ALBERT

All Library Books, journals and Electronic Records Telegrafenberg

feed icon rss

Your email was sent successfully. Check your inbox.

An error occurred while sending the email. Please try again.

Proceed reservation?

Export
  • 1
    Publication Date: 2016-03-07
    Description: We measure the fluid transport properties of microfractures and macrofractures in low-porosity polyphase sandstone, and investigate the controls of in-situ stress state on fluid flow conduits in fractured rock. For this study, the permeability and porosity of the Punchbowl Formation sandstone, a hydrothermally altered arkosic sandstone, were measured and mapped in stress-space under intact, microfractured, and macrofractured deformation states. In contrast to crystalline and other sedimentary rocks, the distributed intragranular and grain-boundary microfracturing that precedes macroscopic fracture formation has little effect on the fluid transport properties. The permeability and porosity of microfractured and intact sandstone depend strongly on mean stress, and are relatively insensitive to differential stress and proximity to the frictional sliding envelope. Porosity variations occur by elastic pore closure with intergranular sliding and pore collapse caused by microfracturing along weakly cemented grain contacts. The macroscopic fractured samples are best described as a two-component system consisting of (1) a tabular fracture with a 0.5 mm-thick gouge zone bounded by 1 mm thick zones of concentrated transgranular and intragranular microfractures, and (2) damaged sandstone. Using bulk porosity and permeability measurements and finite element methods models, we show that the tabular fracture is at least 2 orders of magnitude more permeable than the host rock at mean stresses up to 90 MPa. Further, we show that the tabular fracture zone dilates as the stress state approaches the friction envelope resulting in up to a 3 order of magnitude increase in fracture permeability. These results indicate that the enhanced and stress-sensitive permeability in fault damage zones and sedimentary basins composed of arkosic sandstones will be controlled by the distribution of macroscopic fractures rather than microfractures. This article is protected by copyright. All rights reserved.
    Print ISSN: 1468-8115
    Electronic ISSN: 1468-8123
    Topics: Geosciences
    Published by Wiley
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 2
    facet.materialart.
    Unknown
    In:  Nature, Taipei, Elsevier, vol. 437, no. 7055, pp. 133-136, pp. L15S13, (ISBN: 0-12-018847-3)
    Publication Date: 2005
    Description: Fracture energy is a form of latent heat required to create an earthquake rupture surface and is related to parameters governing rupture propagation and processes of slip weakening. Fracture energy has been estimated from seismological and experimental rock deformation data, yet its magnitude, mechanisms of rupture surface formation and processes leading to slip weakening are not well defined. Here we quantify structural observations of the Punchbowl fault, a large-displacement exhumed fault in the San Andreas fault system, and show that the energy required to create the fracture surface area in the fault is about 300 times greater than seismological estimates would predict for a single large earthquake. If fracture energy is attributed entirely to the production of fracture surfaces, then all of the fracture surface area in the Punchbowl fault could have been produced by earthquake displacements totalling 〈1 km. But this would only account for a small fraction of the total energy budget, and therefore additional processes probably contributed to slip weakening during earthquake rupture.
    Keywords: Fracture ; Fault zone ; SAF ; California ; USA ; Rock mechanics ; Seismology
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 3
    facet.materialart.
    Unknown
    In:  J. Geophys. Res., Taipei, Elsevier, vol. 105, no. B10, pp. 23,421-23,430, pp. L15S13, (ISBN: 0-12-018847-3)
    Publication Date: 2000
    Keywords: Stress ; Crustal deformation (cf. Earthquake precursor: deformation or strain) ; Friction ; Fault zone ; Modelling ; 3210 ; JGR ; Mathematical ; geophysics ; (new ; field) ; Modeling ; 7209 ; Seismology ; Earthquake ; dynamics ; and ; mechanics ; 8010 ; Structural ; geology ; (new ; field, ; replaces ; single ; entry ; 8165) ; fractures ; and ; faults ; 8164 ; Tectonophysics ; Stresses--crust ; and ; lithosphere
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 4
    Publication Date: 2011-06-28
    Description: SUMMARY We present results on the composition, structure and particle size distribution (PSD) of pulverized and damaged granitic rocks in a 42-m-deep core adjacent to the San Andreas Fault near Littlerock, CA. The cored section is composed of pulverized granites and granodiorites, and is cut by numerous mesoscopic secondary shears. The analysis employs XRD, XRF, thin sections and semi-automated particle size analyser methods, including a novel calibration method. The mean particle size for the majority of samples falls between 50 and 470 μm. The PSDs can be fitted by a power law, with D -values ranging between 2.5 and 3.1, as well as by a superposition of two Gaussians. Fracture surface energy calculations based on the observed particle distributions provide very low values, indicating that the part of the total earthquake energy budget expended for breaking or shattering rocks is small. Shear deformation is likely to dominate near secondary faults. The most pronounced fault-related alteration occurs along the secondary shears, and is a function of both composition and depth. The alteration to clay appears to be the result of fluid–rock interaction and brittle deformation under low temperature conditions, rather than of surface-related weathering. The particle size reduction noted in the core reflects multiple mechanisms of comminution. The zones of pulverization that lack significant weathering likely result from repeating episodes of dynamic dilation and contraction.
