ALBERT

Beschreibung: Percutaneous coronary intervention (PCI) is a common treatment method for patients with coronary artery disease (CAD), but its effect on synchronously measured heart rate variability (HRV) and pulse transit time variability (PTTV) have not been well established. This study aimed to verify whether PCI for CAD patients affects both HRV and PTTV parameters. Sixteen CAD patients were enrolled. Two five-minute ECG and finger photoplethysmography (PPG) signals were recorded, one within 24 h before PCI and another within 24 h after PCI. The changes of RR and pulse transit time (PTT) intervals due to the PCI procedure were first compared. Then, HRV and PTTV were evaluated by a standard short-term time-domain variability index of standard deviation of time series (SDTS) and our previously developed entropy-based index of fuzzy measure entropy (FuzzyMEn). To test the effect of different time series length on HRV and PTTV results, we segmented the RR and PTT time series using four time windows of 200, 100, 50 and 25 beats respectively. The PCI-induced changes in HRV and PTTV, as well as in RR and PTT intervals, are different. PCI procedure significantly decreased RR intervals (before PCI 973 ± 85 vs. after PCI 907 ± 100 ms, p 〈 0.05) while significantly increasing PTT intervals (207 ± 18 vs. 214 ± 19 ms, p 〈 0.01). For HRV, SDTS-only output significant lower values after PCI when time windows are 100 and 25 beats while presenting no significant decreases for other two time windows. By contrast, FuzzyMEn gave significant lower values after PCI for all four time windows (all p 〈 0.05). For PTTV, SDTS hardly changed after PCI at any time window (all p > 0.90) whereas FuzzyMEn still reported significant lower values (p 〈 0.05 for 25 beats time window and p 〈 0.01 for other three time windows). For both HRV and PTTV, with the increase of time window values, SDTS decreased while FuzzyMEn increased. This pilot study demonstrated that the RR interval decreased whereas the PTT interval increased after the PCI procedure and that there were significant reductions in both HRV and PTTV immediately after PCI using the FuzzyMEn method, indicating the changes in underlying mechanisms in cardiovascular system.

Beschreibung: Coronary artery disease (CAD) is the most common cause of death globally. To detect CAD noninvasively at an early stage before clinical symptoms occur is still nowadays challenging. Analysis of the variation of heartbeat interval (RRI) opens a new avenue for evaluating the functional change of cardiovascular system which is accepted to occur at the subclinical stage of CAD. In addition, systolic time interval (STI) and diastolic time interval (DTI) also show potential. There may be coupling in these electromechanical time series due to their physiological connection. However, to the best of our knowledge no publication has systematically investigated how can the coupling be measured and how it changes in CAD patients. In this study, we enrolled 39 CAD patients and 36 healthy subjects and for each subject the electrocardiogram (ECG) and photoplethysmography (PPG) signals were recorded simultaneously for 5 min. The RRI series, STI series, and DTI series were constructed, respectively. We used linear cross correlation (CC), coherence function (CF), as well as nonlinear mutual information (MI), cross conditional entropy (XCE), cross sample entropy (XSampEn), and cross fuzzy entropy (XFuzzyEn) to analyse the bivariate RRI-DTI coupling, RRI-STI coupling, and STI-DTI coupling, respectively. Our results suggest that the linear CC and CF generally have no significant difference between the two groups for all three types of bivariate coupling. The MI only shows weak change in RRI-DTI coupling. By comparison, the three entropy-based coupling measurements show significantly decreased coupling in CAD patients except XSampEn for RRI-DTI coupling (less significant) and XCE for STI-DTI and RRI-STI coupling (not significant). Additionally, the XFuzzyEn performs best as it was still significant if we further applied the Bonferroni correction in our statistical analysis. Our study indicates that the intrinsic electromechanical coupling is most probably nonlinear and can better be measured by nonlinear entropy-based measurements especially the XFuzzyEn. Besides, CAD patients are accompanied by a loss of electromechanical coupling. Our results suggest that cardiac electromechanical coupling may potentially serve as a noninvasive diagnostic tool for CAD.

