ALBERT

Description: We determine the deep structure of the eastern Algerian basin and its southern margin in the Annaba region (easternmost Algeria), to better constrain the plate kinematic reconstruction in this region. This study is based on new geophysical data collected during the SPIRAL cruise in 2009, which included a wide-angle, 240-km-long, onshore–offshore seismic profile, multichannel seismic reflection lines and gravity and magnetic data, complemented by the available geophysical data for the study area. The analysis and modelling of the wide-angle seismic data including refracted and reflected arrival travel times, and integrated with the multichannel seismic reflection lines, reveal the detailed structure of an ocean-to-continent transition. In the deep basin, there is an ~5.5-km-thick oceanic crust that is composed of two layers. The upper layer of the crust is defined by a high velocity gradient and P -wave velocities between 4.8 and 6.0 km s –1 , from the top to the bottom. The lower crust is defined by a lower velocity gradient and P -wave velocity between 6.0 and 7.1 km s –1 . The Poisson ratio in the lower crust deduced from S -wave modelling is 0.28, which indicates that the lower crust is composed mainly of gabbros. Below the continental edge, a typical continental crust with P -wave velocities between 5.2 and 7.0 km s –1 , from the top to the bottom, shows a gradual seaward thinning of ~15 km over an ~35-km distance. This thinning is regularly distributed between the upper and lower crusts, and it characterizes a rifted margin, which has resulted from backarc extension at the rear of the Kabylian block, here represented by the Edough Massif at the shoreline. Above the continental basement, an ~2-km-thick, pre-Messinian sediment layer with a complex internal structure is interpreted as allochthonous nappes of flysch backthrusted on the margin during the collision of Kabylia with the African margin. The crustal structure, moreover, provides evidence for Miocene emplacement of magmatic intrusions in both the deep basin and the continental margin. Based on the crustal structure, we propose that the eastern Algerian basin opened during the southeastward migration of the European forearc before the collision, along a NW–SE elongated spreading centre that ran perpendicular to the subduction trend. Such an atypical geometry is explained by the diverging directions of the subduction rollback during the backarc opening: eastward for the Corsica–Sardinia block, and southward for the Kabylian blocks. This geometry of the forearc can be interpreted as the surface expression of a slab tear at depth, which is responsible for atypical magmatism in the overlying backarc oceanic basin.

Description: Ground subsidence in the southeastern border of the Granada Basin (SE Spain) has been studied using remote sensing techniques. Over the last decades, the region has experienced a huge urban expansion which has caused a substantial increase in water supply requirements. Water needs are exclusively met by groundwater by means of numerous pumping wells which exploit a confined detrital aquifer of alluvial fan deposits with a heterogeneous facies distribution. A general piezometric level decline (up to 50 m) has been recorded in the aquifer during the past 30 years which has induced the generation of a subsiding area with oval shape oriented WSW-ENE just where the new urban areas and pumping wells are located. Subsidence has been monitored by exploiting Synthetic Aperture Radar (SAR) images from ENVISAT (2003-2009) and Cosmo-SkyMed (2011-2014). A new approach which combines A-DInSAR and Small-area PSI analysis has been applied obtaining a good accuracy regarding temporal and spatial dimension of the subsidence. ENVISAT data (2003-2009) reveal subsidence rates up to 10-15 mm/yr, and Cosmo-SkyMed (2011-2014) values slightly lower; up to 10 mm/yr. Temporal variations in the subsidence velocity are in accordance to the rainfall pattern and piezometric fluctuations in the aquifer. The sector with highest rates of subsidence does not correspond to the area with more intense groundwater exploitation but to the area with greater presence of clays in the confining layer of the aquifer. There is a clear lithological control in the spatial distribution of the ground subsidence. This work integrates detailed geological and hydrogeological data with differential SAR interferometry monitoring with the aim to better understand subsidence processes in detrital aquifers with small-scale heterogeneity. This article is protected by copyright. All rights reserved.

