ALBERT

Notes: Abstract Petrologic studies of tephra from Kanaga, Adak, and Great Sitkin Islands indicate that amphibole fractionation and magma mixing are important processes controlling the composition of calc-alkaline andesite and dacite magmas in the central Aleutians. Amphibole is ubiquitous in tephra from Kanaga and Adak Islands, whereas it is present only in a basaltic-andesite pumice from Great Sitkin. Dacitic tephra from Great Sitkin do not contain amphibole. Hornblende dacite tephra contain HB+PLAG+OX±OPX±CPX phenocrysts with simple zoning patterns, suggesting that the dacites evolved in isolated magma chambers. Andesitic tephra from Adak contain two pyroxene and hornbelende populations, and reversely zoned plagioclase, indicating a more complex history involving mixing and fractional crystallization. Mass balance calculations suggest that the andesitic tephra may represent the complements of amphibole-bearing cumulate xenoliths, both formed during the evolution of high-Al basalts. The presence of amphibole in andesitic and dacitic tephra implies that Aleutian cale-alkaline magmas evolve in the mid to lower crust under hydrous (〉4 wt.% H2O) and oxidizing (≈Ni−NiO) conditions. Amphibole-bearing andesites and pyroxene-bearing dacites from Great Sitkin indicates fractionation at several levels within the arc crust. Despite its absence in many calc-alkaline andesite and dacite lavas, open system behavior involving amphibole fractionation can explain the trace element characteristies of lavas found on Adak Island. Neither open nor closed system fractionation involving a pyroxene-bearing assemblage is capable of explaining the trace element concentrations or ratios found in the Adak suite. We envision a scenario where amphibole was initially a liquidus phase in many calc-alkaline magmas, but was later replaced by pyroxenes as the magmas rose to shallow levels within the crust. The mineral assemblage in these evolved lavas reflects shallow level equilibration of the magma, whereas the trace element chemistry provides evidence for a earlier, amphibole-bearing, mineral assemblage.

Notes: Abstract Lavas from Akutan Island, located in the eastern Aleutian arc at the transition between continental and oceanic crust, show a gradual change in their petrologic and chemical characteristics over the last 4 million years. The oldest lavas exposed on the island, the Hot Springs Bay Volcanics (HSBV), range from magnesian basalt to dacite (45%–62% SiO2). The most mafic basalts contain salitic clinopyroxene, Cr- and Al-rich spinel, and pargasitic amphibole suggesting that they were derived from relatively hydrous magmas at greater pressures than lavas from the younger Akutan Volcanics (AKV) and the modern volcano (MOD). AKV lavas also range between basalt and dacite (46%–63% SiO2), but contain no hydrous phenocrysts and seem to have fractionated within a shallow level magma chamber. Lavas from the modern volcano are andesitic (52%–57% SiO2) and have a mineral assemblage similar to that of AKV lavas of similar composition. With the exception of clinopyroxene and spinel in the most mafic lavas, the compositions of plagioclase (An92−45), olivine (Fo88−51), orthopyroxene (En69−56), and titanomagnetite (15%–21% TiO2) phenocrysts found in these lavas are within the range observed in lavas from other Aleutian volcanoes. Variations in the major element chemistry of the older lavas can be reproduced by fractional crystallization of the observed mineral assemblages, however closed system crystal fractionation models are inadequate to explain the trace element variations. During the last 4 million years, La/Yb ratios have decreased (6.5–3.3 for HSBV lavas and 2.9–1.9 for MOD lavas) whereas Ba/La ratios appear to have increased slightly (37–43 for HSBV and AKV, and 41–45 of MOD). The lower La/Yb ratios of MOD lavas correspond with lower total abundances of the REE and slightly higher Sr and Pb isotopic ratios. The increased87Sr/86Sr ratios and Pb isotopic ratios in the MOD lavas, the less enriched LREE, and the higher Ba/La ratios may result from partial melting of an arc source which has experienced previous melting events but has continued to be contaminated by a component from the subducting slab. It may also indicate a change in the degree of partial melting of the underlying mantle, which corresponds to a different percentage of a slab derived component being incorporated into the overlying mantle.