ALBERT

Description: Unbalanced voltage will inevitably cause power and DC voltage fluctuations in a three-phase PV system. The deterioration of power quality will do great harm to the PV panels and the loads, so it is necessary to suppress the power fluctuations. This paper further explores the coefficients control strategy of PV converters under unbalanced voltage conditions, aiming to suppress power fluctuations by controlling the injection of some specific orders of current harmonics into the grid. In order to achieve this, the current reference of the PV inverter has been changed by bringing in two control coefficients, and the expression of each order of the current harmonics has been deduced. Based on the standards of PV systems, the regions from which the coefficients can be selected are determined. Then, by tuning these coefficients in the feasible regions, the output parameters (power fluctuation, current THD and odd harmonics) can be controlled precisely. The model of this method is built and simulated in PSCAD/EMTDC, and as a result, it is shown that the power fluctuations can be restricted according to different power quality requirements.

Description: Sensors, Vol. 17, Pages 2306: Mechanical and Electrical Noise in Sense Channel of MEMS Vibratory Gyroscopes Sensors doi: 10.3390/s17102306 Authors: Xukai Ding Jia Jia Yang Gao Hongsheng Li This paper presents a theoretical analysis of mechanical and electrical noise in the sense channel of micro-electromechanical systems (MEMS) vibratory gyroscopes. Closed-form expressions for the power spectral density (PSD) of the noise equivalent rate (NER) of gyroscopes in the open-loop and the force-rebalance operations are derived by using an averaged PSD model and an equivalent transfer function. The obtained expressions are verified through numerical simulations, demonstrating close agreements between the analytic and the numerical models. Based on the derived expressions for the PSD of the NER, the impacts of the modal frequency split, quality factor, and the gain of the feedback forcer, as well as the gain of the signal conditioning circuit, on the gyroscope noise characteristics are theoretically analyzed. In addition, the angle random walk (ARW) and the standard deviation of the NER are also discussed through the PSD models. Finally, the effects of the loop closing, the mode matching, and the gain of the feedback forcer on the PSD of the NER were verified via a MEMS vibratory gyroscope with a tunable modal frequency split.

Description: IJERPH, Vol. 14, Pages 1509: Pollution Emissions, Environmental Policy, and Marginal Abatement Costs International Journal of Environmental Research and Public Health doi: 10.3390/ijerph14121509 Authors: Ling-Yun He Jia-Jia Ou Pollution emissions impose serious social negative externalities, especially in terms of public health. To reduce pollution emissions cost-effectively, the marginal abatement costs (MACs) of pollution emissions must be determined. Since the industrial sectors are the essential pillars of China’s economic growth, as well as leading energy consumers and sulfur dioxide (SO2) emitters, estimating MACs of SO2 emissions at the industrial level can provide valuable information for all abatement efforts. This paper tries to address the critical and essential issue in pollution abatement: How do we determine the MACs of pollution emissions in China? This paper first quantifies the SO2 emission contribution of different industrial sectors in the Chinese economy by an Input-Output method and then estimates MACs of SO2 for industrial sectors at the national level, provincial level, and sectoral level by the shadow price theory. Our results show that six sectors (e.g., the Mining and Washing of Coal sector) should be covered in the Chinese pollution emission trading system. We have also found that the lowest SO2 shadow price is 2000 Yuan/ton at the national level, and that shadow prices should be set differently at the provincial level. Our empirical study has several important policy implications, e.g., the estimated MACs may be used as a pricing benchmark through emission allowance allocation. In this paper, the MACs of industrial sectors are calculated from the national, provincial and sectoral levels; therefore, we provide an efficient framework to track the complex relationship between sectors and provinces.

Description: Sensors, Vol. 17, Pages 2621: Wearable Wide-Range Strain Sensors Based on Ionic Liquids and Monitoring of Human Activities Sensors doi: 10.3390/s17112621 Authors: Shao-Hui Zhang Feng-Xia Wang Jia-Jia Li Hong-Dan Peng Jing-Hui Yan Ge-Bo Pan Wearable sensors for detection of human activities have encouraged the development of highly elastic sensors. In particular, to capture subtle and large-scale body motion, stretchable and wide-range strain sensors are highly desired, but still a challenge. Herein, a highly stretchable and transparent stain sensor based on ionic liquids and elastic polymer has been developed. The as-obtained sensor exhibits impressive stretchability with wide-range strain (from 0.1% to 400%), good bending properties and high sensitivity, whose gauge factor can reach 7.9. Importantly, the sensors show excellent biological compatibility and succeed in monitoring the diverse human activities ranging from the complex large-scale multidimensional motions to subtle signals, including wrist, finger and elbow joint bending, finger touch, breath, speech, swallow behavior and pulse wave.

