ALBERT

All Library Books, journals and Electronic Records Telegrafenberg

feed icon rss

Your email was sent successfully. Check your inbox.

An error occurred while sending the email. Please try again.

Proceed reservation?

Export
Filter
Collection
Language
  • 1
    Electronic Resource
    Electronic Resource
    Springer
    International journal of earth sciences 80 (1991), S. 187-200 
    ISSN: 1437-3262
    Source: Springer Online Journal Archives 1860-2000
    Topics: Geosciences
    Description / Table of Contents: Abstract Many of the least eighty eruptions of the six silicic eruptive cycles in the last 50 ka at Pantelleria started out with explosive phases and ended with lava effusion. The pyroclastic rocks are rhyolitic in composition while the later-erupted lavas are less evolved up to trachyte probably due to the presence of a shallow and compositionally zoned magma chamber tapped at increasing depth during the eruptions. The products of twenty explosive eruptions have been recognized. Most of them are represented by fallout deposits, the only exceptions being the Green Tuff and the Fossa Carbonara Tuff. Hydromagmatism is very rare though the magmas interacted with sea water. It is supposed that interaction was not efficient because the magmas were not vesiculated and disrupted. Horizons showing variable degrees of welding up to vitrophyres, have often been identified in the air-fall tuffs. Most of the eruptions were characterized by low eruptive columns and were likely to have involved a strombolian-type mechanism.
    Abstract: Résumé Parmi les 80 éruptions des 6 cycles d'éruptions acides qui ont affecté Pantelleria au cours des 50.000 dernières années, les plus faibles ont commencé par une phase explosive et se sont achevées par des effusions de laves. La composition des roches pyroclastiques est rhyolitique tandis que celle des laves ultérieures, moins évoluées, est trachytique. Ce fait est dû probablement à la présence d'une chambre magmatique peu profonde à zonage compositionnel, dont des parties de plus en plus profondes ont alimenté les phases successives des éruptions. Les produits de 20 éruptions explosives ont été identifiés. La plupart d'entre eux sont des dépôts de retombée directe, avec comme seules exceptions le «Green Tuff» et le «Fossa Carbonara Tuff». Les manifestations hydromagmatiques sont très rares, en dépit du fait que le magma a dû être en contact avec l'eau de mer. On suppose que leur interaction a été réduite parce que le magma n'était ni vésiculaire, ni dilacéré. Dans les dépôts formés par retombées aériennes, on a identifié à de multiples reprises des horizons de tufs soudés à des degrés divers, jusqu'à celui des vitrophyres. La plupart des éruptions ont présenté des colonnes éruptives peu élevées et ont probablement développé un mécanisme strombolien.
    Notes: Zusammenfassung Die schwächsten der 80 Ausbrüche der sechs sauren Eruptionszyklen bei Pantelleria wurden innerhalb der letzten 50000 Jahre eingeleitet durch explosive Phasen und endeten mit gleichmäßigem Lavaausfluß. Die Zusammensetzung der Pyroklastika ist rhyolitisch, die der späteren Laven eher trachytisch. Die Ursache für diesen unterschiedlichen Chemismus ist wahrscheinlich eine vertikal in der Zusammensetzung zonierte Magmenkammer in geringer Tiefe, die während der Ausbrüche aus immer tiefer gelegenen Bereichen angezapft wurde. Von 20 explosiven Ausbrüchen konnten charakteristische Auswurfprodukte gefunden werden. Dabei handelt es sich meist um Schlacken- und Lavaauswurf, als Ausnahmen existieren der »Green Tuff« und der »Fossa Cabonara Tuff«. Hydromagmatische Vorgänge sind äußerst selten, obwohl das Magma mit Meerwasser in Kontakt gekommen sein muß. Die Annahme, daß keine Reaktion zwischen Magma und Meerwasser stattgefunden hat, beruht auf der blasenfreien und nicht zerrissenen Erhaltung. Innerhalb der Tuffite gibt es mehrere Horizonte unterschiedlicher Verschweißungsstufen bis hin zu Vitrophyren. Die meisten der Ausbrüche hatten niedrige Eruptionssäulen und beinhalteten strombolianische Tätigkeit.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 2
    ISSN: 1546-1696
    Source: Nature Archives 1869 - 2009
    Topics: Biology , Process Engineering, Biotechnology, Nutrition Technology
    Notes: [Auszug] Systemic lupus erythematosus (SLE) is a multisystem chronic inflammatory disease of unknown etiology that affects many organs, including the kidney. The presence of multiple autoantibodies and other immunological abnormalities point to basic defects in immunoregulatory controls that normally ...