Description: [1]  In 2005, an on-shore, off-shore 3D refraction and wide-angle reflection seismic experiment was conducted along the convergent margin at the border between Colombia and Ecuador, over the rupture zone of the 1958, Mw 7.6 subduction earthquake. A well-defined Vp velocity model of the plate boundary and upper and lower plates was constructed, down to 25 km depth, using first arrival traveltimes inversion. The model reveals a several kilometers thick, low-velocity zone in the upper plate, located immediately above the interplate contact. This low-velocity zone might be related to alteration and fracturing of the mafic and ultramafic rocks, which composed the upper plate in this area by fluids released by the lower plate with possible contributions from sediment underplating. Near the toe of the margin, the model shows a low-velocity gradient in the outer wedge, which is interpreted as highly faulted and fractured rocks. This low-velocity/low-gradient region appears to limit the oceanward extension of the rupture zones of the 1958 and 1979 earthquakes, possibly because coseismic deformation and uplift of the outer margin wedge dissipates most of the seismic energy.

Description: We present an integrated approach of the seismic structure and activity along the offshore SW Hellenic subduction from combined observations of marine and land seismic stations. Our imaging of the slab top topography from teleseismic receiver function analysis at Ocean Bottom Seismometers supports a trenchward continuation of the along-dip slab faults beneath the Peloponnesus. We further show that their morpho-structural control accounts for the backstepping of the thrust contact of the Mediterranean Ridge accretionary wedge over the upper plate. Local seismic activity offshore SW Peloponnesus constrained by OBS observations reveals a correlation with specific features of the forearc: the Matapan Troughs. We study the Mw 6.8 14.02.2008 interplate earthquake offshore SW Peloponnesus and show that its nucleation, rupture zone and aftershocks sequence are confined to one slab panel between two adjacent along-dip faults and are thus controlled by the offshore slab top segmentation, but also the upper plate sea-bottom morphology.

Description: Quaternary volcanism in the Central Cordillera of Costa Rica has created an orographic barrier that concentrates rainfall on its northern side. This humid climate produces weathered bedrock prone to landsliding. Ash fall from explosive eruptions kills the vegetation cover and intensifies erosion processes. These eruptions, hydrothermal activity and associated earthquakes destabilize the slopes of river valleys, and even the volcanic edifices, producing landslides and large debris avalanches. All these processes mobilize an extra sediment input that is deposited in the piedmont lowlands forming the Santa Clara megafan. The megafans described in the literature mainly grow according to climatic fluctuations; however, sedimentation in the Santa Clara megafan is also controlled by endogenic processes with longer recurrence periods. Analysis of this megafan provides new insight into the origin and evolution of these landforms. In volcanic regions, active volcanism should be considered when investigating the formation of some megafans. This article is protected by copyright. All rights reserved.

Description: For the first time, a deep seismic data set acquired in the frame of the Algerian–French SPIRAL program provides new insights regarding the origin of the westernmost Algerian margin and basin. We performed a tomographic inversion of traveltimes along a 100-km-long wide-angle seismic profile shot over 40 ocean bottom seismometers offshore Mostaganem (Northwestern Algeria). The resulting velocity model and multichannel seismic reflection profiles show a thin (3–4 km thick) oceanic crust. The narrow ocean–continent transition (less than 10 km wide) is bounded by vertical faults and surmounted by a narrow almost continuous basin filled with Miocene to Quaternary sediments. This fault system, as well as the faults organized in a negative-flower structure on the continent side, marks a major strike-slip fault system. The extremely sharp variation of the Moho depth (up to 45 ± 3°) beneath the continental border underscores the absence of continental extension in this area. All these features support the hypothesis that this part of the margin from Oran to Tenes, trending N65–N70°E, is a fossil subduction-transform edge propagator fault, vestige of the propagation of the edge of the Gibraltar subduction zone during the westward migration of the Alborán domain.

