ISSN:
1551-2916
Source:
Blackwell Publishing Journal Backfiles 1879-2005
Topics:
Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics
,
Physics
Notes:
Blackglas™–Nextel™ 312 (BN) composites with and without filler materials have been processed and characterized. SiC as inactive filler, and Ti and TiB2 as active fillers, were incorporated into the Blackglas resin, and the resulting slurries were painted on Nextel fabrics. The painted fabrics were laminated at 150°C and then pyrolyzed at 1000°C under nitrogen to fabricate ceramic–ceramic composites. The pyrolyzed composites were infiltrated with the resin up to five times to minimize the porosity and microcracks formed upon pyrolysis. Dimensional changes, open porosity, and densities of the composites were monitored throughout the process. The flexural strengths of the unfilled and filled composites after 2, 3, 4, and 5 infiltration cycles were measured by four-point bending. It was found that the addition of filler materials eliminated the delamination problem at a low number of infiltration cycles; however, the strengths of the filled composites did not reach the level of the unfilled composite. Much higher moduli were obtained for the filled composites because of the higher modulus of the filler materials relative to Blackglas.
Type of Medium:
Electronic Resource
URL:
http://dx.doi.org/10.1111/j.1151-2916.2000.tb01663.x
Permalink