ALBERT

All Library Books, journals and Electronic Records Telegrafenberg

feed icon rss

Your email was sent successfully. Check your inbox.

An error occurred while sending the email. Please try again.

Proceed reservation?

Export
  • 1
    facet.materialart.
    Unknown
    In:  J. Geophys. Res., London, Geological Society, vol. 110, no. B7, pp. 309-310, pp. B07203, (ISBN 1-86239-117-3)
    Publication Date: 2005
    Keywords: Rheology ; Mineralogy ; Rock mechanics ; Creep observations and analysis ; JGR ; creep ; two-phase ; lower ; crust ; mylonites. ; 8159 ; Tectonophysics: ; Rheology: ; crust ; and ; lithosphere ; (8031) ; 8012 ; Structural ; Geology: ; High ; strain ; deformation ; zones ; 5120 ; Physical ; Properties ; of ; Rocks: ; Plasticity, ; diffusion, ; and ; creep ; 3902 ; Mineral ; Physics: ; Creep ; and ; deformation
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 2
    Publication Date: 2012-03-10
    Description: Experimental heating tests were performed on Volterra gypsum to study the micromechanical consequences of the dehydration reaction. The experimental conditions were drained at 5 MPa fluid pressure and confining pressures ranging from 15 to 55 MPa. One test was performed with a constantly applied differential stress of 30 MPa. The reaction is marked by (1) a porosity increase and homogeneous compaction, (2) a swarm of acoustic emissions, (3) a large decrease in P and S wave velocities, and (4) a decrease in VP/VS ratio. Wave velocity data are interpreted in terms of crack density and pore aspect ratio, which, modeling pores as spheroids, is estimated at around 0.05 (crack-like spheroid). Complementary tests performed in an environmental scanning electron microscope indicate that cracks first form inside the gypsum grains and are oriented preferentially along the crystal structure of gypsum. Most of the visible porosity appears at later stages when grains shrink and grain boundaries open. Extrapolation of our data to serpentinites in subduction zones suggest that the signature of dehydrating rocks in seismic tomography could be a low apparent Poisson's ratio, although this interpretation may be masked by anisotropy development due to preexisting crystal preferred orientation and/or deformation-induced cracking. The large compaction and the absence of strain localization in the deformation test suggests that dehydrating rocks maybe seen as soft inclusions and could thus induce ruptures in the surrounding, nonreacting rocks.
    Print ISSN: 0148-0227
    Topics: Geosciences , Physics
    Published by Wiley on behalf of American Geophysical Union (AGU).
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 3
    Publication Date: 2017-06-07
    Description: Deformation and failure mode of carbonate rocks depend on the confining pressure. In this study, the mechanical behaviour of a limestone with an initial porosity of 14.7 % is investigated at constant stress. At confining pressures below 55 MPa, dilatancy associated with micro-fracturing occurs during constant stress steps, ultimately leading to failure, similar to creep in other brittle media. At confining pressures higher than 55 MPa, depending on applied differential stress, inelastic compaction occurs, accommodated by crystal plasticity and characterized by constant ultrasonic wave velocities, or dilatancy resulting from nucleation and propagation of cracks due to local stress concentrations associated with dislocation pile-ups, ultimately causing failure. Strain rates during secondary creep preceding dilative brittle failure are sensitive to stress while rates during compactive creep exhibit an insensitivity to stress indicative of the operation of crystal plasticity, in agreement with elastic wave velocity evolution and microstructural observations.
    Print ISSN: 0148-0227
    Topics: Geosciences , Physics
    Published by Wiley on behalf of American Geophysical Union (AGU).
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 4
    Publication Date: 2013-01-05
    Description: [1]  There is a renewed interest in the study of the rheology of halite since salt cavities are considered for waste repositories or energy storage. This research benefits from the development of observation techniques at the micro-scale which allow precise characterizations of microstructures, deformation mechanisms and strain fields. These techniques are applied to uniaxial compression tests on synthetic halite done with a classical press and with a specific rig implemented in a scanning electron microscope. Digital images of the surface of the sample have been recorded at several loading stages. Surface markers allow the measure of displacements by means of Digital Image Correlation (DIC) techniques. Global and local strain fields are then computed using DIC and ad hoc data processing. Analysis of these results provides a measure of strain heterogeneity at various scales, an estimate of the size of the representative volume element and most importantly an identification of the deformation mechanisms, namely crystal slip plasticity (CSP) and grain boundary sliding (GBS) which are shown to be in a complex local interaction. Indeed, the applied macroscopic loading gives rise locally to complex stress states owing to relative crystallographic orientations, density and orientation of interfaces, local deformation history. We have quantitatively estimated the relative importance of CSP and GBS for different microstructures and evidenced their dependence on grain size. The two mechanisms of deformation and their link to the microstructure should thus be considered when modelling polycrystalline visco-plasticity.
    Print ISSN: 0148-0227
    Topics: Geosciences , Physics
    Published by Wiley on behalf of American Geophysical Union (AGU).
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 5
    Electronic Resource
    Electronic Resource
    Springer
    Physics and chemistry of minerals 26 (1998), S. 116-127 
    ISSN: 1432-2021
    Source: Springer Online Journal Archives 1860-2000
    Topics: Chemistry and Pharmacology , Geosciences , Physics