Description: Downscaling techniques offer a solution to the lack of high-resolution satellite Thermal InfraRed (TIR) data and can bridge the gap until operational TIR missions accomplishing spatio-temporal requirements are available. These techniques are generally based on the Visible Near InfraRed (VNIR)-TIR variable relations at a coarse spatial resolution, and the assumption that the relationship between spectral bands is independent of the spatial resolution. In this work, we adopted a previous downscaling method and introduced some adjustments to the original formulation to improve the model performance. Maps of Land Surface Temperature (LST) with 10-m spatial resolution were obtained as output from the combination of MODIS/Sentinel-2 images. An experiment was conducted in an agricultural area located in the Barrax test site, Spain (39°03′35″ N, 2°06′ W), for the summer of 2018. Ground measurements of LST transects collocated with the MODIS overpasses were used for a robust local validation of the downscaling approach. Data from 6 different dates were available, covering a variety of croplands and surface conditions, with LST values ranging 300–325 K. Differences within ±4.0 K were observed between measured and modeled temperatures, with an average estimation error of ±2.2 K and a systematic deviation of 0.2 K for the full ground dataset. A further cross-validation of the disaggregated 10-m LST products was conducted using an additional set of Landsat-7/ETM+ images. A similar uncertainty of ±2.0 K was obtained as an average. These results are encouraging for the adaptation of this methodology to the tandem Sentinel-3/Sentinel-2, and are promising since the 10-m pixel size, together with the 3–5 days revisit frequency of Sentinel-2 satellites can fulfill the LST input requirements of the surface energy balance methods for a variety of hydrological, climatological or agricultural applications. However, certain limitations to capture the variability of extreme LST, or in recently sprinkler irrigated fields, claim the necessity to explore the implementation of soil moisture or vegetation indices sensitive to soil water content as inputs in the downscaling approach. The ground LST dataset introduced in this paper will be of great value for further refinements and assessments.

Description: Some landslides around the world that have low-angle failure planes show exceptionally poor mechanical properties. In some cases, an extraordinarily pure clay layer has been detected on the rupture surface. In this work, a complex landslide, the so-called Diezma landslide, is investigated in a low- to moderate-relief region of Southeast Spain. In this landslide, movement was concentrated on several surfaces that developed on a centimeter-thick layer of smectite (montmorillonite-beidellite) clay-rich level. Since these clayey levels have a very low permeability, high plasticity, and low friction angle, they control the stability of the entire slide mass. Specifically, the triggering factor of this landslide seems to be linked to the infiltration of water from a karstic aquifer located in the head area. The circulation of water through old failure planes could have promoted the active hydrolysis of marly soils to produce new smectite clay minerals. Here, by using geophysical, mineralogical, and geochemical modelling methods, we reveal that the formation and dissolution of carbonates, sulfates, and clay minerals in the Diezma landslide could explain the elevated concentrations of highly plastic secondary clays in its slip surface. This study may help in the understanding of landslides that show secondary clay layers coinciding to their low-angle failure planes.

Description: The usage of recycled polymers for industrial purposes arises as one of the most promising methods of reducing environmental impact and costs associated with scrapping parts. This paper presents a systematic study of the dimensional stability of a raw and 100% recycled polypropylene subjected to realistic environmental conditions occurring along its working life. The component studied is an internal part of an induction hob assembly. Industrial samples manufactured with both materials, in the same mold, and in the same injection machine, are subjected to ejection conditions, storage conditions (50 °C), and extreme performance conditions (80 °C). Induced dimensional changes are registered and analyzed using a coordinate measuring machine, and a tactile sensing probe. To verify the process capability of the samples manufacturing, Cp and Cpk values are calculated to evaluate the suitability of the recycled material as an alternative. Results conclude that, although the use of recycled material implies slight differences in terms of dimensional stability due to the changes induced in the polymer structure, these differences are not significant enough to affect the injection process capability. Therefore, recycling arises as one effective method to reduce both overruns associated with the consumption of raw polypropylene material and its environmental impact.