ALBERT

All Library Books, journals and Electronic Records Telegrafenberg

feed icon rss

Your email was sent successfully. Check your inbox.

An error occurred while sending the email. Please try again.

Proceed reservation?

Export
  • 1
    Publication Date: 2017-04-04
    Description: Magnetotactic bacteria intracellularly biomineralize magnetite of an ideal grain size for recording palaeomagnetic signals. However, bacterial magnetite has only been reported in a few pre-Quaternary records because progressive burial into anoxic diagenetic environments causes its dissolution. Deep-sea carbonate sequences provide optimal environments for preserving bacterial magnetite due to low rates of organic carbon burial and expanded pore-water redox zonations. Such sequences often do not become anoxic for tens to hundreds of metres below the seafloor. Nevertheless, the biogeochemical factors that control magnetotactic bacterial populations in such settings are not well known. We document the preservation of bacterial magnetite, which dominates the palaeomagnetic signal throughout Eocene pelagic carbonates from the southern Kerguelen Plateau, Southern Ocean. We provide evidence that iron fertilization, associated with increased aeolian dust flux, resulted in surface water eutrophication in the late Eocene that controlled bacterial magnetite abundance via export of organic carbon to the seafloor. Increased flux of aeolian ironbearing phases also delivered iron to the seafloor, some of which became bioavailable through iron reduction. Our results suggest that magnetotactic bacterial populations in pelagic settings depend crucially on particulate iron and organic carbon delivery to the seafloor.
    Description: Published
    Description: 441-452
    Description: 1.8. Osservazioni di geofisica ambientale
    Description: 2.2. Laboratorio di paleomagnetismo
    Description: JCR Journal
    Description: restricted
    Keywords: Magnetotactic bacteria ; Magnetofossils ; Magnetite ; Productivity ; Iron ; Organic carbon ; 04. Solid Earth::04.05. Geomagnetism::04.05.06. Paleomagnetism ; 04. Solid Earth::04.05. Geomagnetism::04.05.07. Rock magnetism ; 04. Solid Earth::04.05. Geomagnetism::04.05.09. Environmental magnetism
    Repository Name: Istituto Nazionale di Geofisica e Vulcanologia (INGV)
    Type: article
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 2
    Electronic Resource
    Electronic Resource
    [S.l.] : American Institute of Physics (AIP)
    Journal of Applied Physics 89 (2001), S. 5739-5746 
    ISSN: 1089-7550
    Source: AIP Digital Archive
    Topics: Physics
    Notes: Pulsed laser deposition (PLD) has been used to fabricate polymer/carbon nanocomposite thin films for use in chemical sensors (chemiresistors). Ethylene vinyl acetate copolymer (EVA) films (undoped and 20% carbon by weight) were deposited using an ArF excimer laser (193 nm) at fluences between 150 and 300 mJ/cm2. The structure and morphology of the deposited films were characterized using Fourier transform infrared spectroscopy (FTIR), Raman scattering, and transmission and scanning electron microscopy (TEM). An analysis of the FTIR spectra indicates that a film deposited using an undoped EVA target is primarily polyethylene, suggesting that the acetate group is photochemically or photothermally removed from the starting material. Gas phase measurements of the laser-evaporated material using a quadrupole time of flight mass spectrometer confirm the production of the acetyl radical on the target surface. Analysis of TEM of films deposited using C-doped targets shows that the carbon black particles (initially 50 nm particles in 1 μm agglomerates) are broken down into particles that are ≤50 nm in the deposited film. Incorporation of carbon into the target reduces the degree of photochemical damage of the starting material, as shown in the FTIR spectra of the deposited film. The sensitivity and response time of chemiresistors fabricated from 6 μm thick composite films on top of gold electrodes were measured using toluene vapor (548 ppm). The chemiresistors exhibited a reversible and fast (〈1.3 s) response to the vapor. In comparison to data reported in the literature, chemiresistors fabricated from PLD films are significantly better than devices fabricated using a more conventional polymer film growth technique. © 2001 American Institute of Physics.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 3
    Electronic Resource
    Electronic Resource
    [S.l.] : American Institute of Physics (AIP)
    Journal of Applied Physics 86 (1999), S. 1759-1761 
    ISSN: 1089-7550
    Source: AIP Digital Archive
    Topics: Physics
