Electronic Resource
[S.l.]
:
American Institute of Physics (AIP)
Review of Scientific Instruments
64 (1993), S. 1999-2002
ISSN:
1089-7623
Source:
AIP Digital Archive
Topics:
Physics
,
Electrical Engineering, Measurement and Control Technology
Notes:
This paper presents the characteristics of an optical pressure transducer using fiber optics. The transducer consists of a cylindrical housing with a reflective mylar diaphragm attached at one end and fiber-optic bundle at the other. The fiber-optic bundle used is the bifurcated type, in which two bundles of randomly distributed fibers are joined at one end to form a Y-shaped geometry. The common end is attached to the end of the transducer housing, opposite to the diaphragm. At the branched ends, one bundle is connected to a dc light source, while the other bundle carries the light reflected from the diaphragm to a photodetector. By keeping the input light source at constant intensity, the amount of reflected light depends on the distortion of diaphragm due to pressure differential across the diaphragm surface. This pressure transducer can measure both the static pressure level and the fluctuating pressure. A simple "homemade'' diaphragm was used in this experiment, and a sensitivity of approximately 10 mV per mm Hg was obtained over a range of 20 mm Hg. The dynamic response was linear to about 2 kHz. Both the sensitivity and the frequency response can be much increased by improving the diaphragm performance.
Type of Medium:
Electronic Resource
URL:
http://dx.doi.org/10.1063/1.1143989
Permalink
|
Location |
Call Number |
Expected |
Availability |