Description: Sensors, Vol. 18, Pages 1011: Diaphragm-Free Fiber-Optic Fabry-Perot Interferometric Gas Pressure Sensor for High Temperature Application Sensors doi: 10.3390/s18041011 Authors: Hao Liang Pinggang Jia Jia Liu Guocheng Fang Zhe Li Yingping Hong Ting Liang Jijun Xiong A diaphragm-free fiber-optic Fabry-Perot (FP) interferometric gas pressure sensor is designed and experimentally verified in this paper. The FP cavity was fabricated by inserting a well-cut fiber Bragg grating (FBG) and hollow silica tube (HST) from both sides into a silica casing. The FP cavity length between the ends of the SMF and HST changes with the gas density. Using temperature decoupling method to improve the accuracy of the pressure sensor in high temperature environments. An experimental system for measuring the pressure under different temperatures was established to verify the performance of the sensor. The pressure sensitivity of the FP gas pressure sensor is 4.28 nm/MPa with a high linear pressure response over the range of 0.1–0.7 MPa, and the temperature sensitivity is 14.8 pm/°C under the range of 20–800 °C. The sensor has less than 1.5% non-linearity at different temperatures by using temperature decoupling method. The simple fabrication and low-cost will help sensor to maintain the excellent features required by pressure measurement in high temperature applications.

Description: Real-time monitoring of chemical reactions is still challenging as well as important to study reaction mechanisms and reaction kinetics. Herein, we demonstrated the real-time monitoring of o-phenylenediamine (OPD) oxidation on the surface of gold nanoparticles by surface-enhanced Raman spectroscopy (SERS). The oxidation mechanism and the reaction kinetics were investigated on the basis of the SERS spectrum variation and the related density functionalized theory calculation. It was shown that the oxidation of OPD in the presence of copper ions was a two-step process of the deprotonation of the amino group on the aromatic rings and the rearrangement of the electron cloud to a π-conjugated system, which may open a new door to comprehensively understand the reaction process.

Description: Ischemic heart disease (IHD) is a leading cause of death worldwide. Urban public health and medical management in Shenzhen, an international city in the developing country of China, is challenged by an increasing burden of IHD. This study analyzed the spatio-temporal variation of IHD hospital admissions from 2003 to 2012 utilizing spatial statistics, spatial analysis, and space-time scan statistics. The spatial statistics and spatial analysis measured the incidence rate (hospital admissions per 1,000 residents) and the standardized rate (the observed cases standardized by the expected cases) of IHD at the district level to determine the spatio-temporal distribution and identify patterns of change. The space-time scan statistics was used to identify spatio-temporal clusters of IHD hospital admissions at the district level. The other objective of this study was to forecast the IHD hospital admissions over the next three years (2013–2015) to predict the IHD incidence rates and the varying burdens of IHD-related medical services among the districts in Shenzhen. The results show that the highest hospital admissions, incidence rates, and standardized rates of IHD are in Futian. From 2003 to 2012, the IHD hospital admissions exhibited similar mean centers and directional distributions, with a slight increase in admissions toward the north in accordance with the movement of the total population. The incidence rates of IHD exhibited a gradual increase from 2003 to 2012 for all districts in Shenzhen, which may be the result of the rapid development of the economy and the increasing traffic pollution. In addition, some neighboring areas exhibited similar temporal change patterns, which were also detected by the spatio-temporal cluster analysis. Futian and Dapeng would have the highest and the lowest hospital admissions, respectively, although these districts have the highest incidence rates among all of the districts from 2013 to 2015 based on the prediction using the GM (1,1). In addition, the combined analysis of the prediction of IHD hospital admissions and the general hospital distributions shows that Pingshan and Longgang might experience the most serious burden of IHD hospital services in the near future, although Futian would still have the greatest number and the highest incidence rate of hospital admissions for IHD.

Description: In China, awareness about hypertension, the treatment rate and the control rate are low compared to developed countries, even though China’s aging population has grown, especially in those areas with a high degree of urbanization. However, limited epidemiological studies have attempted to describe the spatial variation of the geo-referenced data on hypertension disease over an urban area of China. In this study, we applied hierarchical Bayesian models to explore the spatial heterogeneity of the relative risk for hypertension admissions throughout Shenzhen in 2011. The final model specification includes an intercept and spatial components (structured and unstructured). Although the road density could be used as a covariate in modeling, it is an indirect factor on the relative risk. In addition, spatial scan statistics and spatial analysis were utilized to identify the spatial pattern and to map the clusters. The results showed that the relative risk for hospital admission for hypertension has high-value clusters in the south and southeastern Shenzhen. This study aimed to identify some specific regions with high relative risk, and this information is useful for the health administrators. Further research should address more-detailed data collection and an explanation of the spatial patterns.