    Notes: Abstract  We have investigated 44Ca self-diffusion in natural diopside single crystals (containing ∼2 atomic % Fe) at temperatures up to 1320 °C (i.e. 30 °C below the nominal melting point). Oxygen fugacity was controlled by gaseous mixtures. Diffusion profiles ranging from ∼50 to 500 nm were analysed by Rutherford Back-Scattering Spectrometry (RBS). The present results are complementary to previous studies, and show that in both synthetic (Fe-poor) and natural (Fe-rich) diopside, there are two different diffusion regimes for Ca with a transition at ∼1230±15 °C. Below this temperature diffusion is characterised by an activation enthalpy of ∼284±10 kJ/mol, while at higher temperatures it increases up to ∼1006±75 kJ/mol. These regimes are proposed to be respectively extrinsic and intrinsic. For the intrinsic regime Ca self-diffusion may involve Ca-Frenkel point defects. These are pairs of a vacancy on a M2 site and a calcium cation on an interstitial (normally unoccupied) site. The concentration of such point defects depends only on temperature, and it is especially important at very high temperatures. The activation enthalpy for intrinsic diffusion may represent the half defect formation enthalpy plus the migration enthalpy for movement through interstitial sites. For the extrinsic regime we propose Ca self-diffusion to involve extrinsic interstitial point defects with concentration proportional to ( )–0.19±0.03. We suggest that for both regimes, Ca diffusion involves the well known M3 sites in the octahedral layers, as well as sites in the tetrahedral layers, that we call M4. These sites are especially convenient to explain the observed isotropic diffusion. Increasing concentration of Ca-Frenkel point defects may be related to the onset of premelting, which affects the thermodynamic properties of Fe-“free” diopside above 1250 °C. In the light of the present results, premelting is also expected to occur in natural Fe-bearing diopside and it could strongly influence its thermodynamic and transport properties. Subsequently, in deep upper mantle conditions (T≈1250 °C–1300 °C) where premelting could occur, diffusional cation exchanges with surrounding phases and diffusion controlled creep might be facilitated. Finally, our diffusion data support a previous suggestion that electrical conductivity may be electronic rather than ionic.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 6
    Electronic Resource
    Electronic Resource
    Springer
    Physics and chemistry of minerals 22 (1995), S. 437-442 
    ISSN: 1432-2021
    Source: Springer Online Journal Archives 1860-2000
    Topics: Chemistry and Pharmacology , Geosciences , Physics
    Notes: Abstract A study of Ca self-diffusion along the b axis in synthetic (iron free) diopside single crystal was performed at temperatures ranging from 1273 K to 1653 K. Diffusion profiles of 44Ca were measured using α-particles Rutherford Backscattering (α-RBS) micro analysis. We unambiguously find two distinct diffusional regimes, characterized by activation enthalpies H = 280 ± 26 kJ/mol and H = 951 ± 87 kJ/mol at temperatures lower and upper than 1515 K, respectively. This change of diffusion regime takes place near the onset of premelting as detected in calorimetric measurements and can be interpreted in terms of enhanced formation of Frenkel point defects with an activation enthalpy of formation of 1524 ± 266 kJ/mol (H f/2 = 762 kJ/mol), in accordance with our high-temperature diffusion data. If premelting of diopside is actually related to Ca-Frenkel point defect concentration, this concentration could reach up to few mole percents close to the melting temperature.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 7
    Publication Date: 2016-05-22
    Description: Inelastic deformation can either occur with dilatancy or compaction, implying differences in porosity changes, failure and petrophysical properties. In this study, the roles of water as a pore fluid, and of temperature, on the deformation and failure of a micritic limestone (white Tavel limestone, porosity 14.7 per cent) were investigated under triaxial stresses. For each sample, a hydrostatic load was applied up to the desired confining pressure (from 0 up to 85 MPa) at either room temperature or at 70 °C. Two pore fluid conditions were investigated at room temperature: dry and water saturated. The samples were deformed up to failure at a constant strain rate of ~10 –5 s –1 . The experiments were coupled with ultrasonic wave velocity surveys to monitor crack densities. The linear trend between the axial crack density and the relative volumetric strain beyond the onset of dilatancy suggests that cracks propagate at constant aspect ratio. The decrease of ultrasonic wave velocities beyond the onset of inelastic compaction in the semi-brittle regime indicates the ongoing interplay of shear-enhanced compaction and crack development. Water has a weakening effect on the onset of dilatancy in the brittle regime, but no measurable influence on the peak strength. Temperature lowers the confining pressure at which the brittle–semi-brittle transition is observed but does not change the stress states at the onset of inelastic compaction and at the post-yield onset of dilatancy.
    Keywords: Mineral Physics, Rheology, Heat Flow and Volcanology
    Print ISSN: 0956-540X
    Electronic ISSN: 1365-246X
    Topics: Geosciences
    Published by Oxford University Press on behalf of The Deutsche Geophysikalische Gesellschaft (DGG) and the Royal Astronomical Society (RAS).
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 8
    Publication Date: 2010-09-01
    Print ISSN: 1062-7391
    Electronic ISSN: 1573-8736
    Topics: Geosciences , Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics
    Published by Springer
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 9
    Publication Date: 2003-01-01
    Print ISSN: 0148-0227
    Electronic ISSN: 2156-2202
    Topics: Geosciences
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 10
    Publication Date: 1998-05-10
    Print ISSN: 0148-0227
    Electronic ISSN: 2156-2202
    Topics: Geosciences
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
Close ⊗
This website uses cookies and the analysis tool Matomo. More information can be found here...