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 3
    Electronic Resource
    Electronic Resource
    Springer
    Rheologica acta 6 (1967), S. 390-396 
    ISSN: 1435-1528
    Source: Springer Online Journal Archives 1860-2000
    Topics: Chemistry and Pharmacology , Physics
    Description / Table of Contents: Zusammenfassung Die vorliegende Arbeit beschreibt eine verbesserte radiometrische Methode zur Messung der WÄrmeausdehnung fester Stoffe, insbesondere von Hochpolymeren. Die Änderungen der Probendimensionen werden als entsprechende Änderungen der Transmission derΒ-Strahlen registriert. In erster Linie wird beabsichtigt, damit thermische Umwandlungen hochpolymerer Stoffe zu verfolgen. An einer Reihe von Meßresultaten wird gezeigt, daß die Methode für diesen Zweck wohl geeignet und mit normaler Dilatometrie vergleichbar ist. Die wiedergegebenen Beispiele beziehen sich auf die Glasumwandlung amorpher Hochpolymere, die Umwandlungen bei Zimmertemperatur in PTFE — wo auch der Hystereseffekt aufgelöst worden ist -, Unterschiede in der WÄrmeausdehnung von PE verschiedener KristallinitÄt usw. In sÄmtlichen FÄllen konnte eine gute übereinstimmung mit den entsprechenden Literaturangaben erzielt werden.
    Notes: Summary The present paper describes an improved radiometric method for the measurement of thermal expansion of solids, especially high polymers. The changes in the dimensions of the sample are recorded as the corresponding changes in the transmission ofΒ-rays. In the first place, the method is aimed at following thermal transitions in high polymers. A number of experimental examples shown in the paper demonstrate that the method is well suited for this purpose and that it gives results comparable with ordinary dilatometry. These examples relate to the glass transition in amorphous polymers, the room temperature transitions in PTFE including the accompanying hysteresis effect, differences in thermal expansion of PE of varying crystallinity, etc. A good agreement with the corresponding literature data was achieved.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 4
    Electronic Resource
    Electronic Resource
    Springer
    Journal of materials science 15 (1980), S. 2636-2642 
    ISSN: 1573-4803
    Source: Springer Online Journal Archives 1860-2000
    Topics: Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics
    Notes: Abstract The behaviour of paperboard beams subjected to pure bending is analysed and related to tensile and compression stress-strain behaviour. Since the compression strength is lower than the tensile strength, beam failure occurs in compression. However, beam failure does not occur when the ultimate strain in pure compression is reached in the surface fibres. A plastic yielding in compression, which gives good agreement between experimentally-determined and theoretically-calculated bending moments up to failure is therefore suggested. At failure, the elastic energy stored in the sample causes propagation of an interlaminar crack at the compression side, which is observed in scanning electron micrographs.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 5
    Electronic Resource
    Electronic Resource
    Springer
    Journal of materials science 18 (1983), S. 1365-1373 
    ISSN: 1573-4803
    Source: Springer Online Journal Archives 1860-2000
    Topics: Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics
    Notes: Abstract A parallel beam model is presented for the bending behaviour of locally delaminated zones (creased zones) of paperboard. It is shown that the bending moment and the force levels are strongly dependent on the geometry and elastic properties of the creased zone. A favourable condition for low crease stiffness is a large number of long interlaminar failures. Experimental measurements of the crease stiffness and maximum bending moment for paperboards with implanted defects of various lengths and numbers were in reasonably good agreement with the crease stiffness predicted by the parallel beam model.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 6
    Electronic Resource
    Electronic Resource
    New York : Wiley-Blackwell
    Journal of Polymer Science: Polymer Chemistry Edition 11 (1973), S. 3017-3020 
    ISSN: 0360-6376
    Keywords: Physics ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology
    Notes: An expression is derived for the partitioning of a solute molecule in a two-phase system: swollen gel and free solvent. The approach is thermodynamic, and no specific mechanism for the accessibility of the solute to the gel is assumed. Instead, general interaction terms between the components, i.e., polymer-solvent-solute, are introduced.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 7
    Electronic Resource
    Electronic Resource
    New York : Wiley-Blackwell
    Journal of Polymer Science: Polymer Chemistry Edition 15 (1977), S. 2029-2032 
    ISSN: 0360-6376
    Keywords: Physics ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology
    Additional Material: 4 Ill.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 8
    Electronic Resource
    Electronic Resource
    New York, NY [u.a.] : Wiley-Blackwell
    Journal of Applied Polymer Science 29 (1984), S. 187-195 
    ISSN: 0021-8995
    Keywords: Chemistry ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics , Physics
    Notes: The mechanical properties, i.e., the tensile strength, tensile modulus, elongation at rupture, and tensile energy absorption (work of rupture), of a dry-formed network of cellulose fibers are shown to be substantially improved by impregnation of the network with organic solutions of poly(vinyl acetate) (PVAC). With the exception of the tensile strength, the improvement of the mechanical properties in the dry state is, however, dependent not only on the polymer content, but also on the interaction between the solvent and the cellulose fibers constituting the network. A solvent which interacts strongly with cellulose produces a stiffer and less ductile network than a more inert liquid. It is suggested that this effect is the result of a change in the cellulose network structure itself. The solvents used in this study were methanol, acetone, ethyl acetate, chloroform, and toluene.
    Additional Material: 5 Ill.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 9
    Electronic Resource
    Electronic Resource
    New York, NY [u.a.] : Wiley-Blackwell
    Journal of Applied Polymer Science 28 (1983), S. 1599-1611 
    ISSN: 0021-8995
    Keywords: Chemistry ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics , Physics
    Notes: Dry-formed networks of cellulose fibers, produced with a laboratory device, have been impregnated with aqueous solutions of poly(vinyl alcohol) or solutions of poly(vinyl acetate) in acetone. In both cases, the strength and stiffness of the networks increase several times compared with the unmodified structure. When aqueous solutions are used, it appears that a minimum amount of poly(vinyl alcohol) is required (ca. 2 wt %) to increase the strength appreciably, but when poly(vinyl acetate) dissolved in acetone is used, as a binder, the strength improves even at the lowest level of polymer addition. For the systems studied here, the elongation at rupture increased with increasing polymer concentration. In most cases, the amount of polymer in the network structure was less than 10 wt %. Some results from impregnations using other polymeric systems, e.g., latices, are also reported.
    Additional Material: 9 Ill.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 10
    Electronic Resource
    Electronic Resource
    New York, NY [u.a.] : Wiley-Blackwell
    Journal of Applied Polymer Science 30 (1985), S. 1597-1604 
    ISSN: 0021-8995
    Keywords: Chemistry ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics , Physics
    Notes: The dynamic mechanical properties of paper during restrained drying are reported in this article. The apparatus used was a servohydraulic material testing system (MTS), connected to a computer unit. It has been found that the ratio of drying stress to elastic modulus at a given dry solids content corresponds to the instantaneous linear contraction of the sheet when the drying stress is relieved. It is therefore deduced that paper behaves as a linear viscoelastic body during restrained drying. The finding of a maximum loss coefficient and the drastic change in elastic modulus during drying of paper are interpreted in terms of a transitional change in the amorphous regions of wood polymers plasticized by water.
    Additional Material: 7 Ill.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
Close ⊗
This website uses cookies and the analysis tool Matomo. More information can be found here...