    Notes: In this communication, we show the feasibility of the pulsed laser ablation technique to make very thin, uniform luminescent coatings on particulate systems. To deposit continuous particulate coatings, the laser-induced plume from the target comes in contact with an agitated bed of core particles (size 1 μm). The pressure and nature of the background gas (inert or active) controls the cluster size of the particles in the laser plume. Experiments were conducted for laser deposition of phosphor nanoparticles on SiO2 core particles by pulsed excimer laser (wavelength=248 nm and pulse duration=25 ns) irradiation of a yttria:Eu (Y2O3:Eu3+) sputtering target. © 1999 American Institute of Physics.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 4
    Electronic Resource
    Electronic Resource
    Woodbury, NY : American Institute of Physics (AIP)
    Applied Physics Letters 76 (2000), S. 1386-1388 
    ISSN: 1077-3118
    Source: AIP Digital Archive
    Topics: Physics
    Notes: A laser-based forward transfer direct writing technique was used to deposit phosphor powder screens for high-resolution display applications. With this technique, called matrix-assisted pulsed-laser evaporation direct write, dense oxide phosphor powders of Y2O3:Eu (red) and Zn2SiO4:Mn (green) were deposited on alumina and polymer substrates. All processing was performed in air at room temperature. Cathodoluminescent measurements showed that the luminous efficiency of the phosphor powders was not degraded by the deposition process. A 6×6 red and green matrix with pixel sizes of 100 μm (250 lines per inch) with a 100 μm spot size is demonstrated; however, with smaller spot sizes this technique is easily scalable to pixel sizes 〈10 μm (〉2500 lines per inch). © 2000 American Institute of Physics.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 5
    Electronic Resource
    Electronic Resource
    Woodbury, NY : American Institute of Physics (AIP)
    Applied Physics Letters 72 (1998), S. 3044-3046 
    ISSN: 1077-3118
    Source: AIP Digital Archive
    Topics: Physics
    Notes: Preamorphous damage in p-type Si implanted with MeV Si ions and annealed at elevated temperature is characterized using deep level transient spectroscopy (DLTS) and transmission electron microscopy (TEM). P-type Si was implanted with 4 MeV Si at doses from 1×1013 to 1×1014 cm−2 and annealed at 800 °C for 15 min. For doses below this critical dose, a sharp peak is observed in the DLTS spectrum, corresponding to the signature of point defects. Above the critical dose, a broad DLTS peak is obtained, indicating the presence of extended defects. This behavior is found to be consistent with TEM analyses where extended defects are only observed for doses above the critical dose. This suggests a critical dose at which point defects from implantation act as nucleating sites for extended defect formation. © 1998 American Institute of Physics.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 6
    Electronic Resource
    Electronic Resource
    Woodbury, NY : American Institute of Physics (AIP)
    Applied Physics Letters 74 (1999), S. 1141-1143 
    ISSN: 1077-3118
    Source: AIP Digital Archive
    Topics: Physics
    Notes: Evolution of extended defects during annealing of MeV ion-implanted p-type Si has been characterized using deep level transient spectroscopy and transmission electron microscopy. The p-type Si was implanted with Si, Ge, and Sn ions with varying energies and doses from 5×1012 to 1×1014 cm−2 then annealed at 800 °C for 15 min. For all implanted species, the critical dose for transformation from point to extended defects has been determined. The type of extended defects formed depends upon the mass of the implanted species even though the dose was adjusted to create a similar damage distribution for all implanted species. © 1999 American Institute of Physics.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 7
    Electronic Resource
    Electronic Resource
    Woodbury, NY : American Institute of Physics (AIP)
    Applied Physics Letters 72 (1998), S. 1838-1839 
    ISSN: 1077-3118
    Source: AIP Digital Archive
    Topics: Physics
    Notes: The degradation of cathodoluminescent (CL) brightness under prolonged electron-beam excitation of phosphors has been identified as one of the outstanding critical issues for flat-panel field-emission displays. In this letter, we have demonstrated that a TaSi2 coating on Y2O2S:Eu3+ phosphors substantially inhibits the cathodoluminescent degradation characteristics without reducing its efficiency. The coating was deposited by pulsed laser deposition of TaSi2 targets onto a fluidized bed containing phosphor particles. Cathodoluminescent degradation experiments conducted at 2 keV and at 150 μA/cm2, showed that the CL brightness decreased by more than 50% after a Coulomb load of 15 C/cm2 on the uncoated material. In contrast, the TaSi2-coated phosphor powders showed much less degradation, with CL brightness only decreasing by approximately 12% after electron irradiation with the same dose. © 1998 American Institute of Physics.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 8
