ALBERT

Description: Discriminating between a creeping and a locked status of active faults is of central relevance to characterize potential rupture scenarios of future earthquakes and the associated seismic hazard for nearby population centres. In this respect, highly similar earthquakes that repeatedly activate the same patch of an active fault portion are an important diagnostic tool to identify and possibly even quantify the amount of fault creep. Here, we present a refined hypocentre catalogue for the Marmara region in northwestern Turkey, where a magnitude M up to 7.4 earthquake is expected in the near future. Based on waveform cross-correlation for selected spatial seismicity clusters, we identify two magnitude M ∼ 2.8 repeater pairs. These repeaters were identified as being indicative of fault creep based on the selection criteria applied to the waveforms. They are located below the western part of the Marmara section of the North Anatolian Fault Zone and are the largest reported repeaters for the larger Marmara region. While the eastern portion of the Marmara seismic gap has been identified to be locked, only sparse information on the deformation status has been reported for its western part. Our findings indicate that the western Marmara section deforms aseismically to a substantial extent, which reduces the probability for this region to host a nucleation point for the pending Marmara earthquake. This is of relevance, since a nucleation of the Marmara event in the west and subsequent eastward rupture propagation towards the Istanbul metropolitan region would result in a substantially higher seismic hazard and resulting risk than if the earthquake would nucleate in the east and thus propagate westward away from the population centre Istanbul.

Description: Within the framework of the Intercontinental Scientific Drilling Programme (ICDP) ‘Drilling the Eger Rift’ project, five boreholes were drilled in the Vogtland (Germany) and West Bohemia (Czech Republic) regions. Three of them will be used to install high-frequency three-dimensional (3D) seismic arrays. The pilot 3D array is located 1.5 km south of Landwüst (Vogtland). The borehole, with a depth of 402 m, was equipped with eight geophones and a fibre optic cable behind the casing used for distributed acoustic sensing (DAS) measurements. The borehole is surrounded by a surface array consisting of 12 seismic stations with an aperture of 400 m. During drilling, a highly fractured zone was detected between 90 m and 165 m depth and interpreted as a possible fault zone. To characterize the fault zone, two vertical seismic profiling (VSP) experiments with drop weight sources at the surface were conducted. The aim of the VSP experiments was to estimate a local 3D seismic velocity tomography including the imaging of the steep fault zone. Our 3D tomography indicates P-wave velocities between 1500 m/s and 3000 m/s at shallow depths (0–20 m) and higher P-wave velocities of up to 5000 m/s at greater depths. In addition, the results suggest a NW–SE striking low-velocity zone (LVZ; characterized by = 1500–3000 m/s), which crosses the borehole at a depth of about 90–165 m. This LVZ is inferred to be a shallow non-tectonic, steep fault zone with a dip angle of about . The depth and width of the fault zone are supported by logging data as electrical conductivity, core recovery and changes in lithology. In this study, we present an example to test and verify 3D tomography and imaging approaches of shallow non-tectonic fault zones based on active seismic experiments using simple surface drop weights as sources and borehole chains as well as borehole DAS behind casing as sensors, complemented by seismic stand-alone surface arrays.