Beschreibung: Hyperspectral remote sensing is used in precision agriculture to remotely and quickly acquire crop phenotype information. This paper describes the generation of a digital orthophoto map (DOM) and radiometric calibration for images taken by a miniaturized snapshot hyperspectral camera mounted on a lightweight unmanned aerial vehicle (UAV). The snapshot camera is a relatively new type of hyperspectral sensor that can acquire an image cube with one spectral and two spatial dimensions at one exposure. The images acquired by the hyperspectral snapshot camera need to be mosaicked together to produce a DOM and radiometrically calibrated before analysis. However, the spatial resolution of hyperspectral cubes is too low to mosaic the images together. Furthermore, there are no systematic radiometric calibration methods or procedures for snapshot hyperspectral images acquired from low-altitude carrier platforms. In this study, we obtained hyperspectral imagery using a snapshot hyperspectral sensor mounted on a UAV. We quantitatively evaluated the radiometric response linearity (RRL) and radiometric response variation (RRV) and proposed a method to correct the RRV effect. We then introduced a method to interpolate position and orientation system (POS) information and generate a DOM with low spatial resolution and a digital elevation model (DEM) using a 3D mesh model built from panchromatic images with high spatial resolution. The relative horizontal geometric precision of the DOM was validated by comparison with a DOM generated from a digital RGB camera. A surface crop model (CSM) was produced from the DEM, and crop height for 48 sampling plots was extracted and compared with the corresponding field-measured crop height to verify the relative precision of the DEM. Finally, we applied two absolute radiometric calibration methods to the generated DOM and verified their accuracy via comparison with spectra measured with an ASD Field Spec Pro spectrometer (Analytical Spectral Devices, Boulder, CO, USA). The DOM had high relative horizontal accuracy, and compared with the digital camera-derived DOM, spatial differences were below 0.05 m (RMSE = 0.035). The determination coefficient for a regression between DEM-derived and field-measured crop height was 0.680. The radiometric precision was 5% for bands between 500 and 945 nm, and the reflectance curve in the infrared spectral region did not decrease as in previous research. The pixel and data sizes for the DOM corresponding to a field area of approximately 85 m × 34 m were small (0.67 m and approximately 13.1 megabytes, respectively), which is convenient for data transmission, preprocessing and analysis. The proposed method for radiometric calibration and DOM generation from hyperspectral cubes can be used to yield hyperspectral imagery products for various applications, particularly precision agriculture.

Beschreibung: Correct estimation of above-ground biomass (AGB) is necessary for accurate crop growth monitoring and yield prediction. We estimated AGB based on images obtained with a snapshot hyperspectral sensor (UHD 185 firefly, Cubert GmbH, Ulm, Baden-Württemberg, Germany) mounted on an unmanned aerial vehicle (UAV). The UHD 185 images were used to calculate the crop height and hyperspectral reflectance of winter wheat canopies from hyperspectral and panchromatic images. We constructed several single-parameter models for AGB estimation based on spectral parameters, such as specific bands, spectral indices (e.g., Ratio Vegetation Index (RVI), NDVI, Greenness Index (GI) and Wide Dynamic Range VI (WDRVI)) and crop height and several models combined with spectral parameters and crop height. Comparison with experimental results indicated that incorporating crop height into the models improved the accuracy of AGB estimations (the average AGB is 6.45 t/ha). The estimation accuracy of single-parameter models was low (crop height only: R2 = 0.50, RMSE = 1.62 t/ha, MAE = 1.24 t/ha; R670 only: R2 = 0.54, RMSE = 1.55 t/ha, MAE = 1.23 t/ha; NDVI only: R2 = 0.37, RMSE = 1.81 t/ha, MAE = 1.47 t/ha; partial least squares regression R2 = 0.53, RMSE = 1.69, MAE = 1.20), but accuracy increased when crop height and spectral parameters were combined (partial least squares regression modeling: R2 = 0.78, RMSE = 1.08 t/ha, MAE = 0.83 t/ha; verification: R2 = 0.74, RMSE = 1.20 t/ha, MAE = 0.96 t/ha). Our results suggest that crop height determined from the new UAV-based snapshot hyperspectral sensor can improve AGB estimation and is advantageous for mapping applications. This new method can be used to guide agricultural management.

Beschreibung: Leaf area index (LAI) is an important indicator of plant growth and yield that can be monitored by remote sensing. Several models were constructed using datasets derived from SRS and STR sampling methods to determine the optimal model for soybean (multiple strains) LAI inversion for the whole crop growth period and a single growth period. Random forest (RF), artificial neural network (ANN), and support vector machine (SVM) regression models were compared with a partial least-squares regression (PLS) model. The RF model yielded the highest precision, accuracy, and stability with V-R2, SDR2, V-RMSE, and SDRMSE values of 0.741, 0.031, 0.106, and 0.005, respectively, over the whole growth period based on STR sampling. The ANN model had the highest precision, accuracy, and stability (0.452, 0.132, 0.086, and 0.009, respectively) over a single growth phase based on STR sampling. The precision, accuracy, and stability of the RF, ANN, and SVM models were improved by inclusion of STR sampling. The RF model is suitable for estimating LAI when sample plots and variation are relatively large (i.e., the whole growth period or more than one growth period). The ANN model is more appropriate for estimating LAI when sample plots and variation are relatively low (i.e., a single growth period).