ALBERT

Description: Halocarbons from oceanic sources contribute to halogens in the troposphere, and can be transported into the stratosphere where they take part in ozone depletion. This paper presents distribution and sources in the equatorial Atlantic from June and July 2011 of the four compounds bromoform (CHBr3), dibromomethane (CH2Br2), methyl iodide (CH3I) and diiodomethane (CH2I2). Enhanced biological production during the Atlantic Cold Tongue (ACT) season, indicated by phytoplankton pigment concentrations, led to elevated concentrations of CHBr3 of up to 44.7 and up to 9.2 pmol/L for CH2Br2 in surface water, which is comparable to other tropical upwelling systems. While both compounds correlated very well with each other in the surface water, CH2Br2 was often more elevated in greater depth than CHBr3, which showed maxima in the vicinity of the deep chlorophyll maximum. The deeper maximum of CH2Br2 indicates an additional source in comparison to CHBr3 or a slower degradation of CH2Br2. Concentrations of CH3I of up to 12.8 pmol/L in the surface water were measured. In contrary to expectations of a predominantly photochemical source in the tropical ocean, its distribution was mostly in agreement with biological parameters, indicating a biological source. CH2I2 was very low in the near surface water with maximum concentrations of only 3.7 pmol/L. CH2I2 showed distinct maxima in deeper waters similar to CH2Br2. For the first time, diapycnal fluxes of the four halocarbons from the upper thermocline into and out of the mixed layer were determined. These fluxes were low in comparison to the halocarbon sea-to-air fluxes. This indicates that despite the observed maximum concentrations at depth, production in the surface mixed layer is the main oceanic source for all four compounds and one of the main driving factors of their emissions into the atmosphere in the ACT-region. The calculated production rates of the compounds in the mixed layer are 34 ± 65 pmol/m**3/h for CHBr3, 10 ± 12 pmol/m**3/h for CH2Br2, 21 ± 24 pmol/m**3/h for CH3I and 384 ± 318 pmol/m**3/h for CH2I2 determined from 13 depth profiles.

Description: Oceanic upwelling velocities are too small to be measured directly. Deviations of the He-3/He-4 ratio in the mixed layer from solubility equilibrium provide an indirect means to infer vertical velocities at the base of the mixed layer. This method is applied to the Mauritanian upwelling region for data from three cruises in summer 2006 and winter 2007 and 2008. Diapycnal mixing coefficients are estimated from microstructure measurements, reaching from 10**-3 m**2/s over the shelf break to 10**-5 m**2/s in the open ocean. The resulting upwelling velocities in the onshore region (upto 50 km from the 50 m isobath) are of the order of 2 x 10**-5 m/s}, in agreement with Ekman theory. Further offshore, in some cases the vertical velocities inferred from the helium isotope disequilibrium exceed the values derived from the wind stress curl by one order of magnitude. The Mauritanian coastal area as part of the Canary Current upwelling system belongs to the most productive ocean regions in the world. Nutrient fluxes into the mixed layer (both advective and diffusive) are equivalent to a net community production of about 1 g C/d, and associated heat fluxes vary between 183 +/- 62 W/m**2 in summer and 97 +/- 25 W/m**2 in winter. Regarding the flux into the mixed layer, the contribution of diffusion and advection are of similar magnitude for both heat and nutrients. The upwelling, however, provides the supply of cold and nutrient rich water from below. The large offshore vertical velocities inferred from the helium method are associated with nutrient fluxes of the same order as for the onshore region, and may be responsible for observed patches of high productivity in that area. The offshore heat fluxes due to upwelling and diapycnal mixing are smaller than 70 W/m**2 for all cruises.

Description: Upper-ocean velocities along the cruise track of Maria S. Merian cruise MSM106 were continuously collected by a vessel-mounted Teledyne RD Instruments 75 kHz Ocean Surveyor ADCP. The transducer was located at 6.0 m below the water line. The instrument was operated in three different configurations: 1) broadband mode with 4 m bins and a blanking distance of 2.0 m, with a total of 128 bins, 2) broadband mode with 8 m bins and a blanking distance of 4.0 m, with a total of 100 bins, 3) narrowband mode with 8 m bins and a blanking distance of 4.0 m, with a total of 100 bins. The ship's velocity was calculated from position fixes obtained by the Global Positioning System (GPS). Heading, pitch and roll data from the ship's gyro platforms and the navigation data were used by the data acquisition software VmDas internally to convert ADCP velocities into earth coordinates. Accuracy of the ADCP velocities mainly depends on the quality of the position fixes and the ship's heading data. Further errors stem from a misalignment of the transducer with the ship's centerline. Data post-processing included water track calibration of the misalignment angle (configuration 1: 0.65° +/- 0.5915°, configuration 2: 0.78° +/- 0.5198°, configuration 3: 0.67° +/- 0.6996°) and scale factor (configuration1: 1.0075 +/- 0.0117, configuration 2: 1.0075 +/- 0.0087, configuration 3: 1.0007 +/- 0.0157) of the Ocean Surveyor signal. The average interval was set to 60 s.