiration (ETo) by a crop coefficient (Kc). Accurate estimation of ETo is critical because it is the main factor affecting the calculation of crop water use and water management. The ETo is generally estimated from recorded meteorological variables at reference weather stations. The main objective of this paper was assessing the effect of the uncertainty due to random noise in the sensors used for measurement of meteorological variables on the estimation of ETo, crop ET and net irrigation requirements of grain corn and alfalfa in three irrigation districts of the middle Ebro River basin. Five scenarios were simulated, four of them individually considering each recorded meteorological variable (temperature, relative humidity, solar radiation and wind speed) and a fifth scenario combining together the uncertainty of all sensors. The uncertainty in relative humidity for irrigation districts Riegos del Alto Aragón (RAA) and Bardenas (BAR), and temperature for irrigation district Canal de Aragón y Cataluña (CAC), were the two most important factors affecting the estimation of ETo, corn ET (ETc_corn), alfalfa ET (ETc_alf), net corn irrigation water requirements (IRncorn) and net alfalfa irrigation water requirements (IRnalf). Nevertheless, this effect was never greater than ±0.5% over annual scale time. The wind speed variable (Scenario 3) was the third variable more influential in the fluctuations (±) of evapotranspiration, followed by solar radiation. Considering the accuracy for all sensors over annual scale time, the variation was about ±1% of ETo, ETc_corn, ETc_alf, IRncorn, and IRnalf. The fluctuations of evapotranspiration were higher at shorter time scale. ETo daily fluctuation remained lower than 5 % during the growing season of corn and alfalfa. This estimation fluctuation in ETo, ETc_corn, ETc_alf , IRncorn, and IRnalf at daily time scale was within an acceptable range, and it can be considered that the sensor accuracy of the meteorological variables is not significant in the estimation of ETo.

Description: Humans are responsible for most forest fires in Europe, but anthropogenic factors behind these events are still poorly understood. We tried to identify the driving factors of human-caused fire occurrence in Spain by applying two different statistical approaches. Firstly, assuming stationary processes for the whole country, we created models based on multiple linear regression and binary logistic regression to find factors associated with fire density and fire presence, respectively. Secondly, we used geographically weighted regression (GWR) to better understand and explore the local and regional variations of those factors behind human-caused fire occurrence. The number of human-caused fires occurring within a 25-yr period (1983–2007) was computed for each of the 7638 Spanish mainland municipalities, creating a binary variable (fire/no fire) to develop logistic models, and a continuous variable (fire density) to build standard linear regression models. A total of 383 657 fires were registered in the study dataset. The binary logistic model, which estimates the probability of having/not having a fire, successfully classified 76.4% of the total observations, while the ordinary least squares (OLS) regression model explained 53% of the variation of the fire density patterns (adjusted R2 = 0.53). Both approaches confirmed, in addition to forest and climatic variables, the importance of variables related with agrarian activities, land abandonment, rural population exodus and developmental processes as underlying factors of fire occurrence. For the GWR approach, the explanatory power of the GW linear model for fire density using an adaptive bandwidth increased from 53% to 67%, while for the GW logistic model the correctly classified observations improved only slightly, from 76.4% to 78.4%, but significantly according to the corrected Akaike Information Criterion (AICc), from 3451.19 to 3321.19. The results from GWR indicated a significant spatial variation in the local parameter estimates for all the variables and an important reduction of the autocorrelation in the residuals of the GW linear model. Despite the fitting improvement of local models, GW regression, more than an alternative to "global" or traditional regression modelling, seems to be a valuable complement to explore the non-stationary relationships between the response variable and the explanatory variables. The synergy of global and local modelling provides insights into fire management and policy and helps further our understanding of the fire problem over large areas while at the same time recognizing its local character.

Description: The seismic hazard of the Iberian Peninsula is analysed using a nonparametric methodology based on statistical kernel functions; the activity rate is derived from the catalogue data, both its spatial dependence (without a seismogenetic zonation) and its magnitude dependence (without using Gutenberg–Richter's law). The catalogue is that of the Instituto Geográfico Nacional, supplemented with other catalogues around the periphery; the quantification of events has been homogenised and spatially or temporally interrelated events have been suppressed to assume a Poisson process. The activity rate is determined by the kernel function, the bandwidth and the effective periods. The resulting rate is compared with that produced using Gutenberg–Richter statistics and a zoned approach. Three attenuation laws have been employed, one for deep sources and two for shallower events, depending on whether their magnitude was above or below 5. The results are presented as seismic hazard maps for different spectral frequencies and for return periods of 475 and 2475 yr, which allows constructing uniform hazard spectra.

Description: A new system for continuous, highly-resolved oceanic and atmospheric measurements of N2O, CO and CO2 is described. The system is based upon off-axis integrated cavity output spectroscopy (OA-ICOS) and a non-dispersive infrared analyzer (NDIR) both coupled to a Weiss-type equilibrator. Performance of the combined setup was evaluated by testing its precision, accuracy, long-term stability, linearity and response time. Furthermore, the setup was tested during two oceanographic campaigns in the equatorial Atlantic Ocean in order to explore its potential for autonomous deployment onboard voluntary observing ships (VOS). Improved equilibrator response times for N2O (2.5 min) and CO (45 min) were achieved in comparison to response times from similar chamber designs used by previous studies. High stability of the OA-ICOS analyzer was demonstrated by low optimal integration times of 2 and 4 min for N2O and CO respectively, as well as detection limits of 〈 40 ppt and precision better than 0.3 ppb Hz−1/2. Results from a direct comparison of the method presented here and well-established discrete methods for oceanic N2O and CO2 measurements showed very good consistency. The favorable agreement between underway atmospheric N2O, CO and CO2 measurements and monthly means at Ascension Island (7.96° S 14.4° W) further suggests a reliable operation of the underway setup in the field. The potential of the system as an improved platform for measurements of trace gases was explored by using continuous N2O and CO2 data to characterize the development of the seasonal equatorial upwelling in the Atlantic Ocean during two R/V Maria S. Merian cruises. A similar record of high-resolution CO measurements was simultaneously obtained offering for the first time the possibility of a comprehensive view on the distribution and emissions of these climate relevant gases on the area. The relatively simple underway N2O/CO/CO2 setup is suitable for long-term deployment on board of research and commercial vessels although potential sources of drift such as cavity temperature and further technical improvements towards automation still need to be addressed.