ALBERT

All Library Books, journals and Electronic Records Telegrafenberg

feed icon rss

Your email was sent successfully. Check your inbox.

An error occurred while sending the email. Please try again.

Proceed reservation?

Export
  • 1
    Publication Date: 2017-04-12
    Description: Shallow-level sill emplacement can uplift Earth’s surface via forced folding, providing insight into the location and size of potential volcanic eruptions. Linking the structure and dynamics of ground deformation to sill intrusion is thus critical in volcanic hazard assessment. This is challenging, however, because (1) active intrusions cannot be directly observed, meaning that we rely on transient host-rock deformation patterns to model their structure; and (2) where ancient sill-fold structure can be observed, magmatism and deformation has long since ceased. To address this problem, we combine structural and dynamic analyses of the Alu dome, Ethiopia, a 3.5-km-long, 346-m-high, elliptical dome of outward-dipping, tilted lava flows cross-cut by a series of normal faults. Vents distributed around Alu feed lava flows of different ages that radiate out from or deflect around its periphery. These observations, coupled with the absence of bounding faults or a central vent, imply that Alu is not a horst or a volcano, as previously thought, but is instead a forced fold. Interferometric synthetic aperture radar data captured a dynamic growth phase of Alu during a nearby eruption in A.D. 2008, with periods of uplift and subsidence previously attributed to intrusion of a tabular sill at 1 km depth. To localize volcanism beyond its periphery, we contend that Alu is the first forced fold to be recognized to be developing above an incrementally emplaced saucer-shaped sill, as opposed to a tabular sill or laccolith.
    Print ISSN: 0091-7613
    Electronic ISSN: 1943-2682
    Topics: Geosciences
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 2
    Publication Date: 2019
    Description: In this study, an alternative fuel for compression ignition (CI) engines called tri-fuel emulsion was prepared using an ultrasonic emulsifier. The objective of the study is to investigate the effect of emulsifying settings and formulation ratio on the physicochemical properties of tri-fuel emulsions. Design of experiment (DOE) with the two-level factorial design was employed to analyze the effect of emulsifying settings such as time, amplitude, and cycle along with the variation ratio of tri-fuel emulsion components as control factors. Numbers of responses identified were important parameters that may contribute to microexplosion phenomenon in CI engine. Analysis of variance (ANOVA) was carried out for each response, and the results indicated that density, dynamic viscosity, surface tension, and average droplet size were influenced by specific preparation control factors. Furthermore, interaction among the control factors was found to affect the responses as well. Interaction means the effect of two factors together is different than what would be expected from each factor separately. Besides, the stability of the tri-fuel emulsion was observed for three months. Furthermore, a qualitative approach with a multiobjective lens digital microscope revealed the geometry of freshly made dispersed tri-fuel emulsion droplets. Microscopic examination on tri-fuel emulsion droplets has shown that the dispersed ethanol capsulated within diesel with the help of biodiesel is similar to a water in diesel emulsion and is dissimilar to commercial diesel mixed with fatty acid methyl esters found in the market.
    Electronic ISSN: 1996-1073
    Topics: Energy, Environment Protection, Nuclear Power Engineering
    Published by MDPI
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 3
    Publication Date: 2018-03-20
    Description: Biodiesel is a promising alternative fuel to run the automotive engine. However, its blends have not been properly investigated during idling as it is the main problem to run the vehicles in a big city. The purpose of this study is to evaluate the impact of alcohol additives such as butanol and ethanol on combustion parameters under idling conditions when a single cylinder diesel engine operates with diesel, diesel-biodiesel blends, and diesel biodiesel-alcohol blends. The engine combustion parameters such as peak pressure, heat release rate and ignition delay were computed. This investigation has revealed that alcohol blends with diesel and biodiesel, BU20 blend yield higher maximum peak cylinder pressure than diesel. B5 blend was found with the lowest energy release among all. B20 was slightly lower than diesel. BU20 blend was seen with the highest peak energy release where E20 blend was found advance than diesel. Among all, the blends alcohol component revealed shorter ignitio...
    Print ISSN: 1757-8981
    Electronic ISSN: 1757-899X
    Topics: Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 4
  • 5
    Publication Date: 2023-07-18
    Description: Abstract: Mekelle is the capital city of Tigray, located in Northern Ethiopia. Water samples collected from 18 springs, spatially covering the study area, were analyzed for their physical properties, and major cation and anion concentrations. Geologically, the study area is characterized by limestone, shale, limestone-shale-marl intercalation, and a dolerite rock unit. The fractured dolerite and fractured limestone are the main water-bearing geological formations. The objective of this research was to determine the groundwater type, from springwater chemistry, and evaluate its quality status for irrigation purposes. The total dissolved solids (TDS), chloride (Cl), and pH range from 330 to 1346 mg/l, 5.76 to 250.6 mg/l, and 7.01 to 8.13 respectively. A piper diagram showed the presence of three groundwater types in this area: calcium magnesium chloride, mixed type, and calcium magnesium bicarbonate hydrochemical facies. The dominant of the three, with about 70 %, was the calcium magnesium bicarbonate type. The sodium adsorption ratio (SAR) and sodium percentage (Na %) were calculated to determine the suitability of the water for irrigation. The SAR and Na % values ranged from 1.71 to 5.36 and 10.69 to 20.54, respectively. As per the international water quality permissible limit for irrigation, both values fall under suitable status. Therefore, based on the outputs of this research, all of the spring waters found in this thematic area can be directly used for irrigation without any prior treatment.
    Language: English
    Type: info:eu-repo/semantics/conferenceObject
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
Close ⊗
This website uses cookies and the analysis tool Matomo. More information can be found here...