    Electronic Resource
    Electronic Resource
    Oxford, UK : Blackwell Publishing Ltd
    Geophysical journal international 108 (1992), S. 0 
    ISSN: 1365-246X
    Source: Blackwell Publishing Journal Backfiles 1879-2005
    Topics: Geosciences
    Notes: A machine has been developed which provides for the study of both shear modulus dispersion and internal friction in geological materials through the observation of forced torsional oscillations of low frequency (10-1000 mHz) and strain amplitude (〈 10-6) under conditions of high pressure (to 300 MPa) and temperature (to 〉 1000°C). The eventual goal is an understanding of the dispersion and attenuation of seismic shear waves in the Earth's upper mantle. Measurements have been made on cylindrical specimens of an olivine-rich rock from Åheim, Norway which } contains, in addition to olivine, about 10 per cent pyroxene and 5-10 per cent of hydrous silicate phases dominantly clinochlore, serpentine and talc. In order to separate aspects of the mechanical behaviour associated with the olivine aggregate from those attributable to the hydrous phases and/or their dehydration products, the specimens were either previously fired under controlled oxygen fugacity at 1200 °C for 24 hours in order to effect complete dehydration within the olivine stability field, or simply oven-dried at 110 °C. Linearity of the mechanical behaviour has been demonstrated by the amplitude independence of the results for the strain amplitude range 10-8-10-6, and by the quantitative consistency between the observed modulus dispersion and that calculated from the measured internal friction through the Kramers-Krönig relations of linear theory. Both the pressure dependence at room temperature, and the temperature dependence at 300 MPa, of the shear modulus and internal friction have been investigated. Much of the variation of the shear modulus is attributed to changes of crack porosity associated with changes in pressure and temperature and with in situ dehydration. Temporal evolution of Q-1 towards a lower asymptotic value over periods of hours of exposure to given conditions of high pressure and temperature is tentatively attributed to the gradual diminution of enhanced anelastic relaxation associated with regions of decaying stress concentration at asperities on cracks and/or grain boundaries. At the highest pressures and temperatures achieved in this study, 300 MPa and 1000 °C, marked dispersion of the shear modulus, amounting to 5 per cent between periods of 3 and 100 s, and concomitant strong internal friction, varying with oscillation period To approximately as 0.011To1/6, are observed. The energy dissipation appears to be concentrated within, rather than at the boundaries between, the olivine grains. These results provide the clearest indication yet that solid-state, probably intragranular, anelastic relaxation in ultramafic rocks gives rise to losses comparable with those observed seismologically in the Earth's upper mantle, although the mechanistic basis for the observed anelasticity remains to be established.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 9
    Electronic Resource
    Electronic Resource
    Amsterdam : Elsevier
    Economic Modelling 10 (1993), S. 11-21 
    ISSN: 0264-9993
    Keywords: Econometric modelling ; International investment ; Supply
    Source: Elsevier Journal Backfiles on ScienceDirect 1907 - 2002
    Topics: Economics
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 10
    Electronic Resource
    Electronic Resource
    Springer
    Journal of geometry 5 (1974), S. 15-26 
    ISSN: 1420-8997
    Source: Springer Online Journal Archives 1860-2000
    Topics: Mathematics
    Notes: Abstract Degenerate cases of the problem of Apollonius, to construct a circle tangent to each of three given circles, are discussed and exhaustively classified for proper circles (finite and non-zero radius). Singular cases are considered, and an outline of the extension of the problem to higher dimensions given. Amusing alternative interpretations of the results are obtained.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
Close ⊗
This website uses cookies and the analysis tool Matomo. More information can be found here...