    Print ISSN: 0956-540X
    Electronic ISSN: 1365-246X
    Topics: Geosciences
    Published by Oxford University Press on behalf of The Deutsche Geophysikalische Gesellschaft (DGG) and the Royal Astronomical Society (RAS).
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 5
    Publication Date: 2011-08-23
    Description: The rotary shear of gouge demonstrates dramatic weakening at coseismic slip rates, but the inherent variation in shear-rate with radius of the rotary shear configuration prohibits determining friction constitutive properties from measures of whole-sample response. Here, representative results of rotary-shear high-speed experiments including both constant-velocity tests (0.1–1.3 m/s) and constant-acceleration tests (0–1.3 m/s, 0.05, and 0.1 m/s2) are analyzed using a thermal, mechanical and hydrologic finite element method (FEM) model to constrain friction constitutive properties and test hypotheses of dynamic weakening by thermal pressurization and flash heating. The observed frictional behavior of room-dry gouge can be explained by using a state-variable friction constitutive relation in which the friction coefficient is inversely proportional to temperature, and by employing a two-mechanism constitutive formulation in which the friction coefficient increases with temperature (temperature-strengthening) at low temperatures and decreases with temperature (temperature-weakening) at higher temperatures. Water-dampened gouge displays a transient weakening during the early stages of constant-acceleration tests. FEM analysis indicates the weakening could reflect thermal pressurization of pore water provided both the permeability of the gouge layer and the sealing capacity of the Teflon sleeve, used to contain the gouge during shear, contribute to restricting fluid flow. Microstructural observations indicate that the dynamic weakening coincides with slip localization and temperature increase by frictional heating, which are conditions that favor weakening by flash heating. At steady state, the relationship between slip-rate and coefficient of friction by the FEM model analysis is consistent with predictions of micromechanical models for weakening by flash heating.
    Print ISSN: 0148-0227
    Topics: Geosciences , Physics
    Published by Wiley on behalf of American Geophysical Union (AGU).
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 6
    Publication Date: 2002-01-01
    Print ISSN: 0149-1423
    Electronic ISSN: 1943-2674
    Topics: Geosciences
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 7
    Publication Date: 1988-01-01
    Print ISSN: 0149-1423
    Electronic ISSN: 1943-2674
    Topics: Geosciences
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 8
    Electronic Resource
    Electronic Resource
    [s.l.] : Nature Publishing Group
    Nature 437 (2005), S. 133-136 
    ISSN: 1476-4687
    Source: Nature Archives 1869 - 2009
    Topics: Biology , Chemistry and Pharmacology , Medicine , Natural Sciences in General , Physics
    Notes: [Auszug] Fracture energy is a form of latent heat required to create an earthquake rupture surface and is related to parameters governing rupture propagation and processes of slip weakening. Fracture energy has been estimated from seismological and experimental rock deformation data, yet its magnitude, ...
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 9
    Publication Date: 2020-04-13
    Print ISSN: 0723-2632
    Electronic ISSN: 1434-453X
    Topics: Architecture, Civil Engineering, Surveying , Geosciences
    Published by Springer
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 10
    Publication Date: 2018-10-01
    Description: Fault rocks can weaken dramatically with increasing slip rate, which results in localization of slip and earthquakes. Exhumed fault zones and fault rocks deformed at seismic rates in the laboratory both show that deformation can become extremely localized to zones less than or equal to millimeters thick. However, localization can occur during aseismic slip, so evidence of localization cannot necessarily be interpreted as having occurred coseismically. Dynamic weakening that occurs during earthquakes is the result of processes that are unique to seismic slip rates, and previous results from carbonates show that these processes produce unique microstructures. We evaluate whether coseismic deformation at low normal stress produces unique structures within the localized slip zones and adjacent gouge that develop in clay-rich gouge from the Central Deforming Zone of the San Andreas fault. We measured the thickness and orientations of localized slip zones and their internal lamina, particle orientations, and particle size distributions of gouge sheared from 0.35 to 1.3 m/s velocity, up to 25-m displacement, and 1-MPa normal stress, under water-wet and room-dry conditions. We find that the thicknesses of localized slip zones and their internal laminae are consistent with numerical formulations for thermal pressurization in wet gouge and both thermal decomposition and cataclastic deformation in dry gouge. Localized zones form coincident with a zone of fluidized gouge that accommodates at most 10% of the shear strain. We conclude that the combined occurrence of foliated localized shear zones with a zone of fluidized gouge may provide a record of seismicity in clay-rich gouges. ©2018. American Geophysical Union. All Rights Reserved.
    Print ISSN: 2169-9313
    Electronic ISSN: 2169-9356
    Topics: Geosciences , Physics
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
Close ⊗
This website uses cookies and the analysis tool Matomo. More information can be found here...