ALBERT

Description: Wind-tunnel tests have been made to determine the location of the boundary-layer transition on three hemispheres having surface roughness (absolute) values of 50, 580, and 2760 microinches. After the initial test run of the smoothest (50 microinch) hemisphere, holes ranging in depth from 1500 to 2500 microinches were noticed in the meridian where transition was observed. The holes were believed to be caused by particles in the air stream. Shadowgraph pictures were obtained of all hemispheres and surface temperature measurements were made on one hemisphere (580 microinches). Tests at high Reynolds numbers (6.4 to 7.5 x 10(exp 6) and a Mach number of 2.48 did not indicate any transition on the 50-microinch surface hemisphere before the holes appeared. However, after the holes were noticed, transition locations as low as 50 deg(measured from the stagnation point) were observed at similar Reynolds numbers and Mach numbers. It is felt the transition resulted from the holes. Similar transition locations of approximately 500 were also observed in the tests of hemispheres with surface roughness values of 580 and 2760 microinches at high Reynolds numbers (6.4 x 10(exp 6) to 7.5 x 10(exp 6)) and at a Mach number of 2.48. The results at a Mach number of 2.48 indicate that an absolute surface roughness value of 50 microinches was not critical in causing boundary-layer tran sition at Reynolds numbers of 6.4 to 7.5 x 10(exp 6) whereas roughness values of 580 and 2760 microinches were greater than critical. Transition Reynolds numbers based on momentum thickness, R(sub phi T) varied over a range of approximately 480 to 300 for transition locations, alpha, on the hemisphere from 880 to 410 (measured from the stagnation point). A maximum value of R(phi) of 660 (based on alpha = 90 deg) was obtained with the 50-microinch surface hemisphere at a Mach